- 您現在的位置：買賣IC網 > PDF目錄383451 > MAX6369KA-T (MAXIM INTEGRATED PRODUCTS INC) Pin-Selectable Watchdog Timers PDF資料下載
參數資料
| 型號： | MAX6369KA-T |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 電源管理 |
| 英文描述： | Pin-Selectable Watchdog Timers |
| 中文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO8 |
| 封裝： | SOT-23, 8 PIN |
| 文件頁數： | 6/8頁 |
| 文件大?。?/td> | 114K |
| 代理商： | MAX6369KA-T |
M
Pin-Selectable Watchdog Timers
6
_______________________________________________________________________________________
Watchdog Timeout Period:
Normal operating watchdog timeout period after the
initial startup delay.
A watchdog output pulse is asserted if a valid watch-
dog input transition is not received before the timeout
period elapses.
Eight pin-selectable timeout period options for each
device, from 30μs to 60s.
Pin-selectable watchdog timer disable feature.
Watchdog Output/Timing Options:
Open drain, active low with 100ms minimum watch-
dog output pulse (MAX6369/MAX6371/MAX6373).
Push-pull, active low with 1ms minimum watchdog
output pulse (MAX6370/MAX6372/MAX6374).
Each device has a watchdog startup delay that is initi-
ated when the supervisor is first powered or after the
user modifies any of the logic control set inputs. The
watchdog timer does not begin to count down until the
V
CC
WDI
WDO
t
SETUP
t
DELAY
t
WD
t
WD
t
WD
t
WDO
A
B
C
D
E
F
G
TRANSITIONS ON WDI IGNORED DURING SETUP DELAY.
TRANSITION(S) ON WDI IGNORED DURING STARTUP DELAY PERIOD.
WATCHDOG TIMER STARTS AFTER STARTUP DELAY AND WDO IS DEASSERTED.
TRANSITION OCCURS BEFORE WATCHDOG TIMEOUT PERIOD. WATCHDOG
TIMER CLEARS AND STARTS TIMER AGAIN.
WATCHDOG TIMES OUT, WDO ASSERTS.
TRANSITIONS ON WDI IGNORED WHEN WDO ASSERTED.
WATCHDOG TIMER STARTS AFTER WDO DEASSERTS.
A
A
B
C
D
E
F
G
E
Figure 2. Watchdog Timing
WATCHDOG
TIMER CIRCUITRY
TRANSITION
DETECTOR
ENABLE
SET WATCHDOG TIMEOUT
SET STARTUP DELAY
MAX6369–MAX6374
EN
CONTROL
LOGIC
SET 2
SET 1
SET 0
V
CC
GND
CLEAR
WDO
OUT
WDI
OUTPUT
Figure 1. Functional Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| MAX6399 | High-Voltage, Overvoltage/Undervoltage, Protection Switch Controller |
| MAX6399ATA-T | High-Voltage, Overvoltage/Undervoltage, Protection Switch Controller |
| MAX6400BS27-T | Analog IC |
| MAX6400-MAX6405 | レP Supervisory Circuits in 4-Bump (2 x 2) Chip-Scale Package |
| MAX6400 | レP Supervisory Circuits in 4-Bump (2 x 2) Chip-Scale Package |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX636AC/D | 功能描述:直流/直流開關調節器 Preset/Adjustable Output CMOS Inverting Switching Regulators RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MAX636ACJA | 功能描述:直流/直流開關調節器 RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MAX636ACPA | 功能描述:直流/直流開關調節器 Preset/Adjustable Invert Switching Reg RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MAX636ACPA+ | 功能描述:直流/直流開關調節器 Preset/Adjustable Invert Switching Reg RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
| MAX636ACSA | 功能描述:直流/直流開關調節器 Preset/Adjustable Invert Switching Reg RoHS:否 制造商:International Rectifier 最大輸入電壓:21 V 開關頻率:1.5 MHz 輸出電壓:0.5 V to 0.86 V 輸出電流:4 A 輸出端數量: 最大工作溫度: 安裝風格:SMD/SMT 封裝 / 箱體:PQFN 4 x 5 |
發布緊急采購，3分鐘左右您將得到回復。