參數資料
型號: NCP1205P2G
廠商: ON SEMICONDUCTOR
元件分類: 穩壓器
英文描述: Single Ended PWM Controller Featuring QR Operation and Soft Frequency Foldback
中文描述: SWITCHING CONTROLLER, 125 kHz SWITCHING FREQ-MAX, PDIP14
封裝: LEAD FREE, PLASTIC, DIP-14
文件頁數: 14/17頁
文件大?。?/td> 277K
代理商: NCP1205P2G
NCP1205
http://onsemi.com
14
As soon as the system recovers from the error, e.g. FB is
back within its regulation area, the IC operation comes back
to normal.
To avoid any system thermal runaway, another internal
8 x 128 ms delay is combined with the previous 128 ms. It
works as follows: the 128 ms delay is provided to account for
any normal transients that engender a temporary loss of
feedback (FB goes toward ground). However, when the
128 ms period is actually over (the feedback is definitively
lost) the IC stops the output driving pulses for a typical
period of 8 x 128 ms. During this mode, the rest of the
functions are still activated. For instance, in lack of pulses,
the self
supplied being no longer provided, the startup
source turns on and off (when reaching the corresponding
UVLO
L
and UVLO
H
levels), creating an hiccup waveform
on the Vcc line. As soon as the feedback condition is
restored, the 8 x 128 ms is interrupted and, in synchronism
with the Vcc line, the IC is back to normal. The following
diagrams show how this mechanism takes place when FB is
down to zero (optocoupler opened) or up to Vcc
(optocoupler shorted). If we assume that the error is
permanently present, then a burst mode takes place with a
128/8 x 128 = 12.5% duty
cycle. The real transmitted
power is thus:
1
PoutBURST
Overvoltage Detection (OVP)
On the PDIP
14 and the SOIC
16 versions, an OVP pin
allows to shutdown the controller as soon as the level on this
pin exceeds 2.8V, as detailed in Figure 16. In lack of
switching pulses, the Vcc capacitor is no longer refreshed by
the auxiliary supply and slowly discharges toward ground.
When the Vcc level crosses UVLOL, a new startup sequence
occurs. If the OVP has gone, the converter resumes its
operation.
Figure 16. In the PDIP
8 Version, the OVP Pad is not
Pinned Out and is Available with PDIP
14 Devices
Only
+
+
2.8 V
Latched
OVP
18 k
2
1
7
8
2 k
OVP
Protecting Pin 1 Against Negative Spikes
As any CMOS controller, NCP1205 is sensitive to
negative voltages that could appear on it’s pins. To avoid any
adverse latch
up of the IC, we strongly recommend
inserting a 15 k resistor in series with pin 1 and the
high
voltage rail, as shown in Figures 17 and 18. This 15 k
resistor prevents from adversely latching the controller in
case of negative spikes appearing on the bulk capacitor
during the power
off sequence. Please note that this resistor
does not dissipate any continuous power and can therefore
be of low power type. Two 8.2 k can also be wired in series
to sustain the large DC voltage present on the bulk.
相關PDF資料
PDF描述
NCP1205PG Single Ended PWM Controller Featuring QR Operation and Soft Frequency Foldback
NCP1205P Single Ended PWM Controller Featuring QR Operation and Soft Frequency Foldback
NCP1205P2 Single Ended PWM Controller Featuring QR Operation and Soft Frequency Foldback
NCP1205 Single Ended PWM Controller Featuring QR Operation and Soft Frequency Foldback
NCP1207APG PWM Current−Mode Controller for Free Running Quasi−Resonant Operation
相關代理商/技術參數
參數描述
NCP1205PG 功能描述:電流型 PWM 控制器 Single Ended Quasi Resonant PWM RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14
NCP1207/D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PWM Current-Mode Controller for Quasi-Resonant Operation
NCP1207A 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Current-Mode Controller for Free Running Quasi-Resonant Operation
NCP1207A_06 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Current−Mode Controller for Free Running Quasi−Resonant Operation
NCP1207A_07 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:PWM Current-Mode Controller for Free Running Quasi-Resonant Operation