參數資料
型號： MC1H3
廠商： Microchip Technology Inc.
英文描述： High Voltage Power Module Users Guide
中文描述： 高壓電源模塊用戶指南
文件頁數： 32/60頁
文件大小： 1522K
代理商： MC1H3
dsPICDEM MC1H 3-Phase High Voltage Power Module
DS70096A-page 26
2003 Microchip Technology Inc.
U16, U17 – Low current (1.6 mA), medium speed (1 MHz) optocouplers to provide
the isolation for the clock and data lines.
R149, R150 – Series resistors that help to set the current through the optocoupler
emitters. They are sized to allow a minimum of 1.8 mA to flow.
C64, C70 – Speed up capacitors to help reduce the effect of the optocoupler's
emitter capacitance at high data rates.
R170, R171 – Pull-up resistors for the open collector outputs of U16 and U17.
1.4.7.3
INVERTER OUTPUT VOLTAGE FEEDBACK AND SENSORLESS
DETECTION
Knowledge of the actual inverter output voltage is useful for two different uses. The
first is for accurately compensating for output voltage errors due to dead time and
power device voltage drops. This can be especially important for high current low
voltage systems with high PWM frequencies and high performance requirements. The
second use is for back EMF sensing for sensorless position detection schemes for
Brushless Permanent Magnet (BPM) and other types of motors.
The hardware for providing this is now discussed with reference to the RED phase.
The other two phases have identical circuits.
R20, R21 and R144 – A resistor divider chain with scaling, the same as the DC
voltage feedback. The same scaling is required in order that the “back EMF
crossing” detection works correctly. The scaling is such that the maximum
expected output voltage will give 4.5V.
C61 – This provides filtering of the inverter output voltage in combination with
R20, R21 and R144.
D41 – This provides a clamp to ensure R_VPH_SENSE is protected.
U31-B – A comparator used to provide a simple sensorless position detection
scheme for BPM motors. Whenever R_PH crosses half the DC bus voltage, an
output transition will occur. The R_CROSSING signal is only valid during regions
of the electrical cycle, where the RED phase output current is zero, so that the
back EMF of the motor determines the voltage of R_VPH. Thus the scheme is
only suitable for use on BPM motors where 120 degree conduction scheme is
used. Careful decoding of all three crossing signals and appropriate angle
interpolation is required for correct commutation. An alternative method for
commutation feedback must be used near zero speed where the back EMF is
insufficient for the scheme to work.
R143, R147 – These provide a small amount of hysteresis to prevent oscillation of
R_CROSSING.
R142 – The pull-up resistor for the open-collector output of the comparator.
相關PDF資料
PDF描述
MC33023DWG High Speed Single−Ended PWM Controller
MC33023DWR2 High Speed Single−Ended PWM Controller
MC33023DWR2G High Speed Single−Ended PWM Controller
MC33025DWG High Speed Double−Ended PWM Controller
MC33025DWR2 High Speed Double−Ended PWM Controller
相關代理商/技術參數
參數描述
MC1JJN0600 功能描述:環形公制連接器 M40 C Straight 6 Position Extension RoHS:否 制造商:3M Electronic Solutions Division 產品類型:Connectors 系列:M12 外殼類型:Plug 觸點數量:4 安裝風格:Cable 端接類型:Solder Cup 電流額定值:4 A
MC1JJN0800 功能描述:環形公制連接器 M40 C Straight Extension 8 Pos. RoHS:否 制造商:3M Electronic Solutions Division 產品類型:Connectors 系列:M12 外殼類型:Plug 觸點數量:4 安裝風格:Cable 端接類型:Solder Cup 電流額定值:4 A
MC1LKN0600 功能描述:環形公制連接器 M40 C Straight Recpt 6 Position RoHS:否 制造商:3M Electronic Solutions Division 產品類型:Connectors 系列:M12 外殼類型:Plug 觸點數量:4 安裝風格:Cable 端接類型:Solder Cup 電流額定值:4 A
MC1LKN0800 功能描述:環形公制連接器 M40 C Straight Recpt 8 Position RoHS:否 制造商:3M Electronic Solutions Division 產品類型:Connectors 系列:M12 外殼類型:Plug 觸點數量:4 安裝風格:Cable 端接類型:Solder Cup 電流額定值:4 A
MC1M 制造商:G & J HALL 功能描述:STEP DRILL 4-12MM 1MM STEP 制造商:G & J HALL 功能描述:STEP DRILL, 4-12MM, 1MM STEP 制造商:G & J HALL 功能描述:STEP DRILL, 4-12MM, 1MM STEP; Drill Bit Size Metric:4mm; Overall Length:75.5mm; SVHC:No SVHC (19-Dec-2012); Drill Bit Type:Step; Material:Steel; Material Thickness Max:5mm; Range:4mm - 12mm; Range:4mm - 12mm; Shank Dia:6mm; S ;RoHS Compliant: NA
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*