參數資料
型號: MQ83C154TXXX-20/883R
廠商: TEMIC SEMICONDUCTORS
元件分類: 微控制器/微處理器
英文描述: 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQFP44
文件頁數: 22/46頁
文件大?。?/td> 7004K
代理商: MQ83C154TXXX-20/883R
154
7593L–AVR–09/12
AT90USB64/128
output can be generated by setting the COM2x1:0 to three. TOP is defined as 0xFF when
WGM2:0 = 3, and OCR2A when MGM2:0 = 7 (see Table 16-3 on page 157). The actual OC2x
value will only be visible on the port pin if the data direction for the port pin is set as output. The
PWM waveform is generated by clearing (or setting) the OC2x Register at the compare match
between OCR2x and TCNT2 when the counter increments, and setting (or clearing) the OC2x
Register at compare match between OCR2x and TCNT2 when the counter decrements. The
PWM frequency for the output when using phase correct PWM can be calculated by the follow-
ing equation:
The N variable represents the prescale factor (1, 8, 32, 64, 128, 256, or 1024).
The extreme values for the OCR2A Register represent special cases when generating a PWM
waveform output in the phase correct PWM mode. If the OCR2A is set equal to BOTTOM, the
output will be continuously low and if set equal to MAX the output will be continuously high for
non-inverted PWM mode. For inverted PWM the output will have the opposite logic values.
At the very start of period 2 in Figure 16-7 on page 153 OCnx has a transition from high to low
even though there is no Compare Match. The point of this transition is to guarantee symmetry
around BOTTOM. There are two cases that give a transition without Compare Match.
OCR2A changes its value from MAX, like in Figure 16-7 on page 153. When the OCR2A
value is MAX the OCn pin value is the same as the result of a down-counting compare match.
To ensure symmetry around BOTTOM the OCn value at MAX must correspond to the result
of an up-counting Compare Match
The timer starts counting from a value higher than the one in OCR2A, and for that reason
misses the Compare Match and hence the OCn change that would have happened on the
way up
16.7
Timer/Counter timing diagrams
The following figures show the Timer/Counter in synchronous mode, and the timer clock (clk
T2)
is therefore shown as a clock enable signal. In asynchronous mode, clk
I/O should be replaced by
the Timer/Counter Oscillator clock. The figures include information on when Interrupt Flags are
set. Figure 16-8 contains timing data for basic Timer/Counter operation. The figure shows the
count sequence close to the MAX value in all modes other than phase correct PWM mode.
Figure 16-8. Timer/Counter timing diagram, no prescaling.
fOCnxPCPWM
f
clk_I/O
N 510
------------------
=
clk
Tn
(clk
I/O/1)
TOVn
clk
I/O
TCNTn
MAX - 1
MAX
BOTTOM
BOTTOM + 1
相關PDF資料
PDF描述
MQ83C154TXXX-20P883D 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CQFP44
MD83C154DTXXX-20/883D 8-BIT, MROM, 20 MHz, MICROCONTROLLER, CDIP40
MR83C154DCXXX-25P883 8-BIT, MROM, 25 MHz, MICROCONTROLLER, CQCC44
MC80C52CXXX-12SHXXX:D 8-BIT, MROM, 12 MHz, MICROCONTROLLER, CDIP40
MR80C52CXXX-16SHXXX:R 8-BIT, MROM, 16 MHz, MICROCONTROLLER, CQCC44
相關代理商/技術參數
參數描述
MQ86 制造商:TE Connectivity 功能描述:
MQ8797BH 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Intel 功能描述:
MQ87C196KC/R 制造商:Rochester Electronics LLC 功能描述:
MQ87C196KD-16/B 制造商:Rochester Electronics LLC 功能描述:
MQ87C196KD-20/R 制造商:Rochester Electronics LLC 功能描述: