- 您現在的位置：買賣IC網 > PDF目錄363232 > NCP699SN50T1G (ON SEMICONDUCTOR) 150 mA CMOS Low Iq LDO with Enable in TSOP−5 PDF資料下載
參數資料
| 型號： | NCP699SN50T1G |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | 150 mA CMOS Low Iq LDO with Enable in TSOP−5 |
| 中文描述： | 5 V FIXED POSITIVE LDO REGULATOR, 0.3 V DROPOUT, PDSO5 |
| 封裝： | LEAD FREE, SC-59, SOT-23, TSOP-5 |
| 文件頁數： | 6/9頁 |
| 文件大?。?/td> | 193K |
| 代理商： | NCP699SN50T1G |
NCP699
http://onsemi.com
6
DEFINITIONS
Load Regulation
The change in output voltage for a change in output
current at a constant temperature.
Dropout Voltage
The input/output differential at which the regulator output
no longer maintains regulation against further reductions in
input voltage. Measured when the output drops 3.0% below
its nominal. The junction temperature, load current, and
minimum input supply requirements affect the dropout level.
Maximum Power Dissipation
The maximum total dissipation for which the regulator
will operate within its specifications.
Quiescent and Ground Current
The quiescent current is the current which flows through
the ground when the LDO operates without a load on its
output: internal IC operation, bias, etc. When the LDO
becomes loaded, this term is called the Ground current. It is
actually the difference between the input current (measured
through the LDO input pin) and the output current.
Line Regulation
The change in output voltage for a change in input voltage.
The measurement is made under conditions of low
dissipation or by using pulse technique such that the average
chip temperature is not significantly affected.
Line Transient Response
Typical over and undershoot response when input voltage
is excited with a given slope.
Thermal Protection
Internal thermal shutdown circuitry is provided to protect
the integrated circuit in the event that the maximum junction
temperature is exceeded. When activated at typically 160
°
C,
the regulator turns off. This feature is provided to prevent
failures from accidental overheating.
Maximum Package Power Dissipation
The maximum power package dissipation is the power
dissipation level at which the junction temperature reaches
its maximum operating value, i.e. 125
°
C. Depending on the
ambient power dissipation and thus the maximum available
output current.
相關PDF資料 |
PDF描述 |
|---|---|
| NCP699 | 150 mA CMOS Low Iq LDO with Enable in TSOP-5(帶有使能端的150mA CMOS, 低Iq LDO) |
| NCP700 | Ultra Low Noise, High PSSR,BiCMOS RF LDO Regulator |
| NCP700MN180R2G | Ultra Low Noise, High PSSR,BiCMOS RF LDO Regulator |
| NCP700MN280R2G | Ultra Low Noise, High PSSR,BiCMOS RF LDO Regulator |
| NCP700MN300R2G | Ultra Low Noise, High PSSR,BiCMOS RF LDO Regulator |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP700 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Ultra Low Noise, High PSSR,BiCMOS RF LDO Regulator |
| NCP700B | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:200 mA, Ultra Low Noise, High PSRR, BiCMOS RF LDO Regulator |
| NCP700BMT18TBG | 功能描述:低壓差穩壓器 - LDO 200MA ULN RF LDO REG1.8V RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| NCP700BMT28TBG | 功能描述:低壓差穩壓器 - LDO 200MA ULN RF LDO REG2.8V RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
| NCP700BMT30TBG | 功能描述:低壓差穩壓器 - LDO 200MA ULN RF LDO REG 3V RoHS:否 制造商:Texas Instruments 最大輸入電壓:36 V 輸出電壓:1.4 V to 20.5 V 回動電壓（最大值）:307 mV 輸出電流:1 A 負載調節:0.3 % 輸出端數量: 輸出類型:Fixed 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-20 |
發布緊急采購，3分鐘左右您將得到回復。