- 您現在的位置：買賣IC網 > PDF目錄383334 > MAX1775 (Maxim Integrated Products, Inc.) 32-Bit Digital Signal Controller with ROM 100-LQFP -40 to 125 PDF資料下載
參數資料
| 型號： | MAX1775 |
| 廠商： | Maxim Integrated Products, Inc. |
| 英文描述： | 32-Bit Digital Signal Controller with ROM 100-LQFP -40 to 125 |
| 中文描述： | 雙輸出、降壓型DC-DC轉換器，用于PDA/掌上電腦 |
| 文件頁數： | 11/15頁 |
| 文件大小： | 290K |
| 代理商： | MAX1775 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁
M
Dual-Output Step-Down
DC-DC Converter for PDA/Palmtop Computers
______________________________________________________________________________________
11
Regulation Control Scheme
The MAX1775 has a unique operating scheme that
allows PWM operation at medium and high current, with
automatic switching to pulse-skipping mode at lower
currents to improve light-load efficiency. Figure 2
shows a simplified block diagram.
Under medium- and heavy-load operation, the inductor
current is continuous and the part operates in PWM
mode. In this mode, the switching frequency is set by
either the minimum on-time or the minimum off-time,
depending on the duty cycle. The duty cycle is approx-
imately the output voltage divided by the input voltage.
If the duty cycle is less than 50%, the minimum on-time
controls the frequency; and the frequency is approxi-
mately f
≈
2.5MHz
D, where D is the duty cycle. If the
duty cycle is greater than 50%, the minimum off-time
sets the frequency; and the frequency is approximately
f
≈
2.5MHz
(1 - D).
In both cases, the voltage is regulated by the error
comparator. For low duty cycles (<50%), the P-channel
MOSFET turns on for the minimum on-time, causing
fixed-on-time operation. During the P-channel MOSFET
on-time, the output voltage rises. Once the P-channel
MOSFET turns off, the voltage drops to the regulation
threshold, at which time another cycle is initiated. For
high duty cycles (>50%), the P-channel MOSFET
remains off for the minimum off-time, causing fixed off-
time operation. In this case, the P-channel MOSFET
remains on until the output voltage rises to the regula-
tion threshold. Then the P-channel MOSFET turns off for
the minimum off-time, initiating another cycle.
By switching between fixed on-time and fixed off-time
operation, the MAX1775 can operate at high input-out-
put ratios, yet still operate up to 100% duty cycle for
low dropout. Note that when operating in fixed on-time,
the minimum output voltage is regulated; but in fixed
off-time operation, the maximum output voltage is regu-
lated. Thus, as the input voltage drops below approxi-
mately twice the output voltage, a decrease in line
regulation can be expected. The drop in voltage is
approximately V
DROP
≈
V
RIPPLE
. At light output loads,
the inductor current is discontinuous, causing the
MAX1775 to operate at lower frequencies, reducing the
MOSFET gate drive and switching losses. In discontin-
uous mode, under most circumstances, the on-time will
be a fixed minimum of 400ns.
The MAX1775 features four separate current-limit
threshold detectors and a watchdog timer for each of
its step-down converters. In addition to the more com-
mon peak current detector and zero crossing detector,
each converter also provides a valley current detector
(I
VALLEY
) and a minimum current detector (I
MIN
). I
VALLEY
is used to force the inductor current to drop to a lower
level after hitting peak current before allowing the P-
channel MOSFET to turn on. This is a safeguard against
inductor current significantly overshooting above the
peak current when the inductor discharges too slowly
when V
OUT
/L is small. I
MIN
is useful in ensuring that a
minimum current is built up in the inductor before turn-
ing off the P-channel MOSFET. This helps the inductor
to charge the output near dropout when dI/dt is small
(because (V
IN
- V
OUT
) / L is small) to avoid multiple
PSW
NON
PON
V
O
NSW
NONOVERLAP
PROTECTION
Q
S
R
S
R
Q
TONMIN
TOFFMIN
V
VALLEY
V
CLM
V
ZERO
FB
V
REF
V
MIN
CS+
CS-
V
IN
PON
Figure 2. Simplified Control System Block Diagram
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1775EEE | 32-Bit Digital Signal Controller with ROM 100-LQFP -40 to 125 |
| MAX1776 | 32-Bit Digital Signal Controller with ROM 100-BGA MICROSTAR -40 to 85 |
| MAX1776EUA | 24V, 600mA Internal Switch, 100% Duty Cycle, Step-Down Converter |
| MAX1777EEI | 32-Bit Digital Signal Controller with ROM 100-BGA MICROSTAR -40 to 125 |
| MAX1777 | High-Efficiency, Quad Output, Main Power- Supply Controllers for Notebook Computers |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX1775EEE | 功能描述:直流/直流開關轉換器 Dual-Out Step-Down for PDA/Palmtop RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1775EEE+ | 功能描述:直流/直流開關轉換器 Dual-Out Step-Down for PDA/Palmtop RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1775EEE+T | 功能描述:直流/直流開關轉換器 Dual-Out Step-Down for PDA/Palmtop RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1775EEE-T | 功能描述:直流/直流開關轉換器 Dual-Out Step-Down for PDA/Palmtop RoHS:否 制造商:STMicroelectronics 最大輸入電壓:4.5 V 開關頻率:1.5 MHz 輸出電壓:4.6 V 輸出電流:250 mA 輸出端數量:2 最大工作溫度:+ 85 C 安裝風格:SMD/SMT |
| MAX1775EEE-TG069 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。