參數資料
型號: MB90652APF
廠商: FUJITSU LTD
元件分類: 微控制器/微處理器
英文描述: 16-bit Proprietary Microcontroller
中文描述: 16-BIT, MROM, 12 MHz, MICROCONTROLLER, PQFP100
封裝: PLASTIC, QFP-100
文件頁數: 17/120頁
文件大小: 1690K
代理商: MB90652APF
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁
17
MB90650A Series
8. Initializing
In this device there are some kinds of inner resisters which are initializid only by power on reset. It is possible
to initialize these resisters by turning on the power supply again.
9. Power Supply Pins
When there are several V
CC
and V
SS
pins, those pins that should have the same electric potential are connected
within the device when the device is designed in order to prevent misoperation, such as latchup. However, all
of those pins must be connected to the power supply and ground externally in order to reduce unnecessary
emissions, prevent misoperation of strobe signals due to an increase in the ground level, and to observe the
total output current standards.
In addition, give a due consideration to the connection in that current supply be connected to V
CC
and V
SS
with
the lowest possible impedance.
Finally, it is recommended to connect a capacitor of about 0.1
μ
F between V
CC
and V
SS
near this device as a
bypass capacitor.
10.Crystal Oscillation Circuit
Noise in the vicinity of the X0 and X1 pins will cause this device to operate incorrectly. Design the printed circuit
board so that the bypass capacitor connecting X0, X1 and the crystal oscillator (or ceramic oscillator) to ground
is located as close to the device as possible, and that the wiring does not closs the other wirings.
In addition, because printed circuit board artwork in which the area around the X0 and X1 pins is surrounded
by ground provides stable operation, such an arrangement is strongly recommended.
11. About 2 Power Supplies
The MB90650A series usually uses the 3-V power supply as the main power source. With Vcc1 = 3 V and Vcc2
= 5 V, however, it can interface with P20 to P27, P30 to P37, P40 to P47, and P70 to P72 for the 5-V power
supply separately from the 3-V power supply. Note, however, that the analog power supplies such as A/D and
D/A can be used only as 3-V power supplies.
相關PDF資料
PDF描述
MB90652APFV 16-bit Proprietary Microcontroller
MB90653A 16-bit Proprietary Microcontroller
MB90653APF Scan Test Devices With Octal Bus Transceivers And Registers 28-LCCC -55 to 125
MB90653APFV Scan Test Devices With Octal Bus Transceivers And Registers 28-CDIP -55 to 125
MB90654A Scan Test Devices With Octal Bus Transceivers And Registers 28-LCCC -55 to 125
相關代理商/技術參數
參數描述
MB90652APFV 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
MB90653A 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
MB90653APF 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
MB90653APFV 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
MB90654A 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller