- 您現在的位置：買賣IC網 > PDF目錄385522 > MAX1802 (Maxim Integrated Products, Inc.) Digital Camera Step-Down Power Supply PDF資料下載
參數資料
| 型號： | MAX1802 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | Digital Camera Step-Down Power Supply |
| 中文描述： | 數碼相機降壓型電源 |
| 文件頁數： | 17/28頁 |
| 文件大?。?/td> | 469K |
| 代理商： | MAX1802 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
M
Digital Camera Step-Down
Power Supply
______________________________________________________________________________________
17
trollers regulate their output voltages by modulating the
pulse width of the drive signal for an external N-channel
MOSFET switch. The auxiliary controllers are inactive
until the main output has started.
Figure 3 shows a block diagram for a MAX1802 auxil-
iary PWM controller. The sawtooth oscillator signal at
OSC governs the internal timing. At the beginning of
each cycle, DL_ goes high to turn on the external MOS-
FET switch. The MOSFET switch turns off when the
internally level-shifted sawtooth rises above COMP_ or
when the maximum duty cycle is exceeded. The switch
remains off until the beginning of the next cycle. An
internal transconductance amplifier establishes an inte-
grated error voltage at COMP_, thereby increasing the
loop gain for improved regulation accuracy.
Power-Up Sequence
The MAX1802 is in the shutdown state with all circuitry
off when the ONM input is low (<1.3V). When ONM
goes high, an internal linear regulator generates 3V at
the VL output from the VDDM input to power internal
circuitry. As VL rises above the 2.4V undervoltage lock-
out threshold, the internal reference and oscillator
begin to function and the main DC-DC converter
begins soft-start operation. The main DC-DC output
reaches full regulation voltage after 1024 soft-start
oscillator cycles. Once the main DC-DC converter com-
pletes soft-start, the core DC-DC converter and the
auxiliary DC-DC controllers are enabled.
As the voltage at VDDC rises above 2.4V, the internal
linear regulator turns off and an internal 3
switch con-
nects VL directly to VDDC, which is typically connected
to the output of the main DC-DC converter.
The core DC-DC converter and the auxiliary DC-DC
controllers have independent on-off control and soft-
start. The main DC-DC converter shuts down with a low
input at ONM. The core DC-DC converter shuts down
with a low input at ONC. Turn auxiliary DC-DC convert-
er 1 off by driving either ON1 or DCON1 to GND. Turn
off auxiliary controller 2 or 3 by driving DCON2 or
DCON3 to GND.
Reference
The MAX1802 has an internal 1.248V, 1% reference.
Connect a 0.1μF bypass capacitor from REF to GND
within 0.2in (5mm) of the REF pin. REF can source up
to 200μA of external load current, and it is enabled
whenever ONM is high and VL is above the undervolt-
R
Q
DL_
S
CLK
FAULT
PROTECTION
LEVEL
SHIFT
REF
COMP_
FB_
DCON_
OSC
SOFT-
START
Figure 3. Auxiliary Controller Block Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1802EHJ | Digital Camera Step-Down Power Supply |
| MAX1804 | External Four-Input Feedback Integrator for Power Supplies |
| MAX1804EUB | External Four-Input Feedback Integrator for Power Supplies |
| MAX1809 | 3A, 1MHz, DDR Memory Termination Supply |
| MAX1809EEE | 3A, 1MHz, DDR Memory Termination Supply |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1802EHJ | 功能描述:直流/直流開關轉換器 Step-Up Slave DC/DC Controller RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1802EHJ+ | 功能描述:直流/直流開關轉換器 Step-Up Slave DC/DC Controller RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1802EHJ+T | 功能描述:直流/直流開關轉換器 Step-Up Slave DC/DC Controller RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1802EHJ-T | 功能描述:直流/直流開關轉換器 Step-Up Slave DC/DC Controller RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1804EUB | 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。