- 您現在的位置：買賣IC網 > PDF目錄40030 > MZP4729ATA (ON SEMICONDUCTOR) 3.6 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 PDF資料下載
參數資料
| 型號： | MZP4729ATA |
| 廠商： | ON SEMICONDUCTOR |
| 元件分類： | 齊納二極管 |
| 英文描述： | 3.6 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 |
| 封裝： | PLASTIC, CASE 59-10, 2 PIN |
| 文件頁數： | 5/7頁 |
| 文件大?。?/td> | 129K |
| 代理商： | MZP4729ATA |
MZP4729A Series
http://onsemi.com
5
APPLICATION NOTE
Since the actual voltage available from a given zener
diode is temperature dependent, it is necessary to determine
junction temperature under any set of operating conditions
in order to calculate its value. The following procedure is
recommended:
Lead Temperature, TL, should be determined from:
TL = θLA PD + TA
θLA is the lead-to-ambient thermal resistance (°C/W) and PD
is the power dissipation. The value for θLA will vary and
depends on the device mounting method. θLA is generally
3040°C/W for the various clips and tie points in common
use and for printed circuit board wiring.
The temperature of the lead can also be measured using a
thermocouple placed on the lead as close as possible to the
tie point. The thermal mass connected to the tie point is
normally large enough so that it will not significantly
respond to heat surges generated in the diode as a result of
pulsed operation once steady-state conditions are achieved.
Using the measured value of TL, the junction temperature
may be determined by:
TJ = TL + ΔTJL
ΔTJL is the increase in junction temperature above the lead
temperature and may be found from Figure 2 for a train of
power pulses (L = 3/8 inch) or from Figure 10 for dc power.
ΔTJL = θJL PD
For worst-case design, using expected limits of IZ, limits
of PD and the extremes of TJ (ΔTJ) may be estimated.
Changes in voltage, VZ, can then be found from:
ΔV = θVZ ΔTJ
θVZ, the zener voltage temperature coefficient, is found
from Figures 5 and 6.
Under high power-pulse operation, the zener voltage will
vary with time and may also be affected significantly by the
zener resistance. For best regulation, keep current
excursions as low as possible.
Data of Figure 2 should not be used to compute surge
capability. Surge limitations are given in Figure 3. They are
lower than would be expected by considering only junction
temperature, as current crowding effects cause temperatures
to be extremely high in small spots resulting in device
degradation should the limits of Figure 3 be exceeded.
相關PDF資料 |
PDF描述 |
|---|---|
| MZPY12CRL2 | 12 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 |
| MZPY4.3DTA | 4.3 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 |
| MZPY4.7DRL2 | 4.7 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 |
| MZPY5.1CRL2 | 5.1 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 |
| MZPY51CTA | 51 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MZP4730 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:1.0 WATT SURMETIC 30 SILICON ZENER DIODES |
| MZP4731 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:1.0 WATT SURMETIC 30 SILICON ZENER DIODES |
| MZP4732 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:1.0 WATT SURMETIC 30 SILICON ZENER DIODES |
| MZP4733 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:1.0 WATT SURMETIC 30 SILICON ZENER DIODES |
| MZP4734 | 制造商:MOTOROLA 制造商全稱:Motorola, Inc 功能描述:1.0 WATT SURMETIC 30 SILICON ZENER DIODES |
發布緊急采購，3分鐘左右您將得到回復。