- 您現在的位置：買賣IC網 > PDF目錄377879 > MB3789 (Fujitsu Limited) RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS PDF資料下載
參數資料
| 型號： | MB3789 |
| 廠商： | Fujitsu Limited |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| 中文描述： | 抗輻射高效，5安培開關穩壓器 |
| 文件頁數： | 16/28頁 |
| 文件大?。?/td> | 214K |
| 代理商： | MB3789 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
16
MB3789
I
SETTING THE DEAD TIME
When the device is set for step-up inverting output based on the flyback method, the output transistor is fixed
to a full-ON state (ON duty = 100%) when the power supply is turned on. To prevent this problem, you may
determine the voltage at the DTC pin (pin 12) from the V
REF
voltage so you can set the output transistor’s dead
time (maximum ON-duty period) as shown in Figure 7 below.
Setting the dead time
1.
When setting the dead time, use resistors as shown in Figure 7 to connect the V
REF
and DTC pins to GND. When
the voltage at the DTC pin (pin 12) is lower than the sawtooth wave output voltage from the oscillator, the output
transistor is turned off.
To set the dead time, see “Duty vs. DTC pin voltage” (in “
I
STANDARD CHARACTERISTIC CURVES”).
2.
Connection without setting the dead time
If you do not set the dead time, connect the V
REF
and DTC pins as shown in Figure 8.
V
dt
=R1 + R2
×
V
REF
R2
2
R2
V
dt
12 DTC
V
REF
R1
2
12 DTC
V
REF
Figure 7 Connection for setting the dead time
Figure 8 Connection without setting the dead time
相關PDF資料 |
PDF描述 |
|---|---|
| MB3789PFV | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| MB3790PF | Battery Backup IC |
| MB3790 | DIODE SCHOTTKY SINGLE 25V 200mW 0.32V-vf 200mA-IFM 1mA-IF 2uA-IR SOT-23 3K/REEL |
| MB3790PFT | Battery Backup IC |
| MB3793-27A | Power Voltage Monitoring IC with Watchdog Timer |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MB3789PFV | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Switching Regulator Controller (Supporting External Synchronization) |
| MB3789PFV-G-BND(E1) | 制造商:Fujitsu 功能描述: |
| MB-379 | 制造商:Maxxtro 功能描述: |
| MB3790 | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Battery Backup IC |
| MB3790PF | 制造商:FUJITSU 制造商全稱:Fujitsu Component Limited. 功能描述:Battery Backup IC |
發布緊急采購，3分鐘左右您將得到回復。