- 您現在的位置：買賣IC網 > PDF目錄385556 > MAX9516 (Maxim Integrated Products, Inc.) 1.8V, Ultra-Low-Power, DirectDrive Video Filter Amplifier with Load Detect PDF資料下載
參數資料
| 型號： | MAX9516 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 1.8V, Ultra-Low-Power, DirectDrive Video Filter Amplifier with Load Detect |
| 中文描述： | 1.8V、超低功耗、DirectDrive視頻濾波放大器，提供負載檢測 |
| 文件頁數： | 11/15頁 |
| 文件大?。?/td> | 320K |
| 代理商： | MAX9516 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁
M
1.8V, Ultra-Low-Power, DirectDrive
Video Filter Amplifier with Load Detect
______________________________________________________________________________________
11
Video Source with a Positive DC Bias
In some applications, the video source generates a sig-
nal with a positive DC voltage bias, i.e. the sync tip of
the signal is well above ground. Figure 6 shows an
example in which the outputs of the luma (Y) DAC and
the chroma (C) DAC are connected together. Since the
DACs are current mode, the output currents sum togeth-
er into the resistor, which converts the resulting current
into a voltage representing a composite video signal.
If the chroma DAC has an independent output resistor
to ground, then the chroma signal, which is a carrier at
3.58MHz for NTSC or at 4.43MHz for PAL, has a posi-
tive DC bias to keep the signal above ground at all
times. If the luma DAC has an independent output
resistor to ground, then the luma signal usually does
not have a positive DC bias, and the sync tip is at
approximately ground. When the chroma and luma sig-
nals are added together, the resulting composite video
signal still has a positive DC bias. Therefore, the signal
must be AC-coupled into the MAX9516 because the
composite video signal is above the nominal, DC-cou-
pled 0V to 0.25V input range.
Video Signal Routing
Minimize the length of the PCB trace between the out-
put of the video DAC and the input of the MAX9516 to
reduce coupling of external noise into the video signal.
If possible, shield the PCB trace.
MAX9516
LOAD SENSE
V
DD
VIDEO
AMPLIFIER
LUMA (Y)
CHROMA (C)
SHDN
IN
DC
LEVEL SHIFT
CLAMP
1.8V
V
DD
OUT
75
75
LOAD
CHARGE PUMP
LINEAR
REGULATOR
C1
1
μ
F
C2
1
μ
F
0.1
μ
F
0.1
μ
F
LPF
GND
CPGND
C1P
C1N
V
SS
DAC
DAC
VIDEO
ASIC
Figure 6. Luma (Y) and Chroma (C) Signals Added Together to Create Composite Video Signal (Which is AC-Coupled Into the
MAX9516)
相關PDF資料 |
PDF描述 |
|---|---|
| MAX951 | Ultra-Low-Power, Single-Supply Op Amp + Comparator + Reference(超低功耗、單電源運放+比較器+基準) |
| MAX952 | Ultra-Low-Power, Single-Supply Op Amp + Comparator + Reference(超低功耗、單電源運放+比較器+基準) |
| MAX953 | Ultra-Low-Power, Single-Supply Op Amp + Comparator + Reference(超低功耗、單電源運放+比較器+基準) |
| MAX954 | Ultra-Low-Power, Single-Supply Op Amp + Comparator + Reference(超低功耗、單電源運放+比較器+基準) |
| MAX9539 | Graphics Video Sync Adder/Extractor |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX9516ALB+ | 制造商:Maxim Integrated Products 功能描述:1.8V, ULTRA-LOW-POWER, DIRECTDRIVE VIDEO FILTER AMPLIFIER - Bulk |
| MAX9516ALB+T | 功能描述:視頻放大器 1.8V DirectDrive Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9516EVKIT+ | 功能描述:放大器 IC 開發工具 MAX9516 Eval Kit RoHS:否 制造商:International Rectifier 產品:Demonstration Boards 類型:Power Amplifiers 工具用于評估:IR4302 工作電源電壓:13 V to 23 V |
| MAX9517ATC+ | 功能描述:視頻放大器 Standard-Definition Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
| MAX9517ATC+T | 功能描述:視頻放大器 Standard-Definition Video Filter Amp RoHS:否 制造商:ON Semiconductor 通道數量:4 電源類型: 工作電源電壓:3.3 V, 5 V 電源電流: 最小工作溫度: 最大工作溫度: 封裝 / 箱體:TSSOP-14 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。