- 您現在的位置：買賣IC網 > PDF目錄11412 > MAX4785EXK+T (Maxim Integrated Products)IC ANALOG SWITCH 1X1 SC70-5 PDF資料下載
參數資料
| 型號： | MAX4785EXK+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 9/10頁 |
| 文件大小： | 0K |
| 描述： | IC ANALOG SWITCH 1X1 SC70-5 |
| 產品培訓模塊： | ISP Current Limit Switches Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 1 |
| 功能： | 開關 |
| 電路： | 1 x 1:1 |
| 導通狀態電阻： | 1 歐姆 |
| 電壓電源： | 單電源 |
| 電壓 - 電源，單路/雙路(±)： | 2.3 V ~ 5.5 V |
| 電流 - 電源： | 65µA |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 6-TSSOP（5 引線），SC-88A，SOT-353 |
| 供應商設備封裝： | SC-70-5 |
| 包裝： | 標準包裝 |
| 產品目錄頁面： | 1421 (CN2011-ZH PDF) |
| 其它名稱： | MAX4785EXK+TDKR |
MAX4785–MAX4788
The switches with autoretry feature turn back on when
the device temperature drops approximately 15°C. The
switches with latchoff feature require ON cycling.
Applications Information
Input Capacitor
To limit the input voltage drop during momentary output
short-circuit conditions, connect a capacitor from IN to
GND. A 0.1F ceramic capacitor is adequate for most
applications; however, higher capacitor values further
reduce the voltage drop at the input and are recom-
mended for lower voltage applications.
Output Capacitance
Connect a 0.1F capacitor from OUT to GND. This
capacitor helps prevent inductive parasitics from
pulling OUT negative during turn-off, thus preventing
the MAX4785–MAX4788 from tripping erroneously. If
the load capacitance is too large, then current may not
have enough time to charge the capacitance and the
device assumes that there is a faulty load condition.
The maximum capacitive load value that can be driven
from OUT is obtained by the following formula:
Layout and Thermal Dissipation
To optimize the switch response time to output short-
circuit conditions, it is very important to keep all traces
as short as possible to reduce the effect of undesirable
parasitic inductance. Place input and output capacitors
as close as possible to the device (no more than 5mm).
IN and OUT pins must be connected with short traces
to the power bus.
During normal operation, the power dissipation is small
and the package temperature change is minimal. If the
output is continuously shorted to ground at the maxi-
mum supply voltage, the operation of the switches with
the autoretry option does not cause problems because
the total power dissipated during the short is scaled by
the duty cycle:
where VIN = 5.5V, IOUT = 240mA, tBLANK = 14ms, and
tRETRY = 98ms.
Attention must be given to the MAX4785 and MAX4787
where the latch-off condition must be manually reset by
toggling ON from high to low. If the latch-off time dura-
tion is not sufficiently high, it is possible for the device
to reach the thermal-shutdown threshold and never be
able to turn the device on until it cools down.
P
VI
t
tt
mW
MAX
IN MAX
OUT MAX
BLANK
RETRY
BLANK
=
××
+
=
__
161
C
It
V
MAX
FWD MIN
BLANK MIN
IN
<
×
__
50mA/100mA Current-Limit Switches
8
_______________________________________________________________________________________
LOAD
CURRENT
SWITCH
STATUS
tBLANK
OFF
ON
ON PIN
VOLTAGE
(a)
(b)
UVLO
FLAG
PIN STATUS
LOAD
CURRENT
SWITCH
STATUS
OFF
ON
IN PIN
VOLTAGE
FLAG
PIN STATUS
tBLANK
Figure 3. MAX4785/MAX4787 Latch Off Fault Blanking
Selector Guide
PART
CURRENT
LIMIT (mA)
FLAG
FUNCTION
AUTO-
RETRY
MAX4785EXS
50
No
MAX4785EXK
50
Yes
No
MAX4786EXS
50
No
Yes
MAX4787EXS
100
No
MAX4787EXK
100
Yes
No
MAX4788EXS
100
No
Yes
相關PDF資料 |
PDF描述 |
|---|---|
| DSPIC33FJ16GS402-H/SO | IC DSC 16BIT 16KB FLASH 28-SOIC |
| PIC18F6493T-I/PT | IC PIC MCU FLASH 8KX16 64TQFP |
| GRM31MR71H184KA01L | CAP CER 0.18UF 50V 10% X7R 1206 |
| PIC18F2423-E/SO | IC PIC MCU FLASH 8KX16 28SOIC |
| DSPIC30F3010-20E/SO | IC DSPIC MCU/DSP 24K 28SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4785EXS | 制造商:Maxim Integrated Products 功能描述:50MA/100MA CURRENT-LIMIT SWITCHES - Cut Tape Product |
| MAX4785EXS-T | 功能描述:電源開關 IC - 配電 RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MAX4786EXS | 制造商:Maxim Integrated Products 功能描述:50MA/100MA CURRENT-LIMIT SWITCHES - Cut Tape Product |
| MAX4786EXS+ | 制造商:Maxim Integrated Products 功能描述:CURRENT LIMIT SW 1-IN 1-OUT 2.3V TO 5.5V 0.12A 4PIN SC-70 - Cut Tape Product |
| MAX4786EXS+T | 功能描述:電源開關 IC - 配電 50mA/100mA Current Limit Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
發布緊急采購，3分鐘左右您將得到回復。