- 您現在的位置：買賣IC網 > PDF目錄11124 > MAX312FESE+T (Maxim Integrated Products)IC SWITCH QUAD SPST 16SOIC PDF資料下載
參數資料
| 型號： | MAX312FESE+T |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 2/15頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC SWITCH QUAD SPST 16SOIC |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 功能： | 開關 |
| 電路： | 4 x SPST - NC |
| 導通狀態電阻： | 10 歐姆 |
| 電壓電源： | 單/雙電源 |
| 電壓 - 電源，單路/雙路(±)： | 4.5 V ~ 30 V，±4.5 V ~ 20 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 16-SOIC |
| 包裝： | 帶卷 (TR) |
MAX312F/MAX313F/MAX314F
state. If the switch state is off, all FETs are turned off and
both NO_ (or NC_) and COM_ are high impedance.
Negative Fault Condition
When the signal on NO_ (or NC_) and COM_ exceeds V-,
the low-fault comparator output is high, turning off FETs
N1 and P1. This makes the NO_ (or NC_) and COM_ pins
high impedance regardless of the switch state. If the
switch state is off, all FETs are turned off and both NO_
(or NC_) and COM_ are high impedance.
Transient Fault Response and Recovery
When a fast rise-time and fall-time transient on NO_,
NC_, or COM_ exceeds V+ or V-, the output follows the
input to the supply rail with only a few nanoseconds
delay. This delay is due to the switch on-resistance and
circuit capacitance to ground. When the input transient
returns to within the supply rails, however, there is a
longer output recovery time delay. For positive faults,
the recovery time is typically 1s. For negative faults,
the recovery time is typically 0.6s. These values
depend on the output resistance and capacitance, and
are not production tested or guaranteed. The delays
are not dependent on the fault amplitude. Higher load
resistance and capacitance increase recovery times.
Fault-Protection Voltage and Power Off
The maximum fault voltage on the NO_ (or NC_) and
COM_ pins is ±36V with power applied and ±40V with
power off.
Failure Modes
Exceeding the fault-protection voltage limits on NO_,
NC_, or COM_, even for very short periods, can cause
the device to fail (see the Absolute Maximum Ratings).
The failure modes may not be obvious, and failure in
one switch may or may not affect other switches in the
same package.
Ground
There is no galvanic connection between the analog
signal paths and GND. The analog signal paths consist
of an N-channel and P-channel MOSFET with their
sources and drains paralleled and their gates driven
out of phase to V+ and V- by the logic-level translators.
However, the potential of the analog signals must be
defined or at least limited with respect to GND.
V+ and GND power the internal logic and logic-level
translators and set the input logic thresholds. The logic-
level translators convert the logic levels to switched V+
and V- signals to drive the gates of the analog switch-
es. This drive signal is the only connection between the
power supplies and the analog signals.
Bipolar Supplies
The MAX312F/MAX313F/MAX314F operate with bipolar
supplies between ±4.5V and ±20V. The V+ and V- sup-
plies need not be symmetrical, but their difference can-
not exceed the absolute maximum rating of 44V.
Single Supply
The MAX312F/MAX313F/MAX314F operate from a sin-
gle supply between +9V and +36V when V- is connect-
ed to GND.
Quad, Rail-to-Rail, Fault-Protected,
SPST Analog Switches
10
______________________________________________________________________________________
Ordering Information (continued)
PART
TEMP RANGE
PIN-PACKAGE
MAX313FESE
-40°C to +85°C
16 SO
MAX313FEPE
-40°C to +85°C
16 Plastic DIP
MAX314FESE
-40°C to +85°C
16 SO
MAX314FEPE
-40°C to +85°C
16 Plastic DIP
Chip Information
TRANSISTOR COUNT: 251
PROCESS: CMOS
SUBSTRATE CONNECTED TO: V+
相關PDF資料 |
PDF描述 |
|---|---|
| VE-2W4-IY-F2 | CONVERTER MOD DC/DC 48V 50W |
| MAX398CSE+T | IC MULTIPLEXER 8X1 16SOIC |
| VE-2W4-IY-F1 | CONVERTER MOD DC/DC 48V 50W |
| MAX398CSE+TG55 | IC MULTIPLEXER 8X1 16SOIC |
| MAX399CSE+T | IC MULTIPLEXER DUAL 4X1 16SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX312LCPE | 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX312LCPE+ | 功能描述:模擬開關 IC 10Ohm Quad SPST CMOS RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX312LCSE | 功能描述:模擬開關 IC RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX312LCSE+ | 功能描述:模擬開關 IC 10Ohm Quad SPST CMOS RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX312LCSE+T | 功能描述:模擬開關 IC 10Ohm Quad SPST CMOS RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
發布緊急采購，3分鐘左右您將得到回復。