- 您現在的位置：買賣IC網 > PDF目錄377925 > MB90F367TPMT (Fujitsu Limited) 16-bit Proprietary Microcontroller PDF資料下載
參數資料
| 型號： | MB90F367TPMT |
| 廠商： | Fujitsu Limited |
| 英文描述： | 16-bit Proprietary Microcontroller |
| 中文描述： | 16位微控制器專有 |
| 文件頁數： | 15/59頁 |
| 文件大小： | 262K |
| 代理商： | MB90F367TPMT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
MB90360 Series
15
10. Connection of unused pins of A/D converter if A/D converter is used
Connect unused pins of A/D converter to AV
CC
=
V
CC
, AV
SS
=
AVR
=
V
SS
.
11. Notes on energization
To prevent the internal regulator circuit from malfunctioning, set the voltage rise time during energization at
50
μ
s or more (0.2 V to 2.7 V)
12. Stabilization of power supply voltage
A sudden change in the power supply voltage may cause the device to malfunction even within the specified
V
CC
power supply voltage operating guarantee range. Therefore, the V
CC
power supply voltage should be stabi-
lized.
For reference, the power supply voltage should be controlled so that V
CC
ripple variations (peak-to-peak value)
at commercial frequencies (50 Hz to 60 Hz) fall below 10
%
of the standard V
CC
power supply voltage and the
coefficient of transient fluctuation does not exceed 0.1 V/ms at instantaneous power switching.
13. Initialization
In the device, there are internal registers which are initialized only by a power-on reset. To initialize these registers,
turn on the power again.
14. Notes on using CAN function
To use CAN function, please set ’1’ to DIRECT bit of CAN direct mode register (CDMR) .
If DIRECT bit is set to ’0’ (initial value) , wait states will be performed when accessing CAN registers.
Note : Please refer to Hardware Manual of MB90360 series for detail of CAN Direct Mode Register.
15. Flash security function
The security bit is located in the area of the flash memory.
If protection code 01
H
is written in the security bit, the flash memory is in the protected state by security.
Therefore, please do not write 01
H
in this address if you do not use the security function.
Please refer to following table for the address of the security bit.
16. Correspondence with
+
105
°
C or more
If used exceeding T
A
=
+
105
°
C, please contact Fujitsu for reliability limitations.
Flash memory size
Address for security bit
MB90F362
MB90F362S
MB90F362T
MB90F362TS
MB90F367
MB90F367S
MB90F367T
MB90F367TS
Embedded 512 Kbit Flash Memory
FF0001
H
相關PDF資料 |
PDF描述 |
|---|---|
| MB90F367TS | 16-bit Proprietary Microcontroller |
| MB90F367TSPMT | 16-bit Proprietary Microcontroller |
| MB90V340A-103 | 16-bit Proprietary Microcontroller |
| MB90V340A-104 | 16-bit Proprietary Microcontroller |
| MB90F372PMT-G | 16-bit Proprietary Microcontroller |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB90F367TSPMCR-GE1 | 制造商:FUJITSU 功能描述: |
| MB90F367TSPMCR-GSE1 | 制造商:FUJITSU 功能描述: |
| MB90F387PMCR-GSE1 | 制造商:FUJITSU 功能描述: |
| MB90F387PMT-GSE1 | 功能描述:IC MCU FLASH 64K ROM 48LQFP RoHS:是 類別:集成電路 (IC) >> 嵌入式 - 微控制器， 系列:F²MC MB90385 產品培訓模塊:MCU Product Line Introduction XMEGA Introduction AVR XMEGA USB Connectivity 標準包裝:90 系列:AVR® XMEGA 核心處理器:AVR 芯體尺寸:8/16-位 速度:32MHz 連通性:I²C，IrDA，SPI，UART/USART 外圍設備:欠壓檢測/復位，DMA，POR，PWM，WDT 輸入/輸出數:50 程序存儲器容量:192KB（96K x 16） 程序存儲器類型:閃存 EEPROM 大小:4K x 8 RAM 容量:16K x 8 電壓 - 電源 (Vcc/Vdd):1.6 V ~ 3.6 V 數據轉換器:A/D 16x12b; D/A 2x12b 振蕩器型:內部 工作溫度:-40°C ~ 85°C 封裝/外殼:64-TQFP 包裝:托盤 配用:ATSTK600-RC14-ND - STK600 SOCKET/ADAPTER 64TQFPATSTK600-TQFP64-ND - STK600 SOCKET/ADAPTER 64-TQFPATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMRATAVRISP2-ND - PROGRAMMER AVR IN SYSTEM |
| MB90F387SPMCR-GE1 | 制造商:FUJITSU 功能描述: |
發(fā)布緊急采購，3分鐘左右您將得到回復。