- 您現在的位置：買賣IC網 > PDF目錄376216 > MXP-128SF (Electronic Theatre Controls, Inc.) 1.25G SFP Transceiver PDF資料下載
參數資料
| 型號： | MXP-128SF |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 1.25G SFP Transceiver |
| 中文描述： | 1.25G SFP收發器 |
| 文件頁數： | 5/7頁 |
| 文件大?。?/td> | 179K |
| 代理商： | MXP-128SF |
Receiver Section
The receiver utilizes an InGaAs PIN photodiode mounted together with a
trans-impedance preamplifier IC in an OSA. This OSA is connected to a circuit providing
post-amplification quantization, and optical signal detection.
RX-LOS
LOS (Loss of Signal) is an open collector/drain output, which should be pulled up
with a 4.7K – 10K
resistor. Pull up voltage between 2.0V and VccT, R+0.3V. When high,
this output indicates the received optical power is below the worst-case receiver sensitivity
(as defined by the standard in use). Low indicates normal operation. In the low state, the
output will be pulled to < 0.8V.
The RX-LOS is high (TTL logic “1”) when there is no incoming light from the
companion transceiver. This signal is normally used by the system for the diagnostic
purpose. The signal is operated in TTL level.
RD-/+
These are the differential receiver outputs. They are AC coupled 100
differential
lines which should be terminated with 100
(differential) at the user SERDES. The AC
coupling is done inside the module and is thus not required on the host board. The voltage
swing on these lines will be between 370 and 2000 mV differential (185 – 1000 mV single
ended) when properly terminated.
Recommended Interface Circuit
Laser
driver
Amplifier
EEPROM
Host Board
DC+3.3V
4.7K to 10K
DC+3.3V
PECL
PECL
DC +3.3V
DC+3.3V
3X4.7K to 10K
4.7K to 10K
DC+3.3V
2X150
SFP Module
DC+3.3V
4.7K to 10K
TX-DSABLE
TX-FAULT
TX-DATQ
TX-DAT
Z0=50
Z0=50
Z0=50
Z0=50
RX-DAT
RX-DATQ
RX-LOS
MODDEF(2)
MODDEF(1)
MODDEF(0)
SerDat IN+
SerDat IN
SerDat OUT+
SerDat OUT-
RGND
5of7
相關PDF資料 |
PDF描述 |
|---|---|
| MXP-128SV | 1.25G SFP Transceiver |
| MXP-485MD | 1.25G SFP Transceiver |
| MXP-485MF | 1.25G SFP Transceiver |
| MXP-485MV | 1.25G SFP Transceiver |
| MXP-485SD | 1.25G SFP Transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MXP-128SV | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:1.25G SFP Transceiver |
| MXP18-C | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:Monolithic Photodiode Array-Chip |
| MXP190B | 功能描述:可復位保險絲 - RoHS:否 制造商:Bourns 電流額定值: 電阻:7.5 Ohms 最大直流電壓: 保持電流:0.1 A 安裝風格:SMD/SMT 端接類型:SMD/SMT 跳閘電流:0.6 A 引線間隔: 系列:MF-PSHT 工作溫度范圍:- 40 C to + 125 C |
| MXP190BB | 功能描述:可復位保險絲 1.9A 6.0V .01 OHM STRAP BATTERY RoHS:否 制造商:Bourns 電流額定值: 電阻:7.5 Ohms 最大直流電壓: 保持電流:0.1 A 安裝風格:SMD/SMT 端接類型:SMD/SMT 跳閘電流:0.6 A 引線間隔: 系列:MF-PSHT 工作溫度范圍:- 40 C to + 125 C |
| MXP190BBLL | 制造商:TE 功能描述:RF2108-000 |
發布緊急采購，3分鐘左右您將得到回復。