參數資料
型號： MCP42100
廠商： Microchip Technology Inc.
元件分類： 數字電位計
英文描述： Single/Dual Digital Potentiometer with SPI⑩ Interface
中文描述： 單/雙數字電位器接口與SPI⑩
文件頁數： 20/33頁
文件大?。?/td> 682K
代理商： MCP42100
MCP41XXX/42XXX
DS11195C-page 20
2003 Microchip Technology Inc.
FIGURE 5-4:
Daisy-Chain Configuration.
Microcontroller
SO
CS
SCK
SI
SO
CS
SCK
SI
CS
SCK
SI
CS
SCK
SO
Device 1
Device 2
Device 3*
If you want to load the following
command/data into each part
in the chain.
Device 1
XX10XX11
Device 2
XX01XX10
Device 3
XX10XX00
EXAMPLE:
Start by setting CS low and
clocking in the command and
data that will end up in Device
3 (16 clocks).
c
After 16 clocks, Device 2 and
Device 3 will both have all
zeros clocked in from the
previous part’s shift register.
Clock-In the command and
data for Device 2 (16 more
clocks). The data that was pre-
viously loaded gets shifted to
the next device on the chain.
d
After 32 clocks, Device 2 has
the data previously loaded
into Device 1 and Device 3
gets 16 more zeros.
Clock-In the data for Device 1
(16 more clocks). The data that
was previously loaded into
Device 1 gets shifted into
Device 2 and Device 3 contains
the first byte loaded. Raise the
CS line to execute the com-
mands for all 3 devices at the
same time.
e
After 48 clocks, all 3 devices
have the proper command/
data loaded into their shift
registers.
*
Last device on a daisy-chain may be a single channel MCP41XXX device.
11001100
11110000
10101010
Device 1
XX10XX00
Device 2
00000000
Device 3
00000000
10101010
00000000
00000000
Device 1
XX01XX10
Device 2
XX10XX00
Device 3
00000000
11110000
10101010
00000000
Device 1
XX10XX11
Device 2
XX01XX10
Device 3
XX10XX00
11001100
11110000
10101010
相關PDF資料
PDF描述
MCP42100T Single/Dual Digital Potentiometer with SPI⑩ Interface
MCP41010 Single/Dual Digital Potentiometer with SPI⑩ Interface
MCP41010T CABLE ASSEMBLY; LEAD-FREE SOLDER; SMB PLUG RIGHT ANGLE TO; SMB JACK BULKHEAD; 50 OHM, RG400/U COAX, DOUBLE SHIELDED;
MCP41050 400000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN
MCP41050T 400000 SYSTEM GATE 2.5 VOLT FPGA - NOT RECOMMENDED for NEW DESIGN
相關代理商/技術參數
參數描述
MCP42100-E/P 功能描述:數字電位計 IC 256 Step SPI 100kOhm RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MCP42100-E/SL 功能描述:數字電位計 IC 256 Step SPI 100kOhm RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MCP42100-E/ST 功能描述:數字電位計 IC 256 Step SPI 100kOhm RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MCP42100-I/P 功能描述:數字電位計 IC 256 Step SPI 100kOhm RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MCP42100-I/P 制造商:Microchip Technology Inc 功能描述:Digital Potentiometer (Pots) IC
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*