- 您現在的位置：買賣IC網 > PDF目錄2013 > MCP4728T-E/UN (Microchip Technology)IC DAC 12BIT W/I2C 10-MSOP PDF資料下載
參數資料
| 型號： | MCP4728T-E/UN |
| 廠商： | Microchip Technology |
| 文件頁數： | 15/33頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC 12BIT W/I2C 10-MSOP |
| 視頻文件： | MCP4728 Evaluation Board Demo |
| 標準包裝： | 2,500 |
| 設置時間： | 6µs |
| 位數： | 12 |
| 數據接口： | EEPROM，I²C，串行 |
| 轉換器數目： | 4 |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-MSOP |
| 包裝： | 帶卷 (TR) |
| 輸出數目和類型： | 4 電壓，單極 |
| 采樣率（每秒）： | * |
| 配用： | MCP4728EV-ND - BOARD EVAL 12BIT 4CH DAC MCP4728 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
MCP4728
DS22187E-page 22
2010 Microchip Technology Inc.
3.3
Serial Data Pin (SDA)
SDA is the serial data pin of the I2C interface. The SDA
pin is used to write or read the DAC register and
EEPROM data. Except for Start and Stop conditions,
the data on the SDA pin must be stable during the high
duration of the clock pulse. The High or Low state of the
SDA pin can only change when the clock signal on the
SCL pin is Low.
The SDA pin is an open-drain N-channel driver.
Therefore, it needs a pull-up resistor from the VDD line
to the SDA pin.
Refer
to
Interface communication.
3.4
LDAC Pin
This pin can be driven by an external control device
such as an MCU I/O pin. This pin is used to:
a)
transfer the contents of the input registers to
their corresponding DAC output registers and
b)
select a device of interest when reading or writ-
ing I2C address bits.
For more details on reading and writing the I2C address
bits, see
When the logic status of the LDAC pin changes from
“High” to “Low”, the contents of all input registers
(Channels A – D) are transferred to their corresponding
output registers, and all analog voltage outputs are
updated simultaneously.
If this pin is permanently tied to “Low”, the content of
the input register is transferred to its output register
(VOUT) immediately at the last input data byte’s
acknowledge pulse.
The user can also use the UDAC bit instead. However,
the UDAC bit updates a selected channel only. See
Section 4.8 “Output Voltage Update” for more
information on the LDAC pin and UDAC bit functions.
3.5
RDY/BSY Status Indicator Pin
This pin is a status indicator of EEPROM programming
activity. This pin is “High” when the EEPROM has no
programming activity, and “Low” when the EEPROM is
in programming mode. It goes “High” when the
EEPROM program is completed.
The RDY/BSY pin is an open-drain N-channel driver.
Therefore, it needs a pull-up resistor (about 100 k
Ω)
from the VDD line to the RDY/BSY pin. Let this pin float
if it is not used.
3.6
Analog Output Voltage Pins
(VOUT A, VOUT B, VOUT C, VOUT D)
The device has four analog voltage output (VOUT) pins.
Each output is driven by its own output buffer with a
gain of 1 or 2, depending on the gain and VREF
selection bit settings. In Normal mode, the DC
impedance of the output pin is about 1
Ω. In
Power-Down mode, the output pin is internally
connected to 1 k
Ω, 100 kΩ, or 500 kΩ, depending on
the Power-Down selection bit settings.
The VOUT pin can drive up to 1000 pF of capacitive
load. It is recommended to use a load with RL greater
than 5 k
Ω.
相關PDF資料 |
PDF描述 |
|---|---|
| MCP4822T-E/MS | IC DAC 12BIT DUAL W/SPI 8MSOP |
| MCP4912T-E/SL | DAC 10BIT DUAL SPI 14SOIC |
| MCP4921-E/MC | DAC 12BIT SGL W/SPI 8DFN |
| MCP79402T-I/MNY | IC RTCC 64BIT SRAM I2C 8TDFN |
| MCP7940MT-I/ST | IC RTCC I2C 64B SRAM 8-TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP4729-E/SS | 功能描述:數模轉換器- DAC Octal 12-bit NV DAC with I2C interface RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MCP47A1T-A0E/LT | 功能描述:數模轉換器- DAC 6-Bit Volatile DAC with Command Code RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MCP47A1T-A1E/LT | 功能描述:數模轉換器- DAC 6-Bit Volatile DAC with Command Code RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MCP47DA1T-A0E/OT | 功能描述:數模轉換器- DAC 6-bit windowed DAC voltage margining RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MCP47DA1T-A1E/OT | 功能描述:數模轉換器- DAC 6-bit windowed DAC voltage margining RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。