參數資料
型號: MC68HC705F4FB
廠商: FREESCALE SEMICONDUCTOR INC
元件分類: 微控制器/微處理器
英文描述: 8-BIT, OTPROM, 1.789 MHz, MICROCONTROLLER, PQFP44
封裝: PLASTIC, QFP-44
文件頁數: 107/130頁
文件大小: 10504K
代理商: MC68HC705F4FB
8-4
MC68HC05F4
RESETS AND INTERRUPTS
8
8.2.1
Interrupt priorities
Each potential interrupt source is assigned a priority which means that if more than one interrupt
is pending at the same time, the processor will service the one with the highest priority rst. For
example, if both an external interrupt and a timer interrupt are pending after an instruction
execution, the external interrupt is serviced rst.
8.2.2
Non-maskable software interrupt (SWI)
The software interrupt (SWI) is an executable instruction and a nonmaskable interrupt: it is
executed regardless of the state of the I-bit in the CCR. If the I-bit is zero (interrupts enabled), SWI
is executed after interrupts that were pending when the SWI was fetched, but before interrupts
generated after the SWI was fetched. The SWI interrupt service routine address is specied by
the contents of memory locations $3FFC and $3FFD.
8.2.3
Maskable hardware interrupts
If the interrupt mask bit (I-bit) of the CCR is set, all maskable interrupts (internal and external) are
masked. Clearing the I-bit allows interrupt processing to occur. IRQ is software selectable as
either edge or edge-and-level sensitive (bit 3 of the system option register).
Note:
The internal interrupt latch is cleared in the rst part of the interrupt service routine;
therefore, one external interrupt pulse could be latched and serviced as soon as the
I-bit is cleared.
8.2.3.1
Real time and core timer (CTIMER) interrupts
There are two different core timer interrupt ags that cause a CTIMER interrupt whenever an
interrupt is enabled and its ag becomes set, namely RTIF and CTOF. The interrupt ags and
enable bits are located in the CTIMER control and status register (CTCSR). These interrupts will
vector to the same interrupt service routine, whose start address is contained in memory locations
$3FF8 and $3FF9 (see Section 5.2.1 and Figure 5-1).
To make use of the real time interrupt the RTIE bit must rst be set. The RTIF bit will then be set
after the specied number of counts.
To make use of the core timer overow interrupt, the CTOFE bit must rst be set. The CTOF bit
will then be set when the core timer counter register overows from $FF to $00.
TPG
74
05F4Book Page 4 Tuesday, August 5, 1997 1:10 pm
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
..
.
相關PDF資料
PDF描述
MC68HC05F4FB 8-BIT, MROM, 1.789 MHz, MICROCONTROLLER, PQFP44
MC68HC05F4CDW 8-BIT, MROM, 1.789 MHz, MICROCONTROLLER, PDSO28
MC68HC705G4 8-BIT, OTPROM, 1 MHz, MICROCONTROLLER, PQFP80
MC68HC05G3 8-BIT, OTPROM, 2 MHz, MICROCONTROLLER, PQFP80
MC68HC705J5ACJP 8-BIT, OTPROM, 2.1 MHz, MICROCONTROLLER, PDIP16
相關代理商/技術參數
參數描述
MC68HC705G1B 制造商:Rochester Electronics LLC 功能描述:- Bulk
MC68HC705J1A 制造商:Freescale Semiconductor 功能描述:
MC68HC705J1ACDW 功能描述:IC MCU 4MHZ 1.2K OTP 20-SOIC RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:HC05 其它有關文件:STM32F101T8 View All Specifications 特色產品:STM32 32-bit Cortex MCUs 標準包裝:490 系列:STM32 F1 核心處理器:ARM? Cortex?-M3 芯體尺寸:32-位 速度:36MHz 連通性:I²C,IrDA,LIN,SPI,UART/USART 外圍設備:DMA,PDR,POR,PVD,PWM,溫度傳感器,WDT 輸入/輸出數:26 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):2 V ~ 3.6 V 數據轉換器:A/D 10x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:36-VFQFN,36-VFQFPN 包裝:托盤 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名稱:497-9032STM32F101T8U6-ND
MC68HC705J1ACP 功能描述:IC MCU 4MHZ 1.2K OTP 20-DIP RoHS:否 類別:集成電路 (IC) >> 嵌入式 - 微控制器, 系列:HC05 其它有關文件:STM32F101T8 View All Specifications 特色產品:STM32 32-bit Cortex MCUs 標準包裝:490 系列:STM32 F1 核心處理器:ARM? Cortex?-M3 芯體尺寸:32-位 速度:36MHz 連通性:I²C,IrDA,LIN,SPI,UART/USART 外圍設備:DMA,PDR,POR,PVD,PWM,溫度傳感器,WDT 輸入/輸出數:26 程序存儲器容量:64KB(64K x 8) 程序存儲器類型:閃存 EEPROM 大小:- RAM 容量:10K x 8 電壓 - 電源 (Vcc/Vdd):2 V ~ 3.6 V 數據轉換器:A/D 10x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:36-VFQFN,36-VFQFPN 包裝:托盤 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名稱:497-9032STM32F101T8U6-ND
MC68HC705J1ACPE 功能描述:8位微控制器 -MCU HCO5 CORE+1.2K RAM + EPR RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT