- 您現在的位置：買賣IC網 > PDF目錄2092 > MAX9814ETD+T (Maxim Integrated Products)IC AMP AUDIO MONO AB MIC 14TDFN PDF資料下載
參數資料
| 型號： | MAX9814ETD+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 14/14頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP AUDIO MONO AB MIC 14TDFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 類型： | AB 類 |
| 輸出類型： | 1-通道（單聲道） |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 特點： | AGC，麥克風，關機 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 14-TDFN-EP（3x3） |
| 封裝/外殼： | 14-WFDFN 裸露焊盤 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 1392 (CN2011-ZH PDF) |
| 其它名稱： | MAX9814ETD+TDKR |
Setting the AGC Threshold
To set the output-voltage threshold at which the micro-
phone output is clamped, an external resistor-divider
must be connected from MICBIAS to ground with the out-
put of the resistor-divider applied to TH. The voltage VTH
determines the peak output-voltage threshold at which
the output becomes clamped. The maximum signal
swing at the output is then limited to two times VTH and
remains at that level until the amplitude of the input signal
is reduced. To disable AGC, connect TH to MICBIAS.
Microphone Bias Resistor
MICBIAS is capable of sourcing 20mA. Select a value for
RMICBIAS that provides the desired bias current for the
electret microphone. A value of 2.2k
Ω is usually sufficient
for a microphone of typical sensitivity. Consult the micro-
phone data sheet for the recommended bias resistor.
Bias Capacitor
The BIAS output of the MAX9814 is internally buffered
and provides a low-noise bias. Bypass BIAS with a
470nF capacitor to ground.
Input Capacitor
The input AC-coupling capacitor (CIN) and the input
resistance (RIN) to the microphone amplifier form a
highpass filter that removes any DC bias from an input
signal (see the
Typical Application Circuit/Functional
Diagram). CIN prevents any DC components from the
input-signal source from appearing at the amplifier out-
puts. The -3dB point of the highpass filter, assuming
zero source impedance due to the input signal source,
is given by:
Choose CIN such that f-3dB_IN is well below the lowest
frequency of interest. Setting f-3dB_IN too high affects the
amplifier’s low-frequency response. Use capacitors with
low-voltage coefficient dielectrics. Aluminum electrolytic,
tantalum, or film dielectric capacitors are good choices
for AC-coupling capacitors. Capacitors with high-voltage
coefficients, such as ceramics (non-C0G dielectrics), can
result in increased distortion at low frequencies.
Output Capacitor
The output of the MAX9814 is biased at 1.23V. To elimi-
nate the DC offset, an AC-coupling capacitor (COUT)
must be used. Depending on the input resistance (RL)
of the following stage, COUT and RL effectively form a
highpass filter. The -3dB point of the highpass filter,
assuming zero output impedance, is given by:
Shutdown
The MAX9814 features a low-power shutdown mode.
When SHDN goes low, the supply current drops to
0.01A, the output enters a high-impedance state, and
the bias current to the microphone is switched off.
Driving SHDN high enables the amplifier. Do not leave
SHDN unconnected.
Power-Supply Bypassing
and PCB Layout
Bypass the power supply with a 0.1F capacitor to
ground. Reduce stray capacitance by minimizing trace
lengths and place external components as close to the
device as possible. Surface-mount components are
recommended. In systems where analog and digital
grounds are available, connect the MAX9814 to analog
ground.
f
1
2R
C
3dB_OUT
L
OUT
=
××
π
f
1
2R
C
3dB_IN
IN
=
××
π
Microphone Amplifier with AGC and
Low-Noise Microphone Bias
MAX9814
Maxim Integrated
9
相關PDF資料 |
PDF描述 |
|---|---|
| MAX9820ETB+T | IC AMP AUD HDPHE 95MW 10TDFN |
| MAX98300SETA+T | IC AMP AUD SPKR 2W MONO D 8TDFN |
| MAX98302ETD+ | IC AMP STER CLASS D 2.4W 14TDFN |
| MAX98303EWE+T | IC AMP AUDIO 3.1W STEREO D 16WLP |
| MAX98304EWL+T | IC AMP AUDIO 3.2W MONO D 9WLP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9814EVKIT+ | 功能描述:音頻 IC 開發工具 MAX9814 Eval Kit RoHS:否 制造商:Texas Instruments 產品:Evaluation Kits 類型:Audio Amplifiers 工具用于評估:TAS5614L 工作電源電壓:12 V to 38 V |
| MAX981CPA | 功能描述:校驗器 IC Single Comparator / Reference RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| MAX981CPA+ | 功能描述:校驗器 IC Single Comparator / Reference RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| MAX981CSA | 功能描述:校驗器 IC RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
| MAX981CSA+ | 功能描述:校驗器 IC Single Comparator / Reference RoHS:否 制造商:STMicroelectronics 產品: 比較器類型: 通道數量: 輸出類型:Push-Pull 電源電壓-最大:5.5 V 電源電壓-最小:1.1 V 補償電壓（最大值）:6 mV 電源電流（最大值）:1350 nA 響應時間: 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:SC-70-5 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。