- 您現在的位置：買賣IC網 > PDF目錄2011 > MAX5895EGK+D (Maxim Integrated Products)IC DAC 16BIT 500MSPS DUAL 68-QFN PDF資料下載
參數資料
| 型號： | MAX5895EGK+D |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 18/31頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 16BIT 500MSPS DUAL 68-QFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 30 |
| 設置時間： | 11ns |
| 位數： | 16 |
| 數據接口： | 并聯 |
| 轉換器數目： | 2 |
| 電壓電源： | 模擬和數字 |
| 功率耗散（最大）： | 511mW |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 68-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 68-QFN 裸露焊盤（10x10） |
| 包裝： | 管件 |
| 輸出數目和類型： | 2 電流，單極 |
| 采樣率（每秒）： | 500M |
| 產品目錄頁面： | 1398 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁
their default values in Table 2. During power-on, RESET
must be held low until all power supplies have stabi-
lized. Alternatively, programming bit 5 of address 00h
to a logic-high also resets the MAX5895 after power-up.
Power-Down Mode
The MAX5895 features three power-saving modes.
Each DAC can be individually powered down through
bits 2 and 3 of address 00h. The interpolation filters can
also be powered down through bit 4 of address 00h,
preserving the output level of each DAC (the DACs
remain powered). Powering down both DACs will auto-
matically put the MAX5895 into full power-down, includ-
ing the interpolation filters.
Applications Information
Frequency Planning
System designers need to take the DAC into account
during frequency planning for high-performance appli-
cations. Proper frequency planning can ensure that
optimal system performance is achieved. The
MAX5895 is designed to deliver excellent dynamic per-
formance across wide bandwidths, as required for
communication systems and, in particular, for multicar-
rier applications. As with all DACs, some combinations
of output frequency and update rate produce better
performance than others.
Harmonics are often folded down into the band of inter-
est. Specifically, if the DAC outputs a frequency close
to fS/N, the Mth harmonic of the output signal will be
aliased down to:
Thus, if N
≈ (M + 1), the Mth harmonic will be close to
the output frequency. SFDR performance of a current-
steering DAC is often dominated by third-order har-
monic distortion. If this is a concern, placing the output
signal at a different frequency other than fS/4 should be
considered.
Common to interpolating DACs are images near the
divided clocks. In a DAC configured for 4x interpolation
this applies to images around fS/4 and fS/2. In a DAC
configured for 8x interpolation this applies to images
around fS/8, fS/4, and fS/2. Most of these images are
not part of the in-band (0 to fDATA/2) SFDR specifica-
tion, though they are a consideration for out-of-band
(fDATA/2 - fDAC/2) SFDR and may depend on the rela-
tionship of the DATACLK to DAC update clock (see the
Data Clock section). When specifying the output recon-
struction filter for other than baseband signals, these
images should not be ignored.
Data Clock
The MAX5895 features synchronizers that allow for
arbitrary phase alignment between DATACLK and
CLKP/CLKN. The DATACLK causes internal switching
in the MAX5895 and the phase between DATACLK
(input mode) to CLKP/CLKN will influence the images
at DATACLK. Optimum image rejection is achieved
when DATACLK transitions are aligned with the falling
edge of CLKP. Figure 14 shows the image level near
DATACLK as a function of the DATACLK (input mode)
to CLKP/CLKN phase at 500Msps, 4x interpolation for a
10MHz, -6dBFS output signal.
Clock Interface
The MAX5895 features a flexible differential clock input
(CLKP, CLKN) with a separate supply (AVCLK) to
achieve optimum jitter performance. It uses an ultra-low
jitter clock to achieve the required noise density. Clock
jitter must be less than 0.5psRMS to meet the specified
noise density. For that reason, the CLKP/CLKN input
source must be designed carefully. The differential
clock (CLKN and CLKP) input can be driven from a sin-
gle-ended or a differential clock source. Differential
clock drive is required to achieve the best dynamic
performance from the DAC. For single-ended opera-
tion, drive CLKP with a low noise source and bypass
CLKN to GND with a 0.1F capacitor.
The CLKP and CLKN pins are internally biased to
AVCLK/2. This allows the user to AC-couple clock
ff
M x f
f
NM
N
S
OUT
S
==
MAX5895
16-Bit, 500Msps Interpolating and Modulating
Dual DAC with CMOS Inputs
______________________________________________________________________________________
25
Figure 14. Effect of CLKP/CLKN to DATACLK Phase on fS/4
Images
fS/4 IMAGES vs. CLKP/CLKN to DATACLK DELAY
fDATA = 125MWps, 4x INTERPOLATION
CLKP/CLKN DELAY (ns)
IMAGE
LEVEL
(dBc)
6.0
4.0
2.0
-100
-90
-80
-70
-60
-50
-110
0
8.0
fS/4 - fOUT
fOUT = 10MHz
AOUT = -6dBFS
fS/4 + fOUT
相關PDF資料 |
PDF描述 |
|---|---|
| MAX5898EGK+D | IC DAC 16BIT DUAL 500MSPS 68-QFN |
| MAX6900ETT+T | IC RTC I2C COMPAT 6-TDFN |
| MAX6902ETA+T | IC RTC SPI COMPAT 8-TDFN |
| MAX7375AXR604+T | IC OSC SILICON SC70-3 |
| MAX7394ATTLY+T | IC OSC SILICON 922KHZ 6-TDFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX5895EGK-TD | 功能描述:數模轉換器- DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5895EVCMOD2 | 功能描述:數模轉換器- DAC Evaluation Kit for the MAX5893/MAX5894/MAX5895 RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5895EVKIT | 功能描述:數模轉換器- DAC Evaluation Kit for the MAX5893/MAX5894/MAX5895 RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5898EGK+D | 功能描述:數模轉換器- DAC 16-Bit 2Ch 500Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| MAX5898EGK+TD | 功能描述:數模轉換器- DAC 16-Bit 2Ch 500Msps DAC RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。