Operating Modes and On-Chip Memory
Data Sheet
M68HC11E Family — Rev. 5
34
Operating Modes and On-Chip Memory
For More Information On This Product,
Go to: www.freescale.com
MOTOROLA
The expansion bus is made up of ports B and C, and control signals AS (address
strobe) and R/W (read/write). R/W and AS allow the low-order address and the
8-bit data bus to be multiplexed on the same pins. During the first half of each bus
cycle address information is present. During the second half of each bus cycle the
pins become the bidirectional data bus. AS is an active-high latch enable signal for
an external address latch. Address information is allowed through the transparent
latch while AS is high and is latched when AS drives low.
The address, R/W, and AS signals are active and valid for all bus cycles, including
accesses to internal memory locations. The E clock is used to enable external
devices to drive data onto the internal data bus during the second half of a read bus
cycle (E clock high). R/W controls the direction of data transfers. R/W drives low
when data is being written to the internal data bus. R/W will remain low during
consecutive data bus write cycles, such as when a double-byte store occurs.
Refer to
Figure 2-1
.
NOTE:
The write enable signal for an external memory is the NAND of the E clock and the
inverted R/W signal.
Figure 2-1. Address/Data Demultiplexing
2.2.3 Test Mode
Test mode, a variation of the expanded mode, is primarily used during Motorola’s
internal production testing; however, it is accessible for programming the
HC373
D1
MCU
ADDR13
ADDR12
ADDR11
ADDR10
ADDR9
ADDR8
ADDR14
ADDR5
ADDR4
ADDR3
ADDR2
ADDR1
ADDR0
ADDR6
DATA5
DATA4
DATA3
DATA2
DATA1
DATA0
DATA6
D2
D3
D4
D5
D6
D7
D8
LE
Q3
Q4
Q5
Q6
Q7
Q8
OE
Q2
PC5
PC4
PC3
PC2
PC1
PC0
AS
PC6
PB5
PB4
PB3
PB2
PB1
PB0
PB6
R/W
E
WE
OE
F
Freescale Semiconductor, Inc.
n
.