參數資料
型號: MGA-81563-TR1
英文描述: 0.1- 6 GHz 3 V, 14 dBm Amplifier
中文描述: 0.1 - 6 GHz的3伏,14 dBm的放大器
文件頁數: 7/12頁
文件大小: 135K
代理商: MGA-81563-TR1
6-202
Although the input terminal of the
MGA-81563 is at ground potential,
it is not a current sink. If the input
is connected to a preceding stage
that has a voltage present, the use
of the DC blocking capacitor (C1)
is required.
C2
C2
C4
C1
L1
RFC
V
d
RF
Output
RF
Input
Figure 15. Schematic Diagram.
DC bias is applied to the MGA-
81563 through the RF Output pin.
An inductor (RFC), or length of
high impedance transmission line
(preferably
λ
/4 at the band
center), is used to isolate the RF
from the DC supply.
The power supply is bypassed to
ground with capacitor C3 to keep
RF off of the DC lines and to
prevent gain dips or peaks in the
response of the amplifier.
An additional bypass capacitor,
C4, may be added to the bias line
near the V
d
connection to elimi-
nate unwanted feedback through
bias lines that could cause oscilla-
tion. C4 will not normally be
needed unless several stages are
cascaded using a common power
supply.
When multiple bypass capacitors
are used, consideration should be
given to potential resonances. It is
important to ensure that the
capacitors when combined with
additional parasitic L’s and C’s on
the circuit board do not form
resonant circuits. The addition of
a small value resistor in the bias
supply line between bypass
capacitors will often “de-Q” the
bias circuit and eliminate the
effect of a resonance.
The value of the DC blocking and
RF bypass capacitors (C1– C3)
should be chosen to provide a
small reactance (typically
<5ohms) at the lowest operating
frequency. The reactance of the
RF choke (RFC) should be high
(e.g., several hundred ohms) at
the lowest frequency of operation.
The MGA-81563’s response at low
frequencies is limited to approxi-
mately 100 MHz by the size of
capacitors integrated on the
MMIC chip.
The input of the MGA-81563 is
partially matched internally to
50
. Without external matching
elements, the input VSWR of the
MGA-81563 is 3.0:1 at 300 MHz
and decreases to 1.5:1 at 6 GHz.
This will be adequate for many
applications. If a better input
VSWR is required, the use of a
series inductor, L1 in the applica-
tions example, (or, alternatively a
length of high impedance trans-
mission line) is all that is needed
to improve the match. The table in
Figure 16 shows suggested values
for L1 for various wireless fre-
quency bands.
Frequency
(GHz)
0.9
1.5
1.9
2.4
4.0
5.8
Figure 16. Values for L1.
Inductor, L1
(nH)
10
6.8
3.9
2.7
0.5
0
These values for L1 take into
account the short length of 50
transmission line between the
inductor and the input pin of the
device.
For applications requiring mini-
mum noise figure (NF
o
), some
improvement over a 50
match is
possible by matching the signal
input to the optimum noise match
impedance,
Γ
o
, as specified in the
“Typical Noise Parameters” table.
For most applications, as shown
in the example circuit, the output
of the MGA-81563 is already
sufficiently well matched to 50
and no additional matching is
needed. The nominal device
output VSWR is
2.2:1 from
300MHz through 6 GHz.
The completed application
amplifier with all components and
SMA connectors is shown in
Figure 17.
IN
OUT
+V
C4
C3
RFC
C2
L1
C1
H
MGA-8-A
Figure 17. Complete Application Circuit.
相關PDF資料
PDF描述
MGA-82563-TR1 0.1-6 GHz 3V, 17 dBm Amplifier
MGB2310TK-X 128 x 64 pixel format, LED or EL Backlight available
MGB27TA-X ULTRA HIGH BRIGHTNESS GREEN LED LAMP
MGB31TA-X ULTRA HIGH BRIGHTNESS GREEN LED LAMP
MGB31TAH ULTRA HIGH BRIGHTNESS GREEN LED LAMP
相關代理商/技術參數
參數描述
MGA-81563-TR1G 功能描述:射頻放大器 3 SV 12.4 dB RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel
MGA-81563-TR2G 功能描述:射頻放大器 3 SV 12.4 dB RoHS:否 制造商:Skyworks Solutions, Inc. 類型:Low Noise Amplifier 工作頻率:2.3 GHz to 2.8 GHz P1dB:18.5 dBm 輸出截獲點:37.5 dBm 功率增益類型:32 dB 噪聲系數:0.85 dB 工作電源電壓:5 V 電源電流:125 mA 測試頻率:2.6 GHz 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 封裝:Reel
MGA82563 制造商:AGILENT 制造商全稱:AGILENT 功能描述:0.1-6 GHz 3V, 17 dBm Amplifier
MGA-82563 制造商:AGILENT 制造商全稱:AGILENT 功能描述:0.1-6 GHz 3V, 17 dBm Amplifier
MGA-82563-1HAG 制造商:Avago Technologies 功能描述:3V MINIATURE 17 DBM POWER AMP WITH HAA TAPE LEAD FREE - Bulk