- 您現在的位置：買賣IC網 > PDF目錄9539 > MAX3311ECUB (Maxim Integrated Products)IC TXRX RS232 460KBPS 10-UMAX PDF資料下載
參數資料
| 型號： | MAX3311ECUB |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 5/8頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC TXRX RS232 460KBPS 10-UMAX |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 50 |
| 類型： | 收發器 |
| 驅動器/接收器數： | 1/1 |
| 規程： | RS232 |
| 電源電壓： | 4.5 V ~ 5.5 V |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 10-TFSOP，10-MSOP（0.118"，3.00mm 寬） |
| 供應商設備封裝： | 10-µMAX |
| 包裝： | 管件 |
Detailed Description
Single Charge-Pump Voltage Converter
The MAX3311E/MAX3313E internal power supply has a
single inverting charge pump that provides a negative
voltage from a single +5V supply. The charge pump
operates in a discontinuous mode and requires a flying
capacitor (C1) and a reservoir capacitor (C2) to gener-
ate the V- supply.
RS-232-Compatible Driver
The transmitter is an inverting level translator that con-
verts CMOS-logic levels to EIA/TIA-232 compatible lev-
els. It guarantees data rates up to 460kbps with
worst-case loads of 3k
in parallel with 1000pF. When
SHDN is driven low, the transmitter is disabled and put
into tri-state. The transmitter input does not have an
internal pullup resistor.
RS-232 Receiver
The MAX3311E/MAX3313E receiver converts RS-232
signals to CMOS-logic output levels. The MAX3311E
receiver will remain active during shutdown mode. The
MAX3313E INVALID indicates when an RS-232 signal
is present at the receiver input, and therefore when the
port is in use.
The MAX3313E INVALID output is pulled low when no
valid RS-232 signal level is detected on the receiver
input.
MAX3311E Shutdown Mode
In shutdown mode, the charge pump is turned off, V- is
pulled to ground, and the transmitter output is disabled
(Table 1). This reduces supply current typically to 1A.
The time required to exit shutdown is less than 25ms.
Applications Information
Capacitor Selection
The capacitor type used for C1 and C2 is not critical for
proper operation; either polarized or nonpolarized
capacitors are acceptable. If polarized capacitors are
used, connect polarity as shown in the Typical
Operating Circuit. The charge pump requires 0.1F
capacitors. Increasing the capacitor values (e.g., by a
factor of 2) reduces power consumption. C2 can be
increased without changing C1’s value. However, do
not increase C1’s value without also increasing the
value of C2 and CBYPASS to maintain the proper ratios
(C1 to the other capacitors).
When using the minimum 0.1F capacitors, make sure
the capacitance does not degrade excessively with
temperature. If in doubt, use capacitors with a larger
nominal value. The capacitor’s equivalent series resis-
tance (ESR) usually rises at low temperatures and influ-
ences the amount of ripple on V-.
To reduce the output impedance at V-, use larger
capacitors (up to 10F).
Bypass VCC to ground with at least 0.1F. In applica-
tions sensitive to power-supply noise generated by the
charge pump, decouple VCC to ground with a capaci-
tor the same size as (or larger than) charge-pump
capacitors C1 and C2.
Transmitter Output when Exiting
Shutdown
Figure 1 shows the transmitter output when exiting
shutdown mode. The transmitter is loaded with 3k
in
parallel with 1000pF. The transmitter output displays no
ringing or undesirable transients as the MAX3311E
comes out of shutdown. Note that the transmitter is
enabled only when the magnitude of V- exceeds
approximately -3V.
High Data Rates
The MAX3311E/MAX3313E maintain RS-232-compati-
ble ±3.7V minimum transmitter output voltage even at
MAX3311E/MAX3313E
±15kV ESD-Protected, 460kbps, 1A,
RS-232-Compatible Transceivers in MAX
_______________________________________________________________________________________
5
Table 1. MAX3311E Shutdown Logic
Truth Table
SHDN
TRANSMITTER
OUTPUT
RECEIVER
OUTPUT
CHARGE
PUMP
L
High Z
Active
Inactive
H
Active
Figure 1. Transmitter Output when Exiting Shutdown or
Powering Up
10
s/div
SHDN
TOUT
5V/div
0
1.5V/div
0
TIN = GND
TIN = VCC
相關PDF資料 |
PDF描述 |
|---|---|
| MAX3311CUB | IC TXRX RS232 460KBPS 10-UMAX |
| MS27474T16F35PB | CONN RCPT 55POS JAM NUT W/PINS |
| VE-B31-IV-B1 | CONVERTER MOD DC/DC 12V 150W |
| VE-BWT-MY-S | CONVERTER MOD DC/DC 6.5V 50W |
| MAX3238CAI | IC TXRX RS232 250KBPS 28-SSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX3311ECUB+ | 功能描述:RS-232接口集成電路 460kbps 1uA Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3311ECUB+ | 制造商:Maxim Integrated Products 功能描述:IC RS232 TRANSCEIVER 460KBPS 5 |
| MAX3311ECUB+T | 功能描述:RS-232接口集成電路 460kbps 1uA Transceiver RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3311ECUB-T | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
| MAX3311EEUB | 功能描述:RS-232接口集成電路 RoHS:否 制造商:Exar 數據速率:52 Mbps 工作電源電壓:5 V 電源電流:300 mA 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-100 封裝: |
發布緊急采購，3分鐘左右您將得到回復。