- 您現在的位置：買賣IC網 > PDF目錄25640 > MQ80C154-25/883 (TEMIC SEMICONDUCTORS) 8-BIT, 25 MHz, MICROCONTROLLER, CQFP44 PDF資料下載
參數資料
| 型號： | MQ80C154-25/883 |
| 廠商： | TEMIC SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, 25 MHz, MICROCONTROLLER, CQFP44 |
| 文件頁數： | 41/80頁 |
| 文件大小： | 5152K |
| 代理商： | MQ80C154-25/883 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁當前第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
241
XMEGA A [MANUAL]
8077I–AVR–11/2012
The recommendations for the maximum receiver baud rate error assume that the receiver and transmitter equally divide
the maximum total error.
21.9
Fractional Baud Rate Generation
Fractional baud rate generation is possible for asynchronous operation due to the relatively high number of clock cycles
for each frame. Each bit is sampled sixteen times, but only the three middle samples are of importance. The total number
of samples for one frame is also relatively high. Given a 1-start, 8-data, no-parity, and 1-stop-bit frame format, and
assuming that normal speed mode is used, the total number of samples for a frame is (1+8+1)×16 or 160. As stated
earlier, the UART can tolerate some variation in clock cycles for each sample. The critical factor is the time from the
falling edge of the start bit (i.e., the clock synchronization) until the last bit's (i.e., the first stop bit’s) value is recovered.
Standard baud rate generators have the unwanted property of having large frequency steps between high baud rate
settings. The worst case is found between the BSEL values 0x000 and 0x001. Going from a BSEL value of 0x000, which
has a 10-bit frame of 160 clock cycles, to a BSEL value of 0x001, with 320 clock cycles, gives a 50% change in
frequency. Ideally, the step size should be small even between the fastest baud rates. This is where the advantage of the
fractional baud rate generator emerges.
In principle, the fractional baud rate generator works by doing uneven counting and then distributing the error evenly over
the entire frame. A typical count sequence for an ordinary baud rate generator is:
2, 1, 0, 2, 1, 0, 2, 1, 0, 2, …
which has an even period time. A baud rate clock ticks each time the counter reaches zero, and a sample of the signal
received on RxD is taken for every 16th baud rate clock tick.
For the fractional baud rate generator, the count sequence can have an uneven period:
2, 1, 0, 2, 1-1, 0, 2, 1, 0, 2, 1-1, 0, ...
In this example, an extra cycle is added to every second baud clock. This gives a baud rate clock tick jitter, but the
average period has been increased by a fraction of 0.5 clock cycles.
Figure 21-9 on page 242 shows an example of how BSEL and BSCALE can be used to achieve baud rates in between
what is possible by just changing BSEL.
The impact of fractional baud rate generation is that the step size between baud rate settings has been reduced. Given a
scale factor of -1, the worst-case step then becomes from 160 to 240 clock cycles per 10-bit frame, compared to the
previous step of from 160 to 320. A higher negative scale factor gives even finer granularity. There is a limit however, to
how high the scale factor can be. The value 2|BSCALE| must be at most half the minimum number of clock cycles of a
frame. For instance, for 10-bit frames, the minimum number of clock cycles is 160. This means that the highest
applicable scale factor is -6 (2I-6I = 64 < (160/2) = 80).
For higher BSEL settings, the scale factor can be increased.
Table 21-5 on page 242 shows BSEL and BSCALE settings when using the internal oscillators to generate the most
commonly used baud rates for asynchronous operation and how reducing the BSCALE can be used to reduce the baud
rate error even further.
相關PDF資料 |
PDF描述 |
|---|---|
| MSP430F2003TRSAR | 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC16 |
| MSP430F2012IRSAR | 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC16 |
| MSP430F2013TRSAR | 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC16 |
| MSP430F2001IRSA | 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PQCC16 |
| MSP430F2013IPWR | 16-BIT, FLASH, 16 MHz, RISC MICROCONTROLLER, PDSO14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MQ80C154-30 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MQ80C154-36 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MQ80C154-L16 | 制造商:TEMIC 制造商全稱:TEMIC Semiconductors 功能描述:CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller |
| MQ80C186-10/BYA | 制造商:Rochester Electronics LLC 功能描述: |
| MQ80C186-12/BYA | 制造商:Rochester Electronics LLC 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。