- 您現在的位置：買賣IC網 > PDF目錄361090 > NCP1216AP65 (ON SEMICONDUCTOR) PWM Current-Mode Controller for High-Power Universal Off-Line Supplies PDF資料下載
參數資料
| 型號： | NCP1216AP65 |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
| 中文描述： | 0.5 A SWITCHING CONTROLLER, 71.5 kHz SWITCHING FREQ-MAX, PDIP7 |
| 封裝： | PLASTIC, DIP-8/7 |
| 文件頁數： | 12/18頁 |
| 文件大?。?/td> | 182K |
| 代理商： | NCP1216AP65 |
NCP1216, NCP1216A
http://onsemi.com
12
315.4U
882.7U
1.450M
2.017M
2.585M
300
200
100
0
Figure 23. The Skip Cycle Takes Place at Low Peak
Currents which Guarantees Noise Free Operation
Skip Cycle
Current Limit
Max Peak
Current
NonLatching Shutdown
In some cases, it might be desirable to shut off the part
temporarily and authorize its restart once the default has
disappeared. This option can easily be accomplished
through a single NPN bipolar transistor wired between FB
and ground. By pulling FB below the Adj pin 1 level, the
output pulses are disabled as long as FB is pulled below
pin 1. As soon as FB is relaxed, the IC resumes its operation.
Figure 24
depicts the application example:
Figure 24. Another Way of Shutting Down the IC
without a Definitive Latchoff State
8
7
6
5
1
2
3
4
Q1
ON/OFF
A full latching shutdown, including overtemperature
protection, is described in application note AND8069/D.
Power Dissipation
The NCP1216 is directly supplied from the DC rail
through the internal DSS circuitry. The current flowing
through the DSS is therefore the direct image of the
NCP1216 current consumption. The total power dissipation
can be evaluated using:
(VHVDC
11 V)
ICC2
which is, as we saw, directly related to the MOSFET Q
g
. If
we operate the device on a 90250 VAC rail, the maximum
rectified voltage can go up to 350 VDC. However, as the
characterization curves show, the current consumption
drops at a higher junction temperature, which quickly occurs
(eq. 10)
due to the DSS operation. In our example, at
T
ambient
= 50
°
C, I
CC2
is measured to be 2.9 mA with a
10 A / 600 V MOSFET. As a result, the NCP1216 will
dissipate from a 250 VAC network,
350 V
2.9 mA@TA
50 C
1 W
(eq. 11)
The PDIP7 package offers a junctiontoambient thermal
resistance R
JA
of 100
°
C/W. Adding some copper area
around the PCB footprint will help decreasing this number:
12 mm x 12 mm to drop R
JA
down to 75
°
C/W with 35
copper thickness (1 oz.) or 6.5 mm x 6.5 mm with 70
copper thickness (2 oz.). For a SOIC8, the original
178
°
C/W will drop to 100
°
C/W with the same amount of
copper. With this later PDIP7 number, we can compute the
maximum power dissipation that the package accepts at an
ambient of 50
°
C:
TJmax
TAmax
RJ
A
which barely matches our previous budget. Several
solutions exist to help improving the situation:
1. Insert a Resistor in Series with Pin 8:
This resistor will
take a part of the heat normally dissipated by the NCP1216.
Calculations of this resistor imply that V
pin8
does not drop
below 30 V in the lowest mains conditions. Therefore, R
drop
can be selected with:
Vbulkmin
50 V
8 mA
In our case, V
bulk
minimum is 120 VDC, which leads to a
dropping resistor of 8.7 k . With the above example in
mind, the DSS will exhibit a dutycycle of:
2.9 mA 8 mA
36%
Pmax
1 W
(eq. 12)
Rdrop
(eq. 13)
(eq. 14)
By inserting the 8.7 k resistor, we drop
8.7 k
* 8 mA
69.6 V
(eq. 15)
during the DSS activation. The power dissipated by the
NCP1216 is therefore:
Pinstant* DSSduty
(350
cycle
(eq. 16)
69) * 8 m * 0.36
800 mW
We can pass the limit and the resistor will dissipate
1 W
800 mW
200 mW
(eq. 17)
or
(eq. 18)
pdrop
692
8.7 k* 0.36
2. Select a MOSFET with a Lower Q
g
:
Certain MOSFETs
exhibit different total gate charges depending on the
technology they use. Careful selection of this component
can help to significantly decrease the dissipated heat.
3. Implement Figure 3, from AN8069/D, Solution:
This is
another possible option to keep the DSS functionality (good
shortcircuit protection and EMI jittering) while driving any
types of MOSFETs. This solution is recommended when the
designer plans to use SOIC8 controllers.
相關PDF資料 |
PDF描述 |
|---|---|
| NCP1216D100 | PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
| NCP1216D133 | PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
| NCP1216D65 | PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
| NCP1216D65G | PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
| NCP1216P100 | PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1216AP65G | 功能描述:電流型 PWM 控制器 Current Mode PWM w/50% Duty Cycle Max RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1216D100 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
| NCP1216D100R2 | 功能描述:電流型 PWM 控制器 Current Mode PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1216D100R2G | 功能描述:電流型 PWM 控制器 Current Mode PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1216D133 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Current-Mode Controller for High-Power Universal Off-Line Supplies |
發布緊急采購，3分鐘左右您將得到回復。