- 您現在的位置：買賣IC網 > PDF目錄361077 > NC12S0A0H06PRFA (Delta Electronics, Inc.) Delphi NC06 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V~5.0Vout, 6A PDF資料下載
參數資料
| 型號： | NC12S0A0H06PRFA |
| 廠商： | Delta Electronics, Inc. |
| 英文描述： | Delphi NC06 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V~5.0Vout, 6A |
| 中文描述： | 德爾福NC06系列非隔離負載點DC / DC電源模塊：12Vin，0.9?5.0Vout，6A條 |
| 文件頁數： | 7/14頁 |
| 文件大小： | 581K |
| 代理商： | NC12S0A0H06PRFA |
DS_NC12S06A_02072007
7
FEATURES DESCRIPTIONS
ENABLE (On/Off)
The ENABLE (on/off) input allows external circuitry to put
the NC converter into a low power dissipation (sleep)
mode. Positive (active-high) ENABLE is available as
standard.
Positive ENABLE (active-high) units of the NC series are
turned on if the ENABLE pin is high or floating. Pulling the
pin low will turn off the unit. With the active high function,
the output is guaranteed to turn on if the ENABLE pin is
driven above 2.4V. The output will turn off if the ENABLE
pin voltage is pulled below .8V.
The ENABLE input can be driven in a variety of ways as
shown in Figures 24, 25 and 26. If the ENABLE signal
comes from the primary side of the circuit, the ENABLE
can be driven through either a bipolar signal transistor
(Figure 24) or a logic gate (Figure 25). If the enable signal
comes from the secondary side, then an opto-coupler or
other isolation devices must be used to bring the signal
across the voltage isolation (please see Figure 26).
NC6A/15A/20A
Vout
Ground
Trim
Enable
Ground
Vin
Figure 24:
Enable Input drive circuit for NC series
NC6A/15A/20A
Vout
Ground
Trim
Enable
Ground
Vin
5V
Figure 25:
Enable input drive circuit using logic gate.
NC6A/15A/20A
Vout
Ground
Trim
Enable
Ground
Vin
Figure 26
: Enable input drive circuit example with isolation.
DESIGN CONSIDERATIONS
The NC06 is a single phase and voltage mode controlled
Buck topology. Block diagram of the converter is shown in
Figure 23. The output can be trimmed in the range of
0.9Vdc to 5.0Vdc by a resistor from Trim pin to Ground.
The converter can be turned ON/OFF by remote control.
Positive on/off (ENABLE pin) logic implies that the
converter DC output is enabled when this signal is driven
high (greater than 2.4V) or floating and
disabled when
the
signal is driven low (below 0.8V). Negative on/off logic is
optional and could also be ordered.
The converter provides an open collector signal called
Power Good. The power good signal is pulled low when
output is not within ±10% of Vout or Enable is OFF.
The converter can protect itself by entering hiccup mode
against over current and short circuit condition. Also, the
converter will shut down when an over voltage protection
is detected.
Figure 23:
Block Diagram
Safety Considerations
It is recommended that the user to provide a very
fast-acting type fuse in the input line for safety. The output
voltage set-point and the output current in the application
could define the amperage rating of the fuse.
相關PDF資料 |
PDF描述 |
|---|---|
| NC12S0A0V06NNFA | Delphi NC06 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V~5.0Vout, 6A |
| NC12S0A0V06NRFA | Delphi NC06 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V~5.0Vout, 6A |
| NC12S0A0V06PNFA | Delphi NC06 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V~5.0Vout, 6A |
| NC12S0A0V06PRFA | Delphi NC06 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V~5.0Vout, 6A |
| NC12S0A0H20NNFA | Delphi NC20 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V-5.0Vout, 20A |
相關代理商/技術參數 |
參數描述 |
|---|---|
| NC12S0A0H15NNFA | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Delphi NC15 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V-5.0Vout, 15A |
| NC12S0A0H15NRFA | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Delphi NC15 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V-5.0Vout, 15A |
| NC12S0A0H15PNFA | 制造商:Delta Electronics Inc 功能描述:CONV DC/DC 12VIN 1.5A ADJ OUT |
| NC12S0A0H15PRFA | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Delphi NC15 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V-5.0Vout, 15A |
| NC12S0A0H20NNFA | 制造商:DELTA 制造商全稱:Delta Electronics, Inc. 功能描述:Delphi NC20 Series Non-Isolated Point of Load DC/DC Power Modules: 12Vin, 0.9V-5.0Vout, 20A |
發布緊急采購，3分鐘左右您將得到回復。