• <wbr id="bhr9q"><li id="bhr9q"></li></wbr>
    <ins id="bhr9q"><small id="bhr9q"></small></ins>
    參數資料
    型號: MB90573
    廠商: Fujitsu Limited
    英文描述: Hex Schmitt-trigger Inverters 14-CFP -55 to 125
    中文描述: 16位微控制器專有
    文件頁數: 12/135頁
    文件大小: 2504K
    代理商: MB90573
    第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁第125頁第126頁第127頁第128頁第129頁第130頁第131頁第132頁第133頁第134頁第135頁
    12
    MB90570 Series
    (Continued)
    Pin no.
    LQFP-120 *
    1
    QFP-120 *
    2
    70
    Pin name
    Circuit type
    Function
    PA6
    SDA
    L
    This is a general purpose I/O port.
    This pin is also used as the data I/O pin for the I
    2
    C interface. This
    function is valid when the I
    2
    C interface is enabled for operation. While the
    I
    2
    C interface is operating, this port should be set to the input level
    (DDRA: bit6 = 0).
    This is a general purpose I/O port.
    71
    PA7
    SCL
    L
    This pin is also used as the clock I/O pin for the I
    2
    C interface. This
    function is valid when the I
    2
    C interface is enabled for operation. While the
    I
    2
    C interface is operating, this port should be set to the input level
    (DDRA: bit7 = 0).
    These are general-purpose I/O ports.
    72,
    75 to 79
    PB0,
    PB1 to PB5
    IRQ0,
    IRQ1 to IRQ5
    E
    These pins are also the external interrupt input pins. IRQ0, 1 are
    enabled for both rising and falling edge detection, and therefore cannot
    be used for recovery from STOP status for MB90V570, MB90F574,
    MB90573 and MB90574. However, IRQ0, 1 can be used for recovery
    from STOP status for MB90V570A, MB90F574A and MB90574C.
    This is a general purpose I/O port.
    80
    PB6
    ADTG
    E
    This is also the A/D converter external trigger input pin. While the A/D
    converter is in input operation, this input signal is in continuous use, and
    therefore the output function should only be used when needed.
    This is a general purpose I/O port.
    81
    PB7
    PC0 to PC3
    V
    CC
    E
    E
    82 to 85
    8,54,94
    These are general purpose I/O ports.
    Power
    supply
    Power
    supply
    H
    J
    These are power supply (5V) input pins.
    33,63,
    91,119
    42
    43
    V
    SS
    These are power supply (0V) input pins.
    AV
    CC
    AVRH
    This is the analog macro (D/A, A/D etc.) Vcc power supply input pin.
    This is the A/D converter Vref+ input pin. The input voltage should not
    exceed Vcc.
    This is the A/D converter Vref-input pin. The input voltage should not
    less than Vss.
    This is the analog macro (D/A, A/D etc.) Vss power supply input pin.
    44
    AVRL
    H
    45
    38
    AV
    SS
    DV
    CC
    H
    H
    This is the D/A converter Vref input pin. The input voltage should not
    exceed Vcc.
    This is the D/A converter GND power supply pin. It should be set to Vss
    equivalent potential.
    39
    DV
    SS
    H
    *1: FPT-120P-M05
    *2: FPT-120P-M13
    ,
    FPT-120P-M21
    相關PDF資料
    PDF描述
    MB90573PFF 16-bit Proprietary Microcontroller
    MB90573PFV 16-bit Proprietary Microcontroller
    MB90574 16-bit Proprietary Microcontroller
    MB90574C 16-bit Proprietary Microcontroller
    MB90574PFF Octal Buffers/Drivers With 3-State Outputs 20-LCCC -55 to 125
    相關代理商/技術參數
    參數描述
    MB90573PFF 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
    MB90573PFV 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
    MB90573PMC1 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
    MB90574 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller
    MB90574C 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:16-bit Proprietary Microcontroller