- 您現在的位置：買賣IC網 > PDF目錄10268 > MAX9750AEUI+ (Maxim Integrated Products)IC AMP AUDIO PWR 2.6W AB 28TSSOP PDF資料下載
參數資料
| 型號： | MAX9750AEUI+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 5/30頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC AMP AUDIO PWR 2.6W AB 28TSSOP |
| 標準包裝： | 50 |
| 系列： | DirectDrive® |
| 類型： | AB 類 |
| 輸出類型： | 2-通道（立體聲）帶立體聲耳機 |
| 在某負載時最大輸出功率 x 通道數量： | 2.6W x 2 @ 3 歐姆; 110mW x 2 @ 16 歐姆 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 特點： | 消除爆音，短路保護和熱保護，關機，音量控制 |
| 安裝類型： | 表面貼裝 |
| 供應商設備封裝： | 28-TSSOP |
| 封裝/外殼： | 28-TSSOP（0.173"，4.40mm 寬） |
| 包裝： | 管件 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
MAX9750/MAX9751/MAX9755
2.6W Stereo Audio Power Amplifiers and
DirectDrive Headphone Amplifiers
______________________________________________________________________________________
13
significant amount of DC current flows to the headphone,
resulting in unnecessary power dissipation and possible
damage to both headphone and headphone amplifier.
Maxim’s DirectDrive architecture uses a charge pump to
an internal negative supply voltage. This allows the
MAX9750/MAX9751/MAX9755 headphone amplifier out-
put to be biased about GND, almost doubling the dynam-
ic range while operating from a single supply. With no DC
component, there is no need for the large DC-blocking
capacitors. Instead of two large capacitors (220F typ),
the MAX9750/MAX9751/MAX9755 charge pump requires
only two small ceramic capacitors (1F typ), conserving
board space, reducing cost, and improving the frequen-
cy response of the headphone amplifier. See the Output
Power vs. Charge-Pump Capacitance and Load
Resistance
graph
in
the
Typical
Operating
Characteristics for details of the possible capacitor val-
ues.
Previous attempts to eliminate the output coupling
capacitors involved biasing the headphone return
(sleeve) to the DC bias voltage of the headphone
amplifiers. This method raised some issues:
1) The sleeve is typically grounded to the chassis. Using
this biasing approach, the sleeve must be isolated
from system ground, complicating product design.
2) During an ESD strike, the amplifier’s ESD structures
are the only path to system ground. The amplifier
must be able to withstand the full ESD strike.
3) When using the headphone jack as a lineout to other
equipment, the bias voltage on the sleeve may con-
flict with the ground potential from other equipment,
resulting in large ground-loop current and possible
damage to the amplifiers.
Low-Frequency Response
In addition to the cost and size disadvantages, the DC-
blocking capacitors limit the low-frequency response of
the amplifier and distort the audio signal:
1) The impedance of the headphone load to the DC-
blocking capacitor forms a highpass filter with the
-3dB point determined by:
where RL is the impedance of the headphone and
COUT is the value of the DC-blocking capacitor.
The highpass filter is required by conventional sin-
gle-ended, single-supply headphone amplifiers to
block the midrail DC component of the audio signal
from the headphones. Depending on the -3dB point,
the filter can attenuate low-frequency signals within
the audio band. Larger values of COUT reduce the
attenuation but are physically larger, more expen-
sive capacitors. Figure 3 shows the relationship
between the size of COUT and the resulting low-fre-
quency attenuation. Note that the -3dB point for a
16
Ω headphone with a 100F blocking capacitor is
100Hz, well within the audio band.
2) The voltage coefficient of the capacitor, the change
in capacitance due to a change in the voltage
across the capacitor, distorts the audio signal. At
frequencies around the -3dB point, the reactance of
the capacitor dominates, and the voltage coefficient
appears as frequency-dependent distortion. Figure
4 shows the THD+N introduced by two different
capacitor dielectrics. Note that around the -3dB
point, THD+N increases dramatically.
The combination of low-frequency attenuation and fre-
quency-dependent distortion compromises audio
reproduction. DirectDrive improves low-frequency
reproduction in portable audio equipment that empha-
sizes low-frequency effects such as multimedia lap-
tops, and MP3, CD, and DVD players.
Charge Pump
The MAX9750/MAX9751/MAX9755 feature a low-noise
charge pump. The 550kHz switching frequency is well
beyond the audio range, and does not interfere with the
audio signals. The switch drivers feature a controlled
switching speed that minimizes noise generated by turn-
on and turn-off transients. Limiting the switching speed of
the charge pump minimizes the di/dt noise caused by the
f
RC
dB
L OUT
=
3
1
2
π
0
-30
10
100
1k
10k
100k
LOW-FREQUENCY ROLLOFF
(RL = 16
Ω)
-24
-27
-12
-15
-18
-21
-6
-9
-3
FREQUENCY (Hz)
ATTENUATION
(dB)
DirectDrive
330
μF
220
μF
100
μF
33
μF
Figure 3. Low-Frequency Attenuation of Common DC-Blocking
Capacitor Values
相關PDF資料 |
PDF描述 |
|---|---|
| LTC1853CFW | IC A/D CONV 8CH 12BIT 48-TSSOP |
| AD7812WYRUZ | IC ADC 10BIT 8-CHAN SRL 20TSSOP |
| MAX9777ETI+ | IC AMP AUDIO PWR 2.6W AB 28TQFN |
| MAX9778ETI+T | IC AMP AUDIO PWR 2.6W AB 28TQFN |
| LTC2414IGN#TRPBF | IC ADC 8CH 24BIT DIFFINPUT28SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9750AEUI+ | 功能描述:IC AMP AUDIO PWR 2.6W AB 28TSSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 音頻放大器 系列:DirectDrive® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:DirectDrive® 類型:H 類 輸出類型:耳機，2-通道（立體聲） 在某負載時最大輸出功率 x 通道數量:35mW x 2 @ 16 歐姆 電源電壓:1.62 V ~ 1.98 V 特點:I²C，麥克風，靜音，短路保護，音量控制 安裝類型:表面貼裝 供應商設備封裝:25-WLP（2.09x2.09） 封裝/外殼:25-WFBGA，WLCSP 包裝:帶卷 (TR) |
| MAX9750AEUI+T | 功能描述:IC AMP AUDIO PWR 2.6W AB 28TSSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 音頻放大器 系列:DirectDrive® 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:DirectDrive® 類型:H 類 輸出類型:耳機，2-通道（立體聲） 在某負載時最大輸出功率 x 通道數量:35mW x 2 @ 16 歐姆 電源電壓:1.62 V ~ 1.98 V 特點:I²C，麥克風，靜音，短路保護，音量控制 安裝類型:表面貼裝 供應商設備封裝:25-WLP（2.09x2.09） 封裝/外殼:25-WFBGA，WLCSP 包裝:帶卷 (TR) |
| MAX9750AEVKIT | 功能描述:放大器 IC 開發工具 RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
| MAX9750BETI | 功能描述:音頻放大器 RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
| MAX9750BETI+ | 功能描述:音頻放大器 Integrated Circuits (ICs) RoHS:否 制造商:STMicroelectronics 產品:General Purpose Audio Amplifiers 輸出類型:Digital 輸出功率: THD + 噪聲: 工作電源電壓:3.3 V 電源電流: 最大功率耗散: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:TQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。