參數資料
型號: MZ4099TA2
元件分類: 齊納二極管
英文描述: 6.8 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-35
封裝: HERMETIC SEALED, GLASS, DO-204AH, 2 PIN
文件頁數: 5/9頁
文件大小: 462K
代理商: MZ4099TA2
MZ4614 through MZ4104 Series
http://www.takcheong.com
5
APPLICATION NOTE - ZENER VOLTAGE
Since the actual voltage available from a given zener
diode is temperature dependent, it is necessary to determine
junction temperature under any set of operating conditions
in order to calculate its value. The following procedure is
recommended:
Lead Temperature, TL, should be determined from:
TL = θLAPD + TA.
θLA is the lead-to-ambient thermal resistance (°C/W) and PD
is the power dissipation. The value for
θLA will vary and
depends on the device mounting method.
θLA is generally 30
to 40
°C/W for the various clips and tie points in common use
and for printed circuit board wiring.
The temperature of the lead can also be measured using a
thermocouple placed on the lead as close as possible to the
tie point. The thermal mass connected to the tie point is
normally large enough so that it will not significantly
respond to heat surges generated in the diode as a result of
pulsed operation once steady-state conditions are achieved.
Using the measured value of TL, the junction temperature
may be determined by:
TJ = TL + TJL.
TJL is the increase in junction temperature above the lead
temperature and may be found from Figure 2 for dc power:
TJL = θJLPD.
For worst-case design, using expected limits of IZ, limits
of PD and the extremes of TJ(TJ) may be estimated.
Changes in voltage, VZ, can then be found from:
V = θVZTJ.
θVZ, the zener voltage temperature coefficient, is found
from Figures 4 and 5.
Under high power-pulse operation, the zener voltage will
vary with time and may also be affected significantly by the
zener resistance. For best regulation, keep current
excursions as low as possible.
Surge limitations are given in Figure 7. They are lower
than would be expected by considering only junction
temperature, as current crowding effects cause temperatures
to be extremely high in small spots, resulting in device
degradation should the limits of Figure 7 be exceeded.
LL
500
400
300
200
100
0
0.2
0.4
0.6
0.8
1
2.4-60 V
62-200 V
L , LEAD LENGTH TO HEAT SINK (INCH)
JL
,JUNCTION
T
O
LEAD
THERMA
L
RESISTANC
E
(
°
C/W)
θ
Figure 2. Typical Thermal Resistance
TYPICAL LEAKAGE CURRENT
AT 80% OF NOMINAL
BREAKDOWN VOLTAGE
+2
5°C
+12
5°C
1000
7000
5000
2000
1000
700
500
200
100
70
50
20
10
7
5
2
1
0.7
0.5
0.2
0.1
0.07
0.05
0.02
0.01
0.007
0.005
0.002
0.001
34
5
6
7
8
9
10
11
12
VZ , NOMINAL ZENER VOLTAGE (VOLTS)
I
,LEAKAGE
CURRENT
(
A
)
R
Figure 3. Typical Leakage Current
13
14
15
相關PDF資料
PDF描述
MZ4100TA2 7.5 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-35
MZ4100TA 7.5 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-35
MZ4101RA2 8.2 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-35
MZ4101RR1 8.2 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-35
MZ4101RR2 8.2 V, 0.5 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-35
相關代理商/技術參數
參數描述
MZ4131 制造商:VISUAL COMMUNICATIONS COMPANY LLC 功能描述:O-RING FOR MOD 6000
MZ43V 制造商:YEASHIN 制造商全稱:YEASHIN 功能描述:500 mW DO-34 Hermetically Sealed Glass Zener Voltage Regulators
MZ4614/D 制造商:未知廠家 制造商全稱:未知廠家 功能描述:500 Milliwatt Hermetically Sealed Glass Silicon Zener Diodes
MZ4614RL 制造商:Rochester Electronics LLC 功能描述:- Bulk
MZ4616 制造商:ON Semiconductor 功能描述:ZEN D035 REG 0.5W 2.2V