- 您現在的位置：買賣IC網 > PDF目錄8522 > MAX9587AZT+T (Maxim Integrated Products)IC DUAL VIDEO AMP LP TSOT23-6 PDF資料下載
參數資料
| 型號： | MAX9587AZT+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 19/19頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DUAL VIDEO AMP LP TSOT23-6 |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 應用： | 重構濾波器 |
| 電路數： | 2 |
| 電流 - 電源： | 4.25mA |
| 電流 - 輸出 / 通道： | 140mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 3.6 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-6 細型，TSOT-23-6 |
| 供應商設備封裝： | TSOT-23-6 |
| 包裝： | 標準包裝 |
| 其它名稱： | MAX9587AZT+TDKR |
MAX9586–MAX9589
Single, Dual, Triple, and Quad Standard-Definition
Video Filter Amplifiers with AC-Coupled Input Buffers
_______________________________________________________________________________________
9
Detailed Description
The MAX9586–MAX9589 filter and amplify the video
DAC output in applications such as set-top boxes and
televisions. These devices consist of input clamps,
input bias circuits, lowpass filters, and gain of 2V/V out-
put amplifiers capable of driving a standard 150
video load to ground.
Inputs
The input stages of the MAX9586–MAX9589 are either
sync-tip clamps or bias circuits. Sync-tip clamps accept
AC-coupled CVBS or luma video signals with sync puls-
es. The sync-tip voltage is internally set to 300mV. Bias
circuit inputs accept AC-coupled chroma, a subcarrier
modulated with the color information. The bias voltage
of the bias circuits is approximately 500mV.
Video Filter
The filter passband (±1dB) is typically 8.5MHz, which
makes the device suitable for standard-definition video
signals from all sources (e.g., broadcast and DVD).
Broadcast video signals are channel limited: NTSC sig-
nals have 4.2MHz bandwidth and PAL signals have
5MHz bandwidth. Video signals from a DVD player,
however, are not channel limited, so the bandwidth of
DVD video signals can approach the Nyquist limit of
6.75MHz. (Recommendation ITU-R BT.601-5 specifies
13.5MHz as the sampling rate for standard-definition
video). Therefore, the maximum bandwidth of the signal
is 6.75MHz. To ease the filtering requirements, most
modern video systems oversample by two times, clock-
ing the video current DAC at 27MHz.
Outputs
The video output amplifiers can both source and sink
load current, allowing output loads to be DC- or AC-
coupled. The amplifier output stage needs approxi-
mately 300mV of headroom from either supply rail. The
devices have an internal level-shift circuit that positions
the sync tip at approximately 300mV at the output.
If the supply voltage is greater than 3.135V (5% below
a 3.3V supply), each amplifier can drive two DC-cou-
pled video loads to ground. If the supply is less than
3.135V, each amplifier can drive only one DC-coupled
or AC-coupled video load.
Shutdown (MAX9586)
The MAX9586 draws less than 1A supply current
when SHDN is low. In shutdown mode, the amplifier
output becomes high impedance.
Applications Information
AC-Coupling the Outputs
The outputs can be AC-coupled since the output stage
can source and sink current as shown in Figure 4.
Coupling capacitors should be 220F or greater to
keep the highpass filter, formed by the 150
equivalent
resistance of the video transmission line, to a corner
frequency of 4.8Hz or below. The frame rate of PAL
systems is 25Hz, and the frame rate of NTSC systems
is 30Hz. The corner frequency should be well below the
frame rate.
Power-Supply Bypassing and Ground
The MAX9586–MAX9589 operate from a single-supply
voltage down to 2.7V, allowing for low-power operation.
Bypass VDD to GND with a 0.1F capacitor. Place all
external components as close as possible to the device.
CVBS IN
LOOPBACK
OUT
37.5
75
0.1
F
VIN
DOUT
37.5
MAX9526
0.1
F
IN
OUT
MAX9586
Figure 3. Loopback Circuit Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| ISL59483IRZ-T13 | IC MUX AMP DUAL 500MHZ 48-QFN |
| VI-J2P-MZ-B1 | CONVERTER MOD DC/DC 13.8V 25W |
| ISL59482IRZ-T13 | IC MUX AMP DUAL 500MHZ 48-QFN |
| 2-1877847-9 | PLUG 7POS 80 DEG BLK/WH 4.0-5.2 |
| ISL59481IRZ-T13 | IC MUX AMP DUAL 500MHZ 48-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9587EVKIT+ | 制造商:Maxim Integrated Products 功能描述:MAX9587 EVAL KIT - Rail/Tube |
| MAX9588AUA+ | 功能描述:視頻放大器 Standard-Definition Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9588AUA+T | 功能描述:視頻放大器 Standard-Definition Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9588EVKIT+ | 制造商:Maxim Integrated Products 功能描述:MAX9588 EVAL KIT - Rail/Tube |
| MAX9589AUB+ | 功能描述:視頻放大器 Standard-Definition Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。