參數資料
型號： MPC8347EVRAJD
廠商： FREESCALE SEMICONDUCTOR INC
元件分類： 微控制器/微處理器
英文描述： 32-BIT, 533 MHz, RISC PROCESSOR, PBGA620
封裝： 29 X 29 MM, 2.46 MM HEIGHT, 1 MM PITCH, LEAD FREE, PLASTIC, BGA-620
文件頁數： 13/102頁
文件大?。?/td> 1094K
代理商： MPC8347EVRAJD
MPC8347E PowerQUICC II Pro Integrated Host Processor Hardware Specifications, Rev. 11
18
Freescale Semiconductor
DDR SDRAM
Figure 5 shows the DDR SDRAM output timing for address skew with respect to any MCK.
Figure 5. Timing Diagram for tAOSKEW Measurement
Figure 6 provides the AC test load for the DDR bus.
MDQS epilogue end
tDDKLME
-0.9
0.3
ns
7
Notes:
1. The symbols used for timing specifications follow the pattern of t(first two letters of functional block)(signal)(state)(reference)(state) for
inputs and t(first two letters of functional block)(reference)(state)(signal)(state) for outputs. Output hold time can be read as DDR timing
(DD) from the rising or falling edge of the reference clock (KH or KL) until the output went invalid (AX or DX). For example,
tDDKHAS symbolizes DDR timing (DD) for the time tMCK memory clock reference (K) goes from the high (H) state until outputs
(A) are setup (S) or output valid time. Also, tDDKLDX symbolizes DDR timing (DD) for the time tMCK memory clock reference
(K) goes low (L) until data outputs (D) are invalid (X) or data output hold time.
2. All MCK/MCK referenced measurements are made from the crossing of the two signals ±0.1 V.
3. In the source synchronous mode, MCK/MCK can be shifted in 1/4 applied cycle increments through the clock control register.
For the skew measurements referenced for tAOSKEW it is assumed that the clock adjustment is set to align the
address/command valid with the rising edge of MCK.
4. ADDR/CMD includes all DDR SDRAM output signals except MCK/MCK, MCS, and MDQ/MECC/MDM/MDQS. For the
ADDR/CMD setup and hold specifications, it is assumed that the clock control register is set to adjust the memory clocks by
1/2 applied cycle.
5. Note that tDDKHMH follows the symbol conventions described in note 1. For example, tDDKHMH describes the DDR timing (DD)
from the rising edge of the MCK(n) clock (KH) until the MDQS signal is valid (MH). tDDKHMH can be modified through control
of the DQSS override bits in the TIMING_CFG_2 register. In source synchronous mode, this will typically be set to the same
delay as the clock adjust in the CLK_CNTL register. The timing parameters listed in the table assume that these 2 parameters
have been set to the same adjustment value. See the
MPC8349E PowerQUICC II Pro Integrated Host Processor Family
Reference Manual, for a description and understanding of the timing modifications enabled by use of these bits.
6. Determined by maximum possible skew between a data strobe (MDQS) and any corresponding bit of data (MDQ), ECC
(MECC), or data mask (MDM). The data strobe should be centered inside of the data eye at the pins of the MPC8347E.
7. All outputs are referenced to the rising edge of MCK(n) at the pins of the MPC8347E. Note that tDDKHMP follows the symbol
conventions described in note 1.
Table 14. DDR SDRAM Output AC Timing Specifications for Source Synchronous Mode (continued)
At recommended operating conditions with GVDD of 2.5 V ± 5%.
Parameter
Symbol1
Min
Max
Unit
Notes
ADDR/CMD
MCK[n]
tMCK
CMD
NOOP
ADDR/CMD
CMD
NOOP
tAOSKEWmax)
tAOSKEW(min)
相關PDF資料
PDF描述
MPC8347VVALF 32-BIT, 667 MHz, RISC PROCESSOR, PBGA672
MPC8347ECZQALF 32-BIT, 667 MHz, RISC PROCESSOR, PBGA620
MPC8347EVVAJF 32-BIT, 533 MHz, RISC PROCESSOR, PBGA672
MPC8347ECZUADD 32-BIT, 266 MHz, RISC PROCESSOR, PBGA672
MPC8347ECZUALD 32-BIT, 667 MHz, RISC PROCESSOR, PBGA672
相關代理商/技術參數
參數描述
MPC8347EVVAGD 功能描述:IC MPU PWRQUICC II PRO 672-TBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC83xx 標準包裝:1 系列:MPC85xx 處理器類型:32-位 MPC85xx PowerQUICC III 特點:- 速度:1.2GHz 電壓:1.1V 安裝類型:表面貼裝 封裝/外殼:783-BBGA，F(xiàn)CBGA 供應商設備封裝:783-FCPBGA（29x29） 包裝:托盤
MPC8347EVVAGDB 功能描述:微處理器 - MPU 8349 TBGA NO PB W/ ENC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8347EVVAJD 功能描述:IC MPU PWRQUICC II PRO 672-TBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC83xx 標準包裝:1 系列:MPC85xx 處理器類型:32-位 MPC85xx PowerQUICC III 特點:- 速度:1.2GHz 電壓:1.1V 安裝類型:表面貼裝 封裝/外殼:783-BBGA，F(xiàn)CBGA 供應商設備封裝:783-FCPBGA（29x29） 包裝:托盤
MPC8347EVVAJDB 功能描述:微處理器 - MPU 8349 TBGA NO PB W/ ENC RoHS:否 制造商:Atmel 處理器系列:SAMA5D31 核心:ARM Cortex A5 數據總線寬度:32 bit 最大時鐘頻率:536 MHz 程序存儲器大小:32 KB 數據 RAM 大小:128 KB 接口類型:CAN, Ethernet, LIN, SPI,TWI, UART, USB 工作電源電壓:1.8 V to 3.3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:FBGA-324
MPC8347EVVAJF 功能描述:IC MPU PWRQUICC II PRO 672-TBGA RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微處理器 系列:MPC83xx 標準包裝:1 系列:MPC85xx 處理器類型:32-位 MPC85xx PowerQUICC III 特點:- 速度:1.2GHz 電壓:1.1V 安裝類型:表面貼裝 封裝/外殼:783-BBGA，F(xiàn)CBGA 供應商設備封裝:783-FCPBGA（29x29） 包裝:托盤
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*