- 您現在的位置：買賣IC網 > PDF目錄10834 > MAX4221CSE+ (Maxim Integrated Products)IC SW VIDEO BUFFERED 16-SOIC PDF資料下載
參數資料
| 型號： | MAX4221CSE+ |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 11/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SW VIDEO BUFFERED 16-SOIC |
| 標準包裝： | 50 |
| 應用： | 緩沖器 |
| 電路數： | 2 |
| -3db帶寬： | 330MHz |
| 轉換速率： | 700 V/µs |
| 電流 - 電源： | 4mA |
| 電壓 - 電源，單路/雙路(±)： | ±4.5 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SOIC |
| 包裝： | 管件 |
MAX4111/MAX4121/MAX4221
330MHz Buffered Video Switches/
Crosspoint Building Blocks
8
_______________________________________________________________________________________
__________Applications Information
Grounding, Bypassing,
and PC Board Layout
To obtain the full 330MHz bandwidth of these switches,
Microstrip and Stripline techniques are recommended.
To ensure your PC board does not degrade the
switch’s performance, it’s wise to design the board for
a frequency greater than 1GHz. Even with very short
runs, it’s good practice to use this technique at critical
points such as inputs and outputs.
Use the following guidelines when designing the board:
Do not use wire-wrap boards, because they are too
inductive.
Do not use IC sockets. They increase parasitic
capacitance and inductance.
In general, surface-mount components have shorter
leads and lower parasitic reactance, and give better
high-frequency performance than through-hole com-
ponents.
The PC board should have at least two layers, with
one side a signal side and the other a ground plane.
Keep signal lines as short and straight as possible.
Do not make 90° turns; round all corners.
The ground plane should be as free from voids as
possible.
Bypass Components—Capacitors
Surface-mount ceramic capacitors are recommended
to achieve good high-frequency bypassing. A 0.1F
capacitor in parallel with a 1000pF capacitor should be
used for each supply. The capacitors should be locat-
ed as close to the ICs supply pins as possible, with the
smaller value capacitor being closer to the IC than the
other.
Creating Larger Arrays
The MAX4111/MAX4121/MAX4221 were designed as
building blocks for larger arrays. The single-pole switch
allows the system designer much greater control over
crosstalk than multiple switches in a single IC. For this
reason, cable drivers have not been included in the
switch design because of the high-power drive
required (see Figure 6).
Even though the stability of these devices is not wors-
ened by adding capacitance, you may want to limit the
number of switches connected together. The
MAX4111/MAX4121/MAX4221 have a finite input capa-
citance of about 3pF and a dynamic output resistance
of about 20
. This causes a pole at a little more than
2.7GHz. However, in a large array with many switch
inputs, the total capacitance is N x 3pF, where “N” is
the number of switches connected in parallel. The pole
will be located at:
CSTRAY = Stray capacitance at the interconnect
If the maximum number of switches that may be con-
nected while still maintaining bandwidth is less than
your system requirements, use a unity-gain buffer
amplifier to isolate the switch from the remainder of the
inputs.
1
23
20
π
(
)
xN x
pF C
x
MHz
STRAY
+
Table 1. MAX4111 Truth Table
Table 2. MAX4121 Truth Table
Table 3. MAX4221 Truth Table
EN
OUT
0
High-Z
1
IN
A0
EN
OUT
X
0
High-Z
0
1
IN0
1
IN1
Note: SEL0 = SEL1 = 1 and/or SEL2 = SEL3 = 1 is not
allowed. Enabling these states will not damage the device,
but may cause excessive supply currents and distortion.
NA
1
IN3
1
0
IN2
0
1
High-Z
0
OUT1
SEL3
SEL2
NA
1
IN1
1
0
IN0
0
1
High-Z
0
OUT0
SEL1
SEL0
相關PDF資料 |
PDF描述 |
|---|---|
| MAX4158EUA+ | IC VIDEO MUX/AMP 8-UMAX |
| MAX4188ESD+ | IC AMP CURRENT SENSE 14-SOIC |
| MAX5151BCPE+ | IC DAC 13BIT DUAL LP SER 16-DIP |
| MAX4189ESD+ | IC AMP CURRENT SENSE 14-SOIC |
| MAX4258EUA+ | IC AMP VIDEO MUX 2CH 8-UMAX |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX4221CSE+ | 功能描述:視頻開關 IC RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel |
| MAX4221CSE+T | 功能描述:視頻開關 IC RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel |
| MAX4221CSE-T | 功能描述:視頻開關 IC RoHS:否 制造商:Texas Instruments 開關數量:4 開啟電阻（最大值）:12 Ohms 傳播延遲時間: 開啟時間（最大值）: 關閉時間（最大值）: 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:WQFN-42 封裝:Reel |
| MAX4221EVKIT-SO | 功能描述:EVALUATION KIT FOR MAX4221 RoHS:否 類別:編程器，開發系統 >> 過時/停產零件編號 系列:- 標準包裝:1 系列:- 傳感器類型:CMOS 成像，彩色（RGB） 傳感范圍:WVGA 接口:I²C 靈敏度:60 fps 電源電壓:5.7 V ~ 6.3 V 嵌入式:否 已供物品:成像器板 已用 IC / 零件:KAC-00401 相關產品:4H2099-ND - SENSOR IMAGE WVGA COLOR 48-PQFP4H2094-ND - SENSOR IMAGE WVGA MONO 48-PQFP |
| MAX4222EEE | 功能描述:高速運算放大器 RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。