- 您現在的位置：買賣IC網 > PDF目錄10441 > MAX9792AETI+ (Maxim Integrated Products)IC AMP AUDIO 3.7W MONO D 28TQFN PDF資料下載
參數資料
| 型號： | MAX9792AETI+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 17/34頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP AUDIO 3.7W MONO D 28TQFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 75 |
| 系列： | DirectDrive® |
| 類型： | D 類 |
| 輸出類型： | 1-通道（單聲道），帶立體聲耳機 |
| 在某負載時最大輸出功率 x 通道數量： | 3.7W x 1 @ 3 歐姆; 180mW x 2 @ 32 歐姆 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 特點： | 消除爆音，LDO，短路保護和熱保護，關機 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 28-TQFN-EP（4x4） |
| 封裝/外殼： | 28-WFQFN 裸露焊盤 |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁
MAX9791/MAX9792
Windows Vista-Compliant Class D Speaker
Amplifiers with DirectDrive Headphone Amplifiers
24
______________________________________________________________________________________
Setting Speaker Amplifier Gain
External input resistors in conjunction with the internal
feedback resistors (RFSPKR) set the speaker amplifier
gain of the MAX9791/MAX9792. Set gain by using
resistor RIN1 as follows (Figure 9):
where AVSPKR is the desired voltage gain. An RIN1 of
20k
yields a gain of 4V/V, or 12dB.
Component Selection
Optional Ferrite Bead Filter
In applications where speaker leads exceed 15cm, use
a filter constructed from a ferrite bead and a capacitor
to ground (Figure 10) to provide additional EMI sup-
pression. Use a ferrite bead with low DC resistance,
high frequency (> 1.2MHz) impedance of 100
to
600
, and rated for at least 1A. The capacitor value
varies based on the ferrite bead chosen and the actual
speaker lead length. Select the capacitor value based
on EMI performance.
Output Power (Headphone Amplifier)
The headphone amplifiers are specified for the worst-
case scenario when both inputs are in phase. Under
this condition, the drivers simultaneously draw current
from the charge pump, leading to a slight loss in head-
room of CPVSS. In typical stereo audio applications, the
left and right signals have differences in both magni-
tude and phase, subsequently leading to an increase in
the maximum attainable output power. Figure 11 shows
the two extreme cases for in and out of phase. In most
cases, the available power lies between these
extremes.
Headphone Amplifier Gain
Gain-Setting Resistors
External input resistors in conjunction with the internal
feedback resistors (RFHP) set the headphone amplifier
gain of the MAX9791/MAX9792. Set gain by using
resistor RIN2 (Figure 4) as follows:
where AVHP is the desired voltage gain. An RIN2 of
40.2k
yields a gain of 1V/V, or 0dB.
Power Supplies
The MAX9791/MAX9792 speaker amplifiers are pow-
ered from PVDD with a range from 2.7V to 5.5V. The
headphone amplifiers are powered from HPVDD and
CPVSS. HPVDD is the positive supply of the headphone
amplifiers and charge pump ranging from 2.7V to 5.5V.
CPVSS is the negative supply of the headphone ampli-
fiers. The charge pump inverts the voltage at HPVDD,
and the resulting voltage appears at CPVSS. AVDD
powers the LDO and the remainder of the device.
AVDD and PVDD must be tied together. If LDO is
enabled, set AVDD and PVDD as specified in the Line
Regulation row of the
Electrical Characteristics table.
A
k
R
VV
VHP
IN
=
-
40 2
2
.
/
A
k
R
VV
VSPKR
IN
=
-4
20
1
/
MAX9791
MAX9792
L1*
L2*
330pF
*L1 = L2 = WRTH 742792040
Figure 10. Optional Ferrite Bead Filter
TOTAL HARMONIC DISTORTION + NOISE
vs. OUTPUT POWER (HEADPHONE MODE)
OUTPUT POWER (mW)
THD+N
(%)
200
150
100
50
0.01
0.1
1
10
100
0.001
0
250
RL = 32
OUT OF PHASE
IN PHASE
Figure 11. Output Power vs. Supply Voltage with Inputs In/Out
of Phase; 32
Load Conditions and 3.5dB Gain
相關PDF資料 |
PDF描述 |
|---|---|
| GM101K | CAP CER 100PF 500V 10% RADIAL |
| MAX9791AETI+ | IC AMP AUDIO 2.2W STER D 28TQFN |
| GE330K | CAP CER 33PF 50V 10% RADIAL |
| GE102K | CAP CER 1000PF 50V 10% RADIAL |
| GE101K | CAP CER 100PF 50V 10% RADIAL |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9792AETI+ | 功能描述:音頻放大器 Windows Vista Class D Speaker Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9792AETI+T | 功能描述:音頻放大器 Windows Vista Class D Speaker Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9792AEVKIT+ | 功能描述:音頻放大器 Windows Vista-Compliant Class D Speaker Amplifiers with DirectDrive Headphone Amplifiers RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9792CETI+ | 功能描述:音頻放大器 Windows Vista Class D Speaker Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9792CETI+T | 功能描述:音頻放大器 Windows Vista Class D Speaker Amp RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。