For a unity gain buffer, VIN
參數資料
型號： MCP6H04-E/ST
廠商： Microchip Technology
文件頁數： 10/46頁
文件大小： 0K
描述： IC OPAMP QUAD16V 1.2MHZ 14TSSOP
標準包裝： 96
放大器類型： 通用
電路數： 4
輸出類型： 滿擺幅
轉換速率： 0.8 V/µs
增益帶寬積： 1.2MHz
電流 - 輸入偏壓： 10pA
電壓 - 輸入偏移： 700µV
電流 - 電源： 135µA
電流 - 輸出 / 通道： 50mA
電壓 - 電源，單路/雙路(±)： 3.5 V ~ 16 V，±1.75 V ~ 8 V
工作溫度： -40°C ~ 125°C
安裝類型： 表面貼裝
封裝/外殼： 14-TSSOP（0.173"，4.40mm 寬）
供應商設備封裝： 14-TSSOP
包裝： 管件
MCP6H01/2/4
DS22243D-page 18
2010-2011 Microchip Technology Inc.
For a unity gain buffer, VIN must be maintained below
VDD – 2.3V for correct operation.
4.2
Rail-to-Rail Output
The output voltage range of the MCP6H01/2/4 op amps
is 0.020V (typical) and 14.980V (typical) when
RL =10k is connected to VDD/2 and VDD =15V.
Refer
to
Figures 2-24
through
for
more
information.
4.3
Capacitive Loads
Driving large capacitive loads can cause stability
problems for voltage feedback op amps. As the load
capacitance increases, the feedback loop’s phase
margin decreases and the closed-loop bandwidth is
reduced. This produces gain peaking in the frequency
response, with overshoot and ringing in the step
response. While a unity-gain buffer (G = +1V/V) is the
most sensitive to capacitive loads, all gains show the
same general behavior.
When driving large capacitive loads with these op
amps (e.g., > 100 pF when G = + 1V/V), a small series
resistor at the output (RISO in Figure 4-4) improves the
feedback loop’s phase margin (stability) by making the
output load resistive at higher frequencies. The
bandwidth will generally be lower than the bandwidth
with no capacitance load.
FIGURE 4-4:
Output Resistor, RISO
Stabilizes Large Capacitive Loads.
Figure 4-5 gives the recommended RISO values for
different capacitive loads and gains. The x-axis is the
normalized load capacitance (CL/GN), where GN is the
circuit’s noise gain. For non-inverting gains, GN and the
Signal Gain are equal. For inverting gains, GN is
1 + |Signal Gain| (e.g., -1V/V gives GN = +2V/V).
After selecting RISO for your circuit, double check the
resulting
frequency
response
peaking
and
step
response overshoot. Modify RISO’s value until the
response
is
reasonable.
Bench
evaluation
and
simulations with the MCP6H01/2/4 SPICE macro
model are helpful.
FIGURE 4-5:
Recommended RISO Values
for Capacitive Loads.
4.4
Supply Bypass
With this family of operational amplifiers, the power
supply pin (VDD for single supply) should have a local
bypass capacitor (i.e., 0.01 F to 0.1 F) within 2 mm
for good high-frequency performance. It can use a bulk
capacitor (i.e., 1 F or larger) within 100 mm to provide
large, slow currents. This bulk capacitor can be shared
with other analog parts.
4.5
Unused Op Amps
An unused op amp in a quad package (MCP6H04)
should be configured as shown in Figure 4-6. These
circuits prevent the output from toggling and causing
crosstalk. Circuit A sets the op amp at its minimum
noise gain. The resistor divider produces any desired
reference voltage within the output voltage range of the
op amp, and the op amp buffers that reference voltage.
Circuit B uses the minimum number of components
and operates as a comparator, but it may draw more
current.
FIGURE 4-6:
Unused Op Amps.
VIN
RISO
VOUT
CL
–
+
MCP6H0X
1
10
100
1000
1.E-11
1.E-10
1.E-09
1.E-08
1.E-07
1.E-06
Normalized Load Capacitance; CL/GN (F)
Re
c
o
m
en
d
ed
R
IS
O
(
)
GN:
1 V/V
2 V/V
5 V/V
VDD = 16V
RL = 10 k
10p
100p
1n
10n
0.1
1
1k
VDD
R1
R2
VDD
VREF
V
REF
V
DD
R
2
R
1
R
2
+
--------------------
=
MCP6H04 (A)
MCP6H04 (B)
相關PDF資料
PDF描述
LT1122CS8 IC OP-AMP JFET FASTSETTLNG 8SOIC
SSQ-112-02-S-S CONN RCPT .100" 12POS SNGL GOLD
2-87230-0 CONN HEADER 40POS DUAL R/A GOLD
4-641209-7 17P MTA156 HDR ASSY FL ST LF
9-146294-0 CONN HEADER BREAKAWAY 40POS .100
相關代理商/技術參數
參數描述
MCP6H04T-E/SL 功能描述:運算放大器 - 運放 1.2 MHz, 16V Op Amps SOIC14 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
MCP6H04T-E/ST 功能描述:運算放大器 - 運放 1.2 MHz, 16V Op Amps TSSOP14 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
MCP6H71-E/SN 功能描述:運算放大器 - 運放 16bit deltasigma ADC dual channel 15sps RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel
MCP6H71-E/SN 制造商:Microchip Technology Inc 功能描述:Single 12V 2MHz Opamp 8 SOIC 制造商:Microchip Technology Inc 功能描述:Single, 12V, 2MHz Opamp 8 SOIC 3.90mm(.1
MCP6H71T-E/MNY 制造商:Microchip Technology Inc 功能描述:SINGLE, 12V, 2MHZ OPAMP - Tape and Reel 制造商:Microchip Technology Inc 功能描述:IC OPAMP GP 2.7MHZ RRO 8TDFN
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*