參數資料
型號： MAX5482EUD+T
廠商： Maxim Integrated Products
文件頁數： 8/20頁
文件大?。?/td> 0K
描述： IC POT DGTL 10BIT NV 14-TSSOP
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 2,500
接片： 1024
電阻（歐姆）： 50k
電路數： 1
溫度系數： 標準值 35 ppm/°C
存儲器類型： 非易失
接口： 4 線串行（芯片選擇，遞增，增/減）
電源電壓： 2.7 V ~ 5.25 V，±2.5 V ~ 5.25 V
工作溫度： -40°C ~ 85°C
安裝類型： 表面貼裝
封裝/外殼： 14-TSSOP（0.173"，4.40mm 寬）
供應商設備封裝： 14-TSSOP
包裝： 帶卷 (TR)
10-Bit, Nonvolatile, Linear-Taper Digital
Potentiometers
Copy Wiper Register to NV Register
The copy wiper register to NV register command (C1,
C0 = 10) stores the current position of the wiper to the
NV register for use at power-up. Figure 6 shows how to
copy data from wiper register to NV register. The oper-
ation takes up to 12ms (max) after
CS goes high to
complete and no other operation should be performed
until completion.
Copy NV Register to Wiper Register
The copy NV register to wiper register (C1, C0 = 11)
restores the wiper position to the current value stored in
the NV register. Figure 7 shows how to copy data from
the NV register to the wiper register.
Digital Up/Down Interface
Figure 8 illustrates an up/down serial-interface timing
diagram. In digital up/down interface mode (SPI/
UD =
0), the logic inputs
CS, DIN(U/D), and SCLK(INC) con-
trol the wiper position and store it in nonvolatile memory
(see Table 3). The chip-select (
CS) input enables the
serial interface when low and disables the interface
when high. The position of the wiper is stored in the
nonvolatile register when
CS transitions from low to
high while SCLK(
INC) is high.
When the serial interface is active (
CS low), a high-to-
low (falling edge) transition on SCLK(
INC) increments
or decrements the internal 10-bit counter depending on
the state of DIN(U/
D). If DIN(U/D) is high, the wiper
increments. If DIN(U/
D) is low, the wiper decrements.
The device stores the value of the wiper position in the
nonvolatile memory when
CS transitions from low to high
while SCLK(
INC) is high. The host system can disable
the serial interface and deselect the device without stor-
ing the latest wiper position in the nonvolatile memory by
keeping SCLK(
INC) low while taking CS high.
Upon power-up, the MAX5481–MAX5484 load the
value of nonvolatile memory into the wiper register, and
set the wiper position to the value last stored.
ACTION
00
1
0
00
0
12
3
4
5
6
78
CS
C1
C0
WRITE NV
REGISTER
(DEVICE IS
BUSY)
tBUSY
SCLK(INC)
DIN(U/D)
Figure 6. Copy Wiper Register to NV Register Operation
CS
DIN(U/D)
SCLK(INC)W
LL
↓
Decrement
LH
↓
Increment
LX
↑
No Change
H
X
No Change
↓
X
No Change
↑
X
L
Position Not Stored
↑
X
H
Position Stored
Table 3. Truth Table
↑ = Low-to-high transition.
↓ = High-to-low transition.
X
= Don’t care.
ACTION
00
1
00
0
12
3
4
5
6
78
CS
C1
C0
WIPER
REGISTER
UPDATED
SCLK(INC)
DIN(U/D)
Figure 7. Copy NV Register to Wiper Register Operation
MAX5481–MAX5484
16
Maxim Integrated
相關PDF資料
PDF描述
7SB3125AMX1TCG 1 BIT BUS SWITCH ULLGA 6
DS1855B-010+T&R IC POT/MEM DIG NV 10/10K 16BGA
DS1845B-050+T&R IC POT/MEM DUAL NV 50K 16-BGA
DS1845B-010+T&R IC POT/MEM DUAL NV 10K 16-BGA
7SB3125MUTCG 1 BIT BUS SWITCH UDFN6
相關代理商/技術參數
參數描述
MAX5483ETE 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5483ETE+ 功能描述:數字電位計 IC 10-Bit Nonvolatile Linear-Taper RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5483ETE+T 功能描述:數字電位計 IC 10-Bit Nonvolatile Linear-Taper RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5483ETE-T 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
MAX5483EUD 功能描述:數字電位計 IC RoHS:否 制造商:Maxim Integrated 電阻:200 Ohms 溫度系數:35 PPM / C 容差:25 % POT 數量:Dual 每 POT 分接頭:256 弧刷存儲器:Volatile 緩沖刷: 數字接口:Serial (3-Wire, SPI) 描述/功能:Dual Volatile Low Voltage Linear Taper Digital Potentiometer 工作電源電壓:1.7 V to 5.5 V 電源電流:27 uA 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:TQFN-16 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*