- 您現在的位置：買賣IC網 > PDF目錄4598 > MCP2036-I/MG (Microchip Technology)IC KEYLESS ENTRY AFE 16-QFN PDF資料下載
參數資料
| 型號： | MCP2036-I/MG |
| 廠商： | Microchip Technology |
| 文件頁數： | 23/30頁 |
| 文件大小： | 0K |
| 描述： | IC KEYLESS ENTRY AFE 16-QFN |
| 標準包裝： | 120 |
| 類型： | 傳感器接口 |
| 應用： | 模擬 I/O |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 16-QFN-EP（3x3） |
| 包裝： | 管件 |
| 產品目錄頁面： | 684 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁當前第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
2009 Microchip Technology Inc.
DS22186B-page 3
MCP2036
FIGURE 1-2:
MCP2036 Typical Application
The coil voltages are then multiplexed into the
Synchronous Detector section by the LBTN/LREF
multiplexer. This allows the microcontroller to select
which signal is sampled by the detector. The detector
converts the coil voltages into a DC level using a
frequency mixer, amplifier, and filter.
The mixer is composed of two switches driven by the
clock present on the CLK signal input. The switches
toggle the amplifier/filter between an inverting and
non-inverting topology, at a rate equal to the clock input
frequency. This inverts and amplifies the negative side
of the signal, while amplifying the positive side. The
result is a pulsed DC signal with a peak voltage,
proportional to the amplitude of the AC coil voltage.
The gain of the detector is set by two pairs of resistors;
one pair are the internal fixed series resistors between
the frequency mixer and the amplifier. The second
resistor pair are the two external gain set resistors
(RGAIN). The two capacitors (CFILTER) in parallel with
the external gain setting resistors form a low pass filter
which converts the pulsed DC output signal into a
smooth DC voltage which is proportional to the AC
sensor voltage input. The output of the system is
present on the VDETOUT pin, which drives the
microcontroller’s ADC input for conversion into a digital
value.
The virtual ground reference for the detector/amplifier
is generated by a second internal op amp which
produces a virtual ground equal to the supply
voltage. The virtual ground is available externally at the
VREF output and used internally throughout the
detector circuit, allowing single supply operation. A
small external capacitance is required to stabilize this
output and limit noise.
MCP2036
LREF
LBTN
LREF
DRVOUT
10
Ω
10nF
REFSEL
10nF
I/O
0
1
2
3
0
1
3
2
CD4052
Key Coils
PIC Microcontroller
CS
I/O
VDET-
VDETOUT
VDET+
VREF
CLK
DRVIN
PWM
ADC
CFILTER
RGAIN
CRGND
RIN
CIN
RADC
CADC
相關PDF資料 |
PDF描述 |
|---|---|
| LFXP3C-3TN100I | IC FPGA 3.1KLUTS 62I/O 100-TQFP |
| LFEC3E-4QN208C | IC FPGA 3.1KLUTS 145I/O 208-PQFP |
| LFEC3E-3QN208I | IC FPGA 3KLUTS 208PQFP |
| ACB34DHBD | CONN EDGECARD 68POS R/A .050 DIP |
| AMM24DSEI-S13 | CONN EDGECARD 48POS .156 EXTEND |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP2036T-I/MG | 功能描述:電容觸摸傳感器 Inductive Sensor AFE RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍: |
| MCP2036T-I/ML | 功能描述:電容觸摸傳感器 Inductive Sensor Ana Front End RoHS:否 制造商:Microchip Technology 電源電壓: 通道數量: 封裝 / 箱體: 尺寸: 溫度范圍: |
| MCP2036T-I/SL | 功能描述:電信線路管理 IC Inductive Sensor AFE RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| MCP2050-330E/MQ | 功能描述:LIN 收發器 LIN Transceiver + 3.3V LDO + WWDT RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
| MCP2050-330E/SL | 功能描述:LIN 收發器 LIN Transceiver + 3.3V LDO + WWDT RoHS:否 制造商:NXP Semiconductors 工作電源電壓: 電源電流: 最大工作溫度: 封裝 / 箱體:SO-8 |
發布緊急采購，3分鐘左右您將得到回復。