- 您現在的位置：買賣IC網 > PDF目錄363210 > NCP1013ST65T3G (ON SEMICONDUCTOR) Self−Supplied Monolithic Switcher for Low Standby−Power Offline SMPS PDF資料下載
參數資料
| 型號： | NCP1013ST65T3G |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 穩壓器 |
| 英文描述： | Self−Supplied Monolithic Switcher for Low Standby−Power Offline SMPS |
| 中文描述： | 1 A SWITCHING REGULATOR, 71 kHz SWITCHING FREQ-MAX, PSSO4 |
| 封裝： | LEAD FREE, PLASTIC, SOT-223, 4 PIN |
| 文件頁數： | 1/24頁 |
| 文件大?。?/td> | 485K |
| 代理商： | NCP1013ST65T3G |
Semiconductor Components Industries, LLC, 2006
October, 2006
Rev. 17
1
Publication Order Number:
NCP1010/D
NCP1010, NCP1011,
NCP1012, NCP1013,
NCP1014
SelfSupplied Monolithic
Switcher for Low Standby
Power Offline SMPS
The NCP101X series integrates a fixed
frequency current
mode
controller and a 700 V MOSFET. Housed in a PDIP
7,
PDIP
7 Gull Wing, or SOT
223 package, the NCP101X offers
everything needed to build a rugged and low
cost power supply,
including soft
start, frequency jittering, short
circuit protection,
skip
cycle, a maximum peak current setpoint and a Dynamic
Self
Supply (no need for an auxiliary winding).
Unlike other monolithic solutions, the NCP101X is quiet by nature:
during nominal load operation, the part switches at one of the available
frequencies (65
100
130 kHz). When the current setpoint falls
below a given value, e.g. the output power demand diminishes, the IC
automatically enters the so
called skip
cycle mode and provides
excellent efficiency at light loads. Because this occurs at typically 1/4
of the maximum peak value, no acoustic noise takes place. As a result,
standby power is reduced to the minimum without acoustic noise
generation.
Short
circuit detection takes place when the feedback signal fades
away, e.g. in true short
circuit conditions or in broken Optocoupler
cases. External disabling is easily done either simply by pulling the
feedback pin down or latching it to ground through an inexpensive
SCR for complete latched
off. Finally soft
start and frequency
jittering further ease the designer task to quickly develop low
cost and
robust offline power supplies.
For improved standby performance, the connection of an auxiliary
winding stops the DSS operation and helps to consume less than
100 mW at high line. In this mode, a built
in latched overvoltage
protection prevents from lethal voltage runaways in case the
Optocoupler would brake. These devices are available in economical
8
pin dual
in
line and 4
pin SOT
223 packages.
Features
Built
in 700 V MOSFET with Typical R
DSon
of 11
and 22
Large Creepage Distance Between High
Voltage Pins
Current
Mode Fixed Frequency Operation:
65 kHz – 100 kHz
130 kHz
Skip
Cycle Operation at Low Peak Currents Only:
No Acoustic Noise!
Dynamic Self
Supply, No Need for an Auxiliary
Winding
Internal 1.0 ms Soft
Start
Latched Overvoltage Protection with Auxiliary
Winding Operation
Frequency Jittering for Better EMI Signature
Auto
Recovery Internal Output Short
Circuit
Protection
Below 100 mW Standby Power if Auxiliary Winding
is Used
Internal Temperature Shutdown
Direct Optocoupler Connection
SPICE Models Available for TRANsient Analysis
Pb
Free Packages are Available
Typical Applications
Low Power AC/DC Adapters for Chargers
Auxiliary Power Supplies (USB, Appliances,TVs, etc.)
PDIP
7
CASE 626A
AP SUFFIX
1
8
MARKING DIAGRAMS
4
P101xAPyy
AWL
YYWWG
1
See detailed ordering and shipping information in the package
dimensions section on page 21 of this data sheet.
ORDERING INFORMATION
SOT
223
CASE 318E
ST SUFFIX
1
4
AYW
101xy
1
x
y
= Current Limit (0, 1, 2, 3, 4)
= Oscillator Frequency
A (65 kHz), B (100 kHz), C (130 kHz)
= 06 (65 kHz), 10 (100 kHz), 13 (130 kHz)
= 065, 100, 130
= Assembly Location
= Wafer Lot
= Year
WW, W = Work Week
or G
= Pb
Free Package
(Note: Microdot may be in either location)
yy
yyy
A
WL, L
YY, Y
http://onsemi.com
1
PDIP
7
(Gull Wing)
CASE 626AA
APL SUFFIX
1
1xAPLyyy
AWL
YYWWG
相關PDF資料 |
PDF描述 |
|---|---|
| NCP1014APL100R2G | Self−Supplied Monolithic Switcher for Low Standby−Power Offline SMPS |
| NCP1014ST100T3G | Self−Supplied Monolithic Switcher for Low Standby−Power Offline SMPS |
| NCP1014ST65T3G | Self−Supplied Monolithic Switcher for Low Standby−Power Offline SMPS |
| NCP1011AP065G | Self−Supplied Monolithic Switcher for Low Standby−Power Offline SMPS |
| NCP1011AP100G | Self−Supplied Monolithic Switcher for Low Standby−Power Offline SMPS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NCP1014 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Self-Supplied Monolithic Switcher for Low Standby- Power Offline SMPS |
| NCP1014/D | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Self-Supplied Monolithic Switcher for Low Standby-Power Offline SMPS |
| NCP1014AP065 | 功能描述:電流型 PWM 控制器 Low Standby Power RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1014AP065G | 功能描述:電流型 PWM 控制器 Low Standby Power Monolithic Switcher RoHS:否 制造商:Texas Instruments 開關頻率:27 KHz 上升時間: 下降時間: 工作電源電壓:6 V to 15 V 工作電源電流:1.5 mA 輸出端數量:1 最大工作溫度:+ 105 C 安裝風格:SMD/SMT 封裝 / 箱體:TSSOP-14 |
| NCP1014AP10 | 制造商:ONSEMI 制造商全稱:ON Semiconductor 功能描述:Self-Supplied Monolithic Switcher for Low Standby- Power Offline SMPS |
發布緊急采購，3分鐘左右您將得到回復。