- 您現在的位置：買賣IC網 > PDF目錄180539 > MAX6730A (Maxim Integrated Products, Inc.) 單/雙/三電壓微處理器監控電路，帶有獨立的看門狗輸出 PDF資料下載
參數資料
| 型號： | MAX6730A |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 單/雙/三電壓微處理器監控電路，帶有獨立的看門狗輸出 |
| 中文描述： | 單/雙/三電壓微處理器監控電路，帶有獨立的看門狗輸出 |
| 文件頁數： | 2/16頁 |
| 文件大?。?/td> | 460K |
| 代理商： | MAX6730A |
MAX6730A–MAX6735A
The RSTIN comparator derives power from VCC1, and
the input voltage must remain less than or equal to
VCC1. Low leakage current at RSTIN allows the use of
large-valued resistors, resulting in reduced power con-
sumption of the system.
Watchdog
The watchdog feature monitors P activity through
the watchdog input (WDI). A rising or falling edge on
WDI within the watchdog timeout period (tWD) indi-
cates normal P operation. WDO asserts low if WDI
remains high or low for longer than the watchdog
timeout period. Floating WDI does not disable the
watchdog timer.
The MAX6730A–MAX6735A include a dual-mode
watchdog timer to monitor P activity. The flexible time-
out architecture provides a long-period initial watchdog
mode, allowing complicated systems to complete
lengthy boots, and a short-period normal watchdog
mode, allowing the supervisor to provide quick alerts
when processor activity fails. After each reset event
(VCC power-up, brownout, or manual reset), there is a
long initial watchdog period of 35s (min). The long
watchdog period mode provides an extended time for
the system to power up and fully initialize all P and
system components before assuming responsibility for
routine watchdog updates.
The usual watchdog timeout period (1.12s min) begins
after the initial watchdog timeout period (tWD-L) expires
or after the first transition on WDI (Figure 3). During nor-
mal operating mode, the supervisor asserts the WDO
output if the P does not update the WDI with a valid
transition (high to low or low to high) within the standard
timeout period (tWD-S) (1.12s min).
Connect MR to WDO to force a system reset in the
event that no rising or falling edge is detected at WDI
within the watchdog timeout period. WDO asserts low
when no edge is detected by WDI, the RST output
asserts low, the watchdog counter immediately clears,
and WDO returns high. The watchdog counter restarts,
using the long watchdog period, when the reset timeout
period ends (Figure 4).
Ensuring a Valid Reset
Output Down to VCC = 0V
The MAX6730A–MAX6735A guarantee proper opera-
tion down to VCC = +0.8V. In applications that require
valid reset levels down to VCC = 0V, use a 100k
pull-
down resistor from RST to GND. The resistor value
used is not critical, but it must be large enough not to
load the reset output when VCC is above the reset
threshold. For most applications, 100k
is adequate.
Note that this configuration does not work for the open-
drain outputs of MAX6730A/MAX6732A/MAX6734A.
Single-/Dual-/Triple-Voltage P Supervisory
Circuits with Independent Watchdog Output
10
______________________________________________________________________________________
tRP
VTH
VCC
(MIN)
VCC1,
VCC2
RSTIN
RST
WDO
WDI
<tWD-S
>tWD-S
tWD-S
<tWD-S
<tWD-L
Figure 3. Watchdog Input/Output Timing Diagram (MR and WDO Not Connected)
相關PDF資料 |
PDF描述 |
|---|---|
| MAX6850AEE-T | 4-Wire Interfaced, 7-, 14-, and 16-Segment Alphanumeric Vacuum-Fluorescent Display Controller |
| MAX6853AEE-T | 2-Wire Interfaced, 5 x 7 Matrix Vacuum-Fluorescent Display Controller |
| MAX685C/D | Dual-Output (Positive and Negative), DC-DC Converter for CCD and LCD |
| MAX686EEE+ | DAC-Controlled Boost Inverter LCD Bias Supply with Internal Switch |
| MAX686EEE+T | DAC-Controlled Boost Inverter LCD Bias Supply with Internal Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX6730AUTLD1+T | 功能描述:監控電路 Single uPower Supervisor RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6730AUTLD2+T | 功能描述:監控電路 Single uPower Supervisor RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6730AUTLD3+ | 制造商:Maxim Integrated Products 功能描述:VOLT SUPERVISOR PWR SUPPLY 4.625V 6PIN SOT-23 - Cut Tape Product |
| MAX6730AUTLD3+T | 功能描述:監控電路 Single uPower Supervisor RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| MAX6730AUTLD4+T | 功能描述:監控電路 Single-/Dual-/Triple-Voltage N
|
發布緊急采購，3分鐘左右您將得到回復。