- 您現在的位置：買賣IC網 > PDF目錄376148 > MB89635R (Fujitsu Limited) Quadruple 2-Input Exclusive-OR Gates 14-CDIP -55 to 125 PDF資料下載
參數資料
| 型號： | MB89635R |
| 廠商： | Fujitsu Limited |
| 英文描述： | Quadruple 2-Input Exclusive-OR Gates 14-CDIP -55 to 125 |
| 中文描述： | 8位微控制器專有 |
| 文件頁數： | 17/59頁 |
| 文件大?。?/td> | 864K |
| 代理商： | MB89635R |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁
MB89630R Series
17
Programming procedure
(1) Set the EPROM programmer to the MBM27C256A-20CZ and MBM27C256A-20TV.
(2) Load program data into the EPROM programmer at 0007
H
to 7FFF
H
. (Note that addresses 8000
H
to FFFF
H
in the operating mode assign to 0000
H
to 7FFF
H
in EPROM mode).
(3) Load option data into addresses 0000
H
to 0006
H
of the EPROM programmer.
(For information about each corresponding option, see “8. OTPROM Option Bit Map.”)
(4) Program with the EPROM programmer.
4. Recommended Screening Conditions
High-temperature aging is recommended as the pre-assembly screening procedure for a product with a blanked
OTPROM microcomputer program.
5. Programming Yield
All bits cannot be programmed at Fujitsu shipping test to a blanked OTPROM microcomputer, due to its nature.
For this reason, a programming yield of 100% cannot be assured at all times.
6. Erasure
In order to clear all locations of their programmed contents, it is necessary to expose the internal EPROM to an
ultraviolet light source. A dosage of 10 W-seconds/cm
2
is required to completely erase an internal EPROM. This
dosage can be obtained by exposure to an ultraviolet lamp (wavelength of 2537 Angstroms ()) with intensity
of 12000
μ
W/cm
2
for 15 to 21 minutes. The internal EPROM should be about one inch from the source and all
filters should be removed from the UV light source prior to erasure.
It is important to note that the internal EPROM and similar devices, will erase with light sources having wave-
lengths shorter than 4000 . Although erasure time will be much longer than with UV source at 2537 ,
nevertheless the exposure to fluorescent light and sunlight will eventually erase the internal EPROM, and
exposure to them should be prevented to realize maximum system reliability. If used in such an environment,
the package windows should be covered by an opaque label or substance.
Program, verify
Aging
+150
°
C, 48 Hrs.
Data verification
Assembly
相關PDF資料 |
PDF描述 |
|---|---|
| MB89635RP-SH | Quadruple 2-Input Exclusive-OR Gates 14-CFP -55 to 125 |
| MB89635RPF | Quadruple 2-Input Exclusive-OR Gates 20-LCCC -55 to 125 |
| MB89635RPFM | Quadruple 2-Input Exclusive-OR Gates 14-CDIP -55 to 125 |
| MB89P637 | 8-bit Proprietary Microcontroller |
| MB89P637PF | Replaced by TPS2061 : 1.1A, 4-5.5V Single Hi-Side MOSFET, Fault Report, Act-Low Enable 8-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB89635RPF | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-bit Proprietary Microcontroller |
| MB89635RPFM | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-bit Proprietary Microcontroller |
| MB89635RP-SH | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:8-bit Proprietary Microcontroller |
| MB89636 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
| MB89636PF | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:8-bit Proprietary Microcontroller |
發布緊急采購，3分鐘左右您將得到回復。