- 您現在的位置：買賣IC網 > PDF目錄377971 > ML4876 (Fairchild Semiconductor Corporation) LCD Backlight Lamp Driver(LCD背光燈驅動器) PDF資料下載
參數資料
| 型號： | ML4876 |
| 廠商： | Fairchild Semiconductor Corporation |
| 英文描述： | LCD Backlight Lamp Driver(LCD背光燈驅動器) |
| 中文描述： | 液晶背光燈驅動器（液晶背光燈驅動器） |
| 文件頁數： | 7/9頁 |
| 文件大?。?/td> | 171K |
| 代理商： | ML4876 |
ML4876
7
FUNCTIONAL DESCRIPTION
The ML4876 consists of a PWM regulator, a lamp driver/
inverter, a linear regulator, a flyback regulator, and
control circuits. This IC, in conjunction with external
components, converts a DC battery voltage into the high
voltage and high frequency ac signal required to start and
drive miniature cold cathode fluorescent lamps. In
addition it generates the DC voltage for the contrast
requirements of LCD screens. A typical application circuit
is shown in Figure 1. Please refer to Application Note 32
for detailed application information beyond what is
presented here.
Note:
Please read the Power Sequencing section below
prior to using the ML4876.
LAMP DRIVER
The lamp driver, sometimes referred to as a lamp inverter,
is comprised of a PWM regulator and a Royer type
inverter circuit to drive the lamp. The PWM regulator, in a
buck configuration, controls the magnitude of the lamp
current to provide the dimming capability. Figure 2 shows
a simplified circuit to more easily illustrate the operation
of the circuit.
Due to the presence of the buck inductor, L1, the circuit
shown in Figure 2 is essentially a current fed parallel
loaded resonant circuit. Lm is the primary inductance of
the output transformer, T1, which tunes with the resonant
capacitor C
R
to set the resonant frequency of the inverter.
The oscillator frequency is always set lower than the
natural resonant frequency to ensure synchronization. The
current source IC models the current through the buck
inductor L1.
Figure 2. Simplified Lamp Driver Circuit
Figure 3. Operating Waveforms of the
Lamp Driver Section
The MOSFETs (Q4 and Q5) are alternately turned on with
a constant 50% duty cycle signal (L GATE1, L GATE2) at
one-half the frequency of the oscillator. In this way each
transistor pulses, or excites, the resonant tank on each
half cycle. The combination of these two signals appear
across the primary winding of the output transformer as a
sinusoidal waveform. This voltage is multiplied by the
step-up turns ratio of the output transformer and impressed
across the lamp.
The output transitions are controlled by feedback through
the L RTD pin by sensing the voltage at the center tap of
the output transformer. Each time this signal reaches the
minimum resonant threshold detection point an internal
clock pulse is generated to keep the system synchronized.
Figure 3 shows some of these representative waveforms at
the important nodes of the circuit.
The PWM regulator is comprised of a MOSFET (U2-A),
inductor L1, and the gate control and drive circuitry as
shown in Figure 1. A signal with a constant pulse width of
150ns is applied to the primary of the 2:1 pulse
transformer T2, rectified by diode D2, and used to charge
the gate capacitance of U2-A, thereby turning it on. The
turn off is controlled by discharging this capacitance
through MOSFET U2-B. The pulse width of the signal on
the gate of U2-B (B OFF) varies according to the
amplitude of the feedback signal on LEA–, which is
proportional to the AC current flowing in the lamp. This
feedback signal is developed by monitoring the current
through resistor R6 in the common source connection of
the inverter MOSFETs (Q4 and Q5). The lamp current, and
therefore brightness, is adjusted by varying the voltage
applied to R7 at the brightness adjust control point.
Increasing this voltage decreases the brightness.
T1
C
OUT
L
C
R
Q4
Q5
Lm
Lm
T1
1:N
I
C
SOURCE OF
U2-A
T1-CNTR-PRI
DRAIN-Q4
L GATE2
DRAIN-Q5
L GATE1
C
T
CLOCK
相關PDF資料 |
PDF描述 |
|---|---|
| ML4877 | LCD Desktop Backlight Lamp Driver(LCD桌面背光燈驅動器) |
| ML4880 | Portable PC/PCMCIA Power Controller(便攜式PC/PCMCIA電源控制器) |
| ML4890 | High Efficiency, Low Ripple Boost Regulator(輸出可調、小波紋升壓穩壓器) |
| ML4894 | Synchronous Buck Controller For DC/DC conversion(用于DC/DC變換的同步補償控制器（5.9V～15V到5V變換）) |
| ML4895 | Synchronous Buck Controller For DC/DC conversion(用于DC/DC變換的同步補償控制器（5.9V～15V到2.5V～4V變換）) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ML4876CR | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Fairchild Semiconductor Corporation 功能描述: |
| ML4876CR/301ER20 UP WAF | 制造商:Fairchild Semiconductor Corporation 功能描述: |
| ML4876CRX | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Fairchild Semiconductor Corporation 功能描述: |
| ML4876ER | 制造商:MICRO-LINEAR 制造商全稱:MICRO-LINEAR 功能描述:LCD Backlight Lamp Driver with Contrast |
| ML4876ER-NL4C0092 | 制造商:Rochester Electronics LLC 功能描述:- Bulk 制造商:Fairchild Semiconductor Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。