- 您現在的位置：買賣IC網 > PDF目錄385531 > MAX477 (Maxim Integrated Products, Inc.) 300MHz High-Speed Op Amp(300MHz 高速運算放大器) PDF資料下載
參數資料
| 型號： | MAX477 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 300MHz High-Speed Op Amp(300MHz 高速運算放大器) |
| 中文描述： | 300MHz、高速運算放大器 |
| 文件頁數： | 7/12頁 |
| 文件大?。?/td> | 176K |
| 代理商： | MAX477 |
M
300MHz High-S peed Op Amp
_______________________________________________________________________________________
7
_______________Detailed Desc ription
The MAX477 allows the flexibility and ease of a classic
voltage-feedback architecture while maintaining the
high-speed benefits of current-mode feedback (CMF)
amplifiers. Although the MAX477 is a voltage-feedback
op amp, its internal architecture provides an 1100V/μs
slew rate and a low 8mA supply current. CMF ampli-
fiers offer high slew rates while maintaining low supply
current, but use the feedback and load resistors as part
of the amplifier’s frequency compensation network. In
addition, they have only one input with high imped-
ance.
The MAX477 has speed and power specifications like
those of current-feedback amplifiers, but has high input
impedance at both input terminals. Like other voltage-
feedback op amps, its frequency compensation is
independent of the feedback and load resistors, and it
exhibits a constant gain-bandwidth product. However,
unlike standard voltage-feedback amplifiers, its large-
signal slew rate is not limited by an internal current
source, so the MAX477 exhibits a very high full-power
bandwidth.
Output S hort-Circ uit Protec tion
Under short-circuit conditions, the output current is typi-
cally limited to 150mA. This is low enough that a short to
ground of any duration will not cause permanent dam-
age to the chip. However, a short to either supply will
significantly increase the power dissipation and may
cause permanent damage. The high output-
current capability is an advantage in systems that trans-
mit a signal to several loads. See High-Performance
Video Distribution Amplifier in the Applications
Informationsection.
__________Applic ations Information
Grounding, Bypassing,
and PC Board Layout
To obtain the MAX477’s full 300MHz bandwidth, Micro-
strip and Stripline techniques are recommended in
most cases. To ensure the PC board does not degrade
the amplifier’s performance, design the board for a fre-
quency greater than 1GHz. Even with very short traces,
use these techniques at critical points, such as inputs
and outputs. Whether you use a constant-impedance
board or not, observe the following guidelines when
designing the board:
Do not use wire-wrap boards. They are too inductive.
Do not use IC sockets. They increase parasitic
capacitance and inductance.
In general, surface-mount components have shorter
leads and lower parasitic reactance, giving better
high-frequency performance than through-hole com-
ponents.
The PC board should have at least two layers, with
one side a signal layer and the other a ground plane.
Keep signal lines as short and straight as possible.
Do not make 90° turns; round all corners.
The ground plane should be as free from voids as
possible.
_____________________Pin Desc ription
NAME
FUNCTION
1, 5, 8
N.C.
No Connect. Not internally connected.
2
IN-
Inverting Input
PIN
3
IN+
Noninverting Input
4
V
EE
Negative Power Supply
7
V
CC
Positive Power Supply
6
OUT
Amplifier Output
MAX477
V
OUT
= -(R
F
/R
G
) V
IN
V
OUT
V
IN
R
F
R
G
Figure 1a. Inverting Gain Configuration
MAX477
V
OUT
= [1 + (R
F
/R
G
)] V
IN
V
OUT
V
IN
R
F
R
G
Figure 1b. Noninverting Gain Configuration
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4789EUK | 200mA/250mA/300mA Current-Limit Switches |
| MAX4789EUS | 200mA/250mA/300mA Current-Limit Switches |
| MAX4793EUK | 200mA/250mA/300mA Current-Limit Switches |
| MAX4793EUS | 200mA/250mA/300mA Current-Limit Switches |
| MAX4794EUS | 200mA/250mA/300mA Current-Limit Switches |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4772ETT+T | 功能描述:電源開關 IC - 配電 200mA/500mA Select Current-Limit Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MAX4772ETT-T | 功能描述:電源開關 IC - 配電 RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
| MAX4772EUT | 制造商:Maxim Integrated Products 功能描述:- Cut Tape Product |
| MAX4772EUT+ | 制造商:Maxim Integrated Products 功能描述:- Cut Tape Product |
| MAX4772EUT+T | 功能描述:電源開關 IC - 配電 200mA/500mA Select Current-Limit Switch RoHS:否 制造商:Exar 輸出端數量:1 開啟電阻（最大值）:85 mOhms 開啟時間（最大值）:400 us 關閉時間（最大值）:20 us 工作電源電壓:3.2 V to 6.5 V 電源電流（最大值）: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOT-23-5 |
發布緊急采購，3分鐘左右您將得到回復。