- 您現在的位置：買賣IC網 > PDF目錄359200 > MPU150-S259 Power Factor Correction (PFC) Meets EN61000-3-2 PDF資料下載
參數資料
| 型號： | MPU150-S259 |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Power Factor Correction (PFC) Meets EN61000-3-2 |
| 中文描述： | 功率因數校正（PFC）符合EN61000 - 3 - 2 |
| 文件頁數： | 3/6頁 |
| 文件大?。?/td> | 303K |
| 代理商： | MPU150-S259 |
3
MPU150/MDU150 SERIES
OUTPUT SPECIFICATIONS
PARAMETER
Efficiency
Minimum Load, V1
CONDITIONS/DESCRIPTION
Full Rated Load, 110 VAC. Varies with distribution of loads among outputs.
Minimum load required to maintain regulation on
V2 at maximum load.
Minimum load required to maintain regulation on
V4 at maximum load.
Full load, 20MHz bandwidth.
With 300 LFM forced air cooling. (Note 1)
Output voltage overshoot/undershoot at turn-on.
Varies by output. Total regulation includes: line changes over the specified.
input range, changes in load starting at 20% load and changing to 100% load.
Recovery time, to within 1% of initial set point due to a 50-100% load change,
5% max. deviation.
Time required for initial output voltage stabilization.
Time required for output voltage to rise from 10% to 90%.
MIN
65
4
3
N/A
0.3
See Model Selection Charts
150
NOM
75
MAX
UNITS
%
MPU150-3300, V1
All other models, V1
MPU150-3300, V3
All other models, V3
A
Minimum Load, V3
A
Ripple and Noise
Output Power
Overshoot / Undershoot
Regulation
Watts
%
0
See Model Selection Charts
Transient Response
500
μS
Turn-on Delay
Turn-on Rise Time
2
20
Sec
mS
INTERFACE SIGNALS AND INTERNAL PROTECTION
PARAMETER
Overvoltage Protection
CONDITIONS/DESCRIPTION
Latch style overvoltage protection. Available on
V1, V2, all models, and V3 on all models except
MPU150-3300.
MIN
3.0
4.1
3.8
6.0
14
4.3
NOM
MAX
3.25
4.65
4.2
6.4
16
4.65
UNITS
2.5V output, V1
3.3V output, V1
3.3V output, V2
5V output, V1, V2
12V output, V2 (Note 2)
MPU150-4350 3.3V output, V1
V
Overload Protection
Overtemperature Protection
Output Good
Fully protected against output overload and short circuit. Automatic recovery upon removal of overload condition.
System shutdown due to excessive internal temperature, automatic reset.
TTL compatible signal available for V1. Signal is high when
output is within 5% of nominal. Signal shall remain low for 20
milliseconds following loss of Output Good.
TTL compatible logic signal. Time before regulation dropout due to loss of input
power. May be used as independent PSOK signal in redundant applications.
Accuracy of shared current with up to 6 parallel units. Single wire current share
on V1 and V2 with return via -Sense return.
Available on V1 and V2. Total voltage compensation for cable losses with
respect to the main output.
Output voltage is inhibited by application of an external high (5V) signal.
NOTES:
1) Overvoltage range for 12V, V3 outputs: 14V to 19V.
3.3V
5V
3.16
4.75
V
Input Power Fail Warning
5
mS
Current Share
10
%
Remote Sense
500
mV
Inhibit
SAFETY, REGULATORY, AND EMI SPECIFICATIONS
PARAMETER
Agency Approvals
CONDITIONS/DESCRIPTION
UL1950.
CSA 22.2 NO. 234/950.
EN60950 (TüV).
Input to output per EN60950.
MIN
NOM
MAX
UNITS
Approved
Dielectric Withstand Voltage
MPU150
MDU150 1544
2600
VDC
Electromagnetic Interference
FCC CFR title 47 Part 15 Sub-Part B - Conducted.
EN55022 / CISPR 22 Conducted.
Per EN61000-4-2, level 4.
Per EN61000-4-3, level 3.
Per EN61000-4-4, level 3.
Per EN61000-4-5, class 3.
B
B
8
10
±2
1
2
Class
ESD Susceptibility
Radiated Susceptibility
EFT/Burst
Input Transient Protection
kV
V/M
kV
Line to Line
Line to Ground
kV
Insulation Resistance
Leakage Current
Input to output.
Per EN60950.
10
M
MPU150 at 264 VAC
MDU150 at 72 VDC
2) Overvoltage range for 12V, V3 outputs: 14V to 19V.
1250
100
μA
NOTES:
1) This product is not rated for convection applications.
相關PDF資料 |
PDF描述 |
|---|---|
| MPW1021 | MPW1000 25 - 30 Watts 2:1 Wide Input Range DC/DC Converters Single Outputs |
| MPX10DP | 10kPa Uncompensated Silicon Pressure Sensors(10kPa無補償硅壓力傳感器) |
| MPX12D | 10kPa Uncompensated Silicon Pressure Sensors(10kPa無補償硅壓力傳感器) |
| MPX2010 | 10kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors(10kPa片內溫度補償和校準硅壓力傳感器) |
| MPX2100A | 100kPa On-Chip Temperature Compensated & Calibrated Silicon Pressure Sensors(100kPa片內溫度補償和校準硅壓力傳感器) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MPU150-S261 | 制造商:Power-One 功能描述:150 W Single Output 48 V Open Frame Power Supply |
| MPU150-S262 | 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:Power Factor Correction (PFC) Meets EN61000-3-2 |
| MPU150-S270M | 制造商:Power-One 功能描述: |
| MPU150-S301 | 制造商:Power-One 功能描述: |
| MPU15A | 制造商:MPSIND 制造商全稱:MPS Industries, Inc. 功能描述:15W Desk Top Switching Power Supplies For Medical Equipment. |
發布緊急采購，3分鐘左右您將得到回復。