33
8272E–AVR–04/2013
ATmega164A/PA/324A/PA/644A/PA/1284/P
9.3
Low Power Crystal Oscillator
This Crystal Oscillator is a low power oscillator, with reduced voltage swing on the XTAL2 out-
put. It gives the lowest power consumption, but is not capable of driving other clock inputs, and
may be more susceptible to noise in noisy environments. In these cases, refer to the
”Full swingSome initial guidelines for choosing capacitors for use with crystals are given in
Table 9-3. The
The Low Power Oscillator can operate in three different modes, each optimized for a specific fre-
quency range. The operating mode is selected by the fuses CKSEL3..1 as shown in
Table 9-3.
Notes:
1. If the crystal frequency exceeds the specification of the device (depends on VCC), the CKDIV8
Fuse can be programmed in order to divide the internal frequency by 8. It must be ensured
that the resulting divided clock meets the frequency specification of the device.
2. This is the recommended CKSEL settings for the different frequency ranges.
3. This option should not be used with crystals, only with ceramic resonators.
The CKSEL0 Fuse together with the SUT1..0 Fuses select the start-up times as shown in
TableTable 9-3.
Low Power Crystal Oscillator Operating Modes
Frequency Range [MHz]
Recommended Range for Capacitors C1 and C2 [pF]
0.4 - 0.9
–
0.9 - 3.0
101
12 - 22
3.0 - 8.0
110
12 - 22
8.0 - 16.0
111
12 - 22
Table 9-4.
Start-up Times for the Low Power Crystal Oscillator Clock Selection.
Oscillator source /
power conditions
Start-up time from
power-down and
power-save
Additional delay
from reset
(VCC = 5.0V)
CKSEL0
SUT1..0
Ceramic resonator, fast
rising power
258CK
000
Ceramic resonator, slowly
rising power
258CK
001
Ceramic resonator, BOD
enabled
1K CK
010
Ceramic resonator, fast
rising power
1K CK
011
Ceramic resonator, slowly
rising power
1K CK
100
Crystal Oscillator, BOD
enabled
16K CK
14CK
1
01
Crystal Oscillator, fast
rising power
16K CK
14CK + 4.1ms
1
10
Crystal Oscillator, slowly
rising power
16K CK
14CK + 65ms
1
11