參數資料
型號: MK60N256VLQ100
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
封裝: 20 X 20 MM, LQFP-144
文件頁數: 21/76頁
文件大小: 1862K
代理商: MK60N256VLQ100
Table 13. MCG specifications (continued)
Symbol
Description
Min.
Typ.
Max.
Unit
Notes
Dlock
Lock entry frequency tolerance
± 1.49
± 2.98
%
Dunl
Lock exit frequency tolerance
± 4.47
± 5.97
%
tpll_lock
Lock detector detection time
0.15 +
1075(1/
fpll_ref)
ms
1. This parameter is measured with the internal reference (slow clock) being used as a reference to the FLL (FEI clock
mode).
2. These typical values listed are with the slow internal reference clock (FEI) using factory trim and DMX32=0.
3. The resulting system clock frequencies should not exceed their maximum specified values. The DCO frequency deviation
(
Δfdco_t) over voltage and temperature should be considered.
4. These typical values listed are with the slow internal reference clock (FEI) using factory trim and DMX32=1.
5. The resulting clock frequency must not exceed the maximum specified clock frequency of the device.
6. This specification was obtained at TBD frequency.
7. This specification applies to any time the FLL reference source or reference divider is changed, trim value is changed,
DMX32 bit is changed, DRS bits are changed, or changing from FLL disabled (BLPE, BLPI) to FLL enabled (FEI, FEE,
FBE, FBI). If a crystal/resonator is being used as the reference, this specification assumes it is already running.
8. Excludes any oscillator currents that are also consuming power while PLL is in operation.
9. This specification was obtained using a Freescale developed PCB. PLL jitter is dependent on the noise characteristics of
each PCB and results will vary.
10. This specification was obtained at internal frequency of TBD.
11. This specification applies to any time the PLL VCO divider or reference divider is changed, or changing from PLL disabled
(BLPE, BLPI) to PLL enabled (PBE, PEE). If a crystal/resonator is being used as the reference, this specification assumes
it is already running.
6.3.2 Oscillator electrical specifications
This section provides the electrical characteristics of the module.
6.3.2.1 Oscillator DC electrical specifications
Table 14. Oscillator DC electrical specifications
Symbol
Description
Min.
Typ.
Max.
Unit
Notes
VDD
Supply voltage
1.71
3.6
V
IDDOSC
Supply current — low-power mode (HGO=0)
32 kHz
4 MHz
8 MHz
16 MHz
24 MHz
32 MHz
500
200
300
700
1.2
1.5
nA
μA
mA
Table continues on the next page...
Peripheral operating requirements and behaviors
K60 Sub-Family Data Sheet Data Sheet, Rev. 4, 3/2011.
28
Preliminary
Freescale Semiconductor, Inc.
相關PDF資料
PDF描述
MK60X256VLQ100 FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
MK60N512VMD100R FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA144
MK60X256VLQ100R FLASH, 100 MHz, RISC MICROCONTROLLER, PQFP144
MK60N512VMC100 FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA121
MK60N256VMC100 FLASH, 100 MHz, RISC MICROCONTROLLER, PBGA121
相關代理商/技術參數
參數描述
MK60N256VMD100 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Up to 100 MHz ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
MK60N512VLL100 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:K60 Sub-Family Data Sheet
MK60N512VLQ100 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Up to 100 MHz ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
MK60N512VMD100 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:Up to 100 MHz ARM Cortex-M4 core with DSP instructions delivering 1.25 Dhrystone MIPS per MHz
MK60R4F-R52 功能描述:金屬膜電阻器 - 透孔 1/4watt 6.4ohm 1% RoHS:否 制造商:IRC 電阻:63.4 kOhms 容差:1 % 功率額定值:100 mW 電壓額定值:200 V 溫度系數:100 PPM / C 端接類型:Axial 工作溫度范圍: 尺寸:2.3 mm Dia. x 6.4 mm L 封裝:Bulk