- 您現在的位置：買賣IC網 > PDF目錄380549 > MX28F2000PQC-12C4 (MACRONIX INTERNATIONAL CO LTD) 2M-BIT [256K x 8] CMOS FLASH MEMORY PDF資料下載
參數資料
| 型號： | MX28F2000PQC-12C4 |
| 廠商： | MACRONIX INTERNATIONAL CO LTD |
| 元件分類： | DRAM |
| 英文描述： | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| 中文描述： | 256K X 8 FLASH 12V PROM, 120 ns, PQCC32 |
| 封裝： | PLASTIC, MO-052, LCC-32 |
| 文件頁數： | 10/33頁 |
| 文件大?。?/td> | 191K |
| 代理商： | MX28F2000PQC-12C4 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
10
P/N: PM0380
REV. 1.5, OCT 29, 1998
MX28F2000P
While the Automatic Erase algorithm is in operation,
DQ7 will read "0" until the erase operation is com-
pleted. Upon completion of the erase operation, the
data on DQ7 will read "1". The Data Polling feature is
valid after the rising edge of the second WE pulse of
two write pulse sequences.
The Data Polling feature is active during Automatic
Program/Erase algorithms.
POWER-UP SEQUENCE
The MX28F2000P powers up in the Read only mode.
In addition, the memory contents may only be altered
after successful completion of a two-step command
sequence. Power up sequence is not required.
SYSTEM CONSIDERATIONS
During the switch between active and standby condi-
tions, transient current peaks are produced on the
rising and falling edges of Chip Enable. The
magnitude of these transient current peaks is
dependent on the output capacitance loading of the
device. At a minimum, a 0.1uF ceramic capacitor (high
frequency, low inherent inductance) should be used
on each device between VCC and GND, and between
VPP and GND to minimize transient effects. In
addition, to overcome the voltage drop caused by the
inductive effects of the printed circuit board traces on
FLASH memory arrays, a 4.7uF bulk electrolytic
capacitor should be used between VCC and GND for
each eight devices. The location of the capacitor
should be close to where the power supply is con-
nected to the array.
相關PDF資料 |
PDF描述 |
|---|---|
| MX28F2000PQC-70C4 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| MX28F2000PQC-90C4 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| MX28F2000PTC-12C4 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| MX28F2000PTC-70C4 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
| MX28F2000PTC-90C4 | 2M-BIT [256K x 8] CMOS FLASH MEMORY |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MX28F2000PQC-70C4 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
| MX28F2000PQC-90C4 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
| MX28F2000PRC-12C4 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
| MX28F2000PRC-70C4 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
| MX28F2000PRC-90C4 | 制造商:MCNIX 制造商全稱:Macronix International 功能描述:2M-BIT [256K x 8] CMOS FLASH MEMORY |
發布緊急采購，3分鐘左右您將得到回復。