![](http://datasheet.mmic.net.cn/120000/MC9S08FL8CLC_datasheet_3559632/MC9S08FL8CLC_1.png)
Freescale Semiconductor
Data Sheet: Technical Data
Document Number: MC9S08FL16
Rev. 3, 11/2010
Freescale Semiconductor, Inc., 2009-2010. All rights reserved.
This document contains information on a product under development. Freescale reserves the
right to change or discontinue this product without notice.
MC9S08FL16
32-Pin SDIP
1376-02
32-Pin LQFP
873A-03
Features:
8-Bit S08 Central Processor Unit (CPU)
Up to 20 MHz CPU at 4.5 V to 5.5 V across
temperature range of –40 °C to 85 °C
HC08 instruction set with added BGND instruction
Support for up to 32 interrupt/reset sources
On-Chip Memory
Up to 16 KB flash read/program/erase over full
operating voltage and temperature
Up to 1024-byte random-access memory (RAM)
Security circuitry to prevent unauthorized access
to RAM and flash contents
Power-Saving Modes
Two low power stop modes; reduced power wait
mode
Allows clocks to remain enabled to specific
peripherals in stop3 mode
Clock Source Options
Oscillator (XOSC) — Loop-control Pierce
oscillator; crystal or ceramic resonator range of
31.25 kHz to 39.0625 kHz or 1 MHz to 16 MHz
Internal Clock Source (ICS) — Internal clock
source module containing a
frequency-locked-loop (FLL) controlled by internal
or external reference; precision trimming of
internal reference allows 0.2% resolution and 2%
deviation over temperature and voltage; supports
bus frequencies up to 10 MHz
System Protection
Watchdog computer operating properly (COP)
reset with option to run from dedicated 1 kHz
internal clock source or bus clock
Low-voltage detectionwith reset or interrupt;
selectable trip points
Illegal opcode detection with reset
Illegal address detection with reset
Flash block protection
Development Support
Single-wire background debug interface
Breakpoint capability to allow single breakpoint
setting during in-circuit debugging (plus two more
breakpoints).
On-chip in-circuit emulator (ICE) debug module
containing two comparators and nine trigger
modes.
Peripherals
IPC — Interrupt priority controller to provide
hardware based nested interrupt mechanism
ADC — 12-channel, 8-bit resolution; 2.5
s
conversion time; automatic compare function;
1.7 mV/
C temperature sensor; internal bandgap
reference channel; operation in stop; optional
hardware trigger; fully functional from 4.5 V to
5.5 V
TPM — One 4-channel and one 2-channel
timer/pulse-width modulators (TPM) modules;
selectable input capture, output compare, or
buffered edge- or center-aligned PWM on each
channel
MTIM16 — One 16-bit modulo timer with optional
prescaler
SCI — One serial communications interface
module with optional 13-bit break; LIN extensions
Input/Output
30 GPIOs including 1 output-only pin and 1
input-only pin
Package Options
32-pin SDIP
32-pin LQFP
Document Number: MC9S08FL16
Rev. 3, 11/2010
MC9S08FL16 Series
Covers: MC9S08FL16 and
MC9S08FL8