- 您現在的位置：買賣IC網 > PDF目錄296502 > MCP111T-475LB (Microchip Technology Inc.) Micropower Voltage Detector PDF資料下載
參數資料
| 型號： | MCP111T-475LB |
| 廠商： | Microchip Technology Inc. |
| 英文描述： | Micropower Voltage Detector |
| 中文描述： | 微功耗電壓檢測器 |
| 文件頁數： | 3/22頁 |
| 文件大?。?/td> | 332K |
| 代理商： | MCP111T-475LB |
第1頁第2頁當前第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁
2004 Microchip Technology Inc.
DS21889B-page 11
MCP111/112
4.0
APPLICATION INFORMATION
For many of today’s microcontroller applications, care
must be taken to prevent low-power conditions that can
cause many different system problems. The most
common causes are brown-out conditions, where the
system supply drops below the operating level momen-
tarily. The second most common cause is when a slowly
decaying power supply causes the microcontroller to
begin executing instructions without sufficient voltage to
sustain SRAM, thus producing indeterminate results.
Figure 4-1 shows a typical application circuit.
FIGURE 4-1:
Typical Application Circuit.
4.1
V
TRIP Operation
The voltage trip point (V
TRIP) is determined on the falling
edge of V
DD. The actual voltage trip point (VTRIPAC) will
be between the minimum trip point (V
TRIPMIN) and the
maximum trip point (V
TRIPMAX). There is a hysteresis on
this trip point to remove any “jitter” that would occur on
the V
OUT pin when the device VDD is at the trip point.
Figure 4-2 shows the state of the V
OUT pin as deter-
mined by the V
DD voltage. The VTRIP specification is for
falling V
DD voltages. When the VDD voltage is rising, the
V
OUT pin will not be driven high until VDD is at VTRIP +
V
HYS.
FIGURE 4-2:
VOUT Operation as Determined by the VTRIP and VHYS.
2
MCP11X
VDD
VOUT
MCLR
(Reset Input)
VSS
GND
PICmicro
Microcontroller
3
1
RPU
Note 1: RPU may be required with the MCP111
due to the open-drain output. Resistor
RPU is not required with the MCP112.
0.1
F
VDD
VTRIPMAX
VTRIPMIN
VTRIPAC
VTRIPAC + VHYSAC
VOUT
1V
< 1 V is outside the
device specifications
相關PDF資料 |
PDF描述 |
|---|---|
| MCP111T-475TT | Micropower Voltage Detector |
| MCP112 | Micropower Voltage Detector |
| MCP112-300 | Micropower Voltage Detector |
| MCP1603-330I/MC | 0.5 A SWITCHING REGULATOR, 2800 kHz SWITCHING FREQ-MAX, PDSO8 |
| MCP1603-ADJI/MC | 0.5 A SWITCHING REGULATOR, 2800 kHz SWITCHING FREQ-MAX, PDSO8 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MCP111T-475TT | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Micropower Voltage Detector |
| MCP112 | 制造商:MICROCHIP 制造商全稱:Microchip Technology 功能描述:Micropower Voltage Detector |
| MCP112-195I/MB | 制造商:Microchip Technology Inc 功能描述:VOLT SUPERVISOR DETECT 1.9V 4P - Rail/Tube |
| MCP112-195I/TO | 功能描述:監控電路 1uA Sup P-P Act Low RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MCP112-240E/MB | 制造商:Microchip Technology Inc 功能描述:VOLT SUPERVISOR DETECT 2.32V 4 - Rail/Tube |
發布緊急采購，3分鐘左右您將得到回復。