- 您現在的位置：買賣IC網 > PDF目錄5960 > MCP6H04-E/SL (Microchip Technology)IC OPAMP QUAD16V 1.2MHZ 14SOIC PDF資料下載
參數資料
| 型號： | MCP6H04-E/SL |
| 廠商： | Microchip Technology |
| 文件頁數： | 11/46頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP QUAD16V 1.2MHZ 14SOIC |
| 標準包裝： | 57 |
| 放大器類型： | 通用 |
| 電路數： | 4 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 0.8 V/µs |
| 增益帶寬積： | 1.2MHz |
| 電流 - 輸入偏壓： | 10pA |
| 電壓 - 輸入偏移： | 700µV |
| 電流 - 電源： | 135µA |
| 電流 - 輸出 / 通道： | 50mA |
| 電壓 - 電源，單路/雙路(±)： | 3.5 V ~ 16 V，±1.75 V ~ 8 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 14-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 14-SOIC |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁
2010-2011 Microchip Technology Inc.
DS22243D-page 19
MCP6H01/2/4
4.6
PCB Surface Leakage
In applications where low input bias current is critical,
PCB surface leakage effects need to be considered.
Surface leakage is caused by humidity, dust or other
contamination on the board. Under low-humidity condi-
tions, a typical resistance between nearby traces is
1012
. A 15V difference would cause 15 pA of current
to flow; which is greater than the MCP6H01/2/4 family’s
bias current at +25°C (10 pA, typical).
The easiest way to reduce surface leakage is to use a
guard ring around sensitive pins (or traces). The guard
ring is biased at the same voltage as the sensitive pin.
An example of this type of layout is shown in
FIGURE 4-7:
Example Guard Ring Layout
for Inverting Gain.
1.
Non-inverting Gain and Unity-Gain Buffer:
a.
Connect the non-inverting pin (VIN+) to the
input with a wire that does not touch the
PCB surface.
b.
Connect the guard ring to the inverting input
pin (VIN–). This biases the guard ring to the
common mode input voltage.
2.
Inverting Gain and Trans-impedance Gain
Amplifiers (convert current to voltage, such as
photo detectors):
a.
Connect the guard ring to the non-inverting
input pin (VIN+). This biases the guard ring
to the same reference voltage as the op
amp (e.g., VDD/2 or ground).
b.
Connect the inverting pin (VIN–) to the input
with a wire that does not touch the PCB
surface.
4.7
Application Circuits
4.7.1
DIFFERENCE AMPLIFIER
The MCP6H01/2/4 op amps can be used in current
sensing applications. Figure 4-8 shows a resistor
(RSEN) that converts the sensor current (ISEN) to
voltage, as well as a difference amplifier that amplifies
the voltage across the resistor while rejecting common
mode noise. R1 and R2 must be well matched to obtain
an
acceptable
Common
Mode
Rejection
Ratio
(CMRR). Moreover, RSEN should be much smaller than
R1 and R2 in order to minimize the resistive loading of
the source.
To ensure proper operation, the op amp common mode
input voltage must be kept within the allowed range.
The reference voltage (VREF) is supplied by a
low-impedance source. In single-supply applications,
VREF is typically VDD/2.
.
FIGURE 4-8:
High Side Current Sensing
Using Difference Amplifier.
Guard Ring
VIN–VIN+
VSS
R1
VOUT
R2
R1
RSEN
ISEN
RSEN << R1, R2
V
OUT
V
1
V
2
–
R
2
R
1
------
V
REF
+
=
VREF
R2
VDD
MCP6H01
相關PDF資料 |
PDF描述 |
|---|---|
| LT6203CDD#TRPBF | IC OPAMP R-R IN/OUT DUAL LP 8DFN |
| D-406-0001 | CONN BUTT SPLICE 22-18AWG RED |
| 321280 | CONN SPLICE BUTT 12-14 AWG SOLIS |
| 8-320562-2 | CONN SPLICE BUTT 16-14AWG PIDG |
| MCP6274-E/SL | IC OPAMP 2.0V QUAD R-R 14SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP6H04T-E/SL | 功能描述:運算放大器 - 運放 1.2 MHz, 16V Op Amps SOIC14 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MCP6H04T-E/ST | 功能描述:運算放大器 - 運放 1.2 MHz, 16V Op Amps TSSOP14 RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MCP6H71-E/SN | 功能描述:運算放大器 - 運放 16bit deltasigma ADC dual channel 15sps RoHS:否 制造商:STMicroelectronics 通道數量:4 共模抑制比（最小值）:63 dB 輸入補償電壓:1 mV 輸入偏流（最大值）:10 pA 工作電源電壓:2.7 V to 5.5 V 安裝風格:SMD/SMT 封裝 / 箱體:QFN-16 轉換速度:0.89 V/us 關閉:No 輸出電流:55 mA 最大工作溫度:+ 125 C 封裝:Reel |
| MCP6H71-E/SN | 制造商:Microchip Technology Inc 功能描述:Single 12V 2MHz Opamp 8 SOIC 制造商:Microchip Technology Inc 功能描述:Single, 12V, 2MHz Opamp 8 SOIC 3.90mm(.1 |
| MCP6H71T-E/MNY | 制造商:Microchip Technology Inc 功能描述:SINGLE, 12V, 2MHZ OPAMP - Tape and Reel 制造商:Microchip Technology Inc 功能描述:IC OPAMP GP 2.7MHZ RRO 8TDFN |
發布緊急采購，3分鐘左右您將得到回復。