- 您現在的位置：買賣IC網 > PDF目錄183240 > MOS6020-223 (COILCRAFT INC) 1 ELEMENT, 22 uH, GENERAL PURPOSE INDUCTOR, SMD PDF資料下載
參數資料
| 型號： | MOS6020-223 |
| 廠商： | COILCRAFT INC |
| 元件分類： | 通用定值電感 |
| 英文描述： | 1 ELEMENT, 22 uH, GENERAL PURPOSE INDUCTOR, SMD |
| 文件頁數： | 1/2頁 |
| 文件大?。?/td> | 65K |
| 代理商： | MOS6020-223 |
Document 267
Specifications subject to change without notice.
Document 267-1 Revised 02/19/03
This lumped-element (SPICE) model data simulates the
frequency-dependent behavior of Coilcraft power induc-
tors within the frequency range shown in the accompa-
nying table for each individual inductor.
The data represents de-embedded measurements, as
described below. Effects due to different customer cir-
cuit board traces, board materials, ground planes or
interactions with other components are not included and
can have a significant effect when comparing the simu-
lation to measurements of the inductors using other
production verification instruments and fixtures.
Lumped Element Modeling Method
Measurements were made using a 50 Ohm impedance
analyzer. Fixture compensation was performed to re-
move fixture effects. No DC bias current was applied in
any of the measurements. The lumped element values
were determined by optimizing the simulation model to
an average of the measurements. This method results in
a model that represents as closely as possible the
typical frequency-dependent behavior of the compo-
nent within the model frequency range.
The equivalent lumped element model schematic is
shown below. Each model should be analyzed only at
the input and output ports. Conclusions based on indi-
vidual lumped element values may be erroneous.
The value of the frequency-dependent variable resistor
RVAR1 is calculated from:
RVAR1 = k1 *
k1 is shown for each value in the accompanying table.
f is the frequency in Hz
RVAR1 is the resistance in Ohms
The value of the frequency-dependent variable resistor
RVAR2 is calculated from:
RVAR2 = k2 *
k2 is shown for each value in the accompanying table.
f is the frequency in Hz
RVAR2 is the resistance in Ohms
The value of the frequency-dependent inductance LVAR is
calculated from:
LVAR = k3 k4 * LOG (k5 * f)
k3, k4, and k5 are shown in the accompanying table.
f is the frequency in Hz
LVAR is the inductance in H
Disclaimer
Coilcraft makes every attempt to provide accurate mea-
surement data and software, representative of our com-
ponents, in a usable format. Coilcraft, however, disclaims
all warrants relating to the use of its data and software,
whether expressed or implied, including without limitation
any implied warranties of merchantability or fitness for a
particular purpose. Coilcraft cannot and will not be liable
for any special, incidental, consequential, indirect or
similar damages occurring with the use of the data and/
or software.
CR1
R2
LVAR
RVAR
RVAR1
RVAR
RVAR2
SPICE Model – MOS6020
相關PDF資料 |
PDF描述 |
|---|---|
| MOS6020-682 | 1 ELEMENT, 6.8 uH, GENERAL PURPOSE INDUCTOR, SMD |
| MP0045/1E1/AM/012 | PUSHBUTTON SWITCH, DPDT, LATCHED, 12VDC, PANEL MOUNT-THREADED |
| MP01036 | 1-PORT SAW RESONATOR, 1000 MHz |
| MP02GN260-16 | 260 A, 1600 V, SILICON, RECTIFIER DIODE |
| MP1210RD/883 | PARALLEL, WORD INPUT LOADING, 1 us SETTLING TIME, 12-BIT DAC, CDIP24 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MOS6020-223ML | 制造商:Coilcraft Inc 功能描述:Power inductor, shielded, 20% tol, SMT, RoHS |
| MOS6020-223MLB | 功能描述:固定電感器 Power Inductor 22 uH 20 % 1.4 A RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| MOS6020-223MLC | 功能描述:固定電感器 Power Inductor 22 uH 20 % 1.4 A RoHS:否 制造商:AVX 電感:10 uH 容差:20 % 最大直流電流:1 A 最大直流電阻:0.075 Ohms 工作溫度范圍:- 40 C to + 85 C 自諧振頻率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接類型:SMD/SMT 封裝 / 箱體:6.6 mm x 4.45 mm |
| MOS6020-223MXB | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMT Power Inductor |
| MOS6020-223MXC | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:SMT Power Inductor |
發布緊急采購，3分鐘左右您將得到回復。