- 您現在的位置：買賣IC網 > Datasheet目錄42 > MAX14544ETA+T (Maxim Integrated)IC ACCY SWITCH OVP PROTECT 8TDFN Datasheet資料下載
參數資料
| 型號： | MAX14544ETA+T |
| 廠商： | Maxim Integrated |
| 文件頁數： | 9/10頁 |
| 文件大?。?/td> | 1137K |
| 描述： | IC ACCY SWITCH OVP PROTECT 8TDFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 2,500 |
| 功能： | 電流開關 |
| 輸入電壓： | 2.3 V ~ 5.5 V |
| 電流 - 輸出： | 可調 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-WFDFN 裸露焊盤 |
| 供應商設備封裝： | 8-TDFN-EP（2x2） |
| 包裝： | 帶卷 (TR) |
28V-Capable, I
LIM
V
BUS
Accessory Switch
9
fault-blanking timeout, FLAG asserts low. FLAG is not
asserted when load-transient fault is less than t
BLANK
.
The fault blanking time only applies to forward current-
limit faults.
A reverse current-limit fault, thermal fault, or OVP fault
causes FLAG to assert immediately and does not wait
for the blanking time.
Thermal Shutdown
The MAX14544/MAX14545 have a thermal-shutdown
feature to protect the devices from overheating. The
device turns off and FLAG goes low immediately (no
fault blanking) when the junction temperature exceeds
+150NC. The MAX14544/MAX14545 turns back on when
the device temperature drops approximately 15NC.
OVLO and UVLO
The MAX14544/MAX14545 feature an overvoltage pro-
tection. When IN goes above V
OVLO
(6.0V max), the
switch turns off and FLAG goes low immediately with
no fault-blanking time. When IN drops below V
UVLO
(1.8V min), the switch turns off but FLAG stays high. The
MAX14544/MAX14545 turns back on when IN is in the
operating range.
Applications Information
Input Capacitor
To limit the input-voltage drop during momentary output
short-circuit conditions, connect a capacitor from IN to
GND. A 10FF ceramic capacitor is adequate for most
applications; however, higher capacitor values further
reduce the voltage drop at the input and are recom-
mended for lower voltage applications.
Output Capacitor
Connect a 1FF ceramic capacitor from OUT to GND.
This capacitor helps prevent inductive parasitics from
pulling OUT negative during turn-off, thus preventing
the MAX14544/MAX14545 from tripping erroneously. If
the load capacitance is too large, then current may not
have enough time to charge the capacitance and the
device assumes that there is faulty load condition. The
maximum capacitive load value that can be driven from
OUT is obtained by the following formula:
?/DIV>
<
FWD_MIN BLANK_MIN
MAX
IN
I
t
C
V
Layout and Thermal Dissipation
To optimize the switch response time to output short-
circuit conditions, it is very important to keep all traces
as short as possible to reduce the effect of undesirable
parasitic inductance. Place input and output capacitors
as close as possible to the device. IN and OUT must be
connected with short traces to the power bus.
During normal operation, the power dissipation is small
and the package temperature change is minimal. If the
output is continuously shorted to ground at the maximum
supply voltage, the operation of the switches with the
autoretry option does not cause problems because the
total power dissipated during the short is scaled by the
duty cycle:
IN_MAX OUT_MAX BLANK
MAX
RETRY
BLANK
V
I
t
P
51.6mW
t
t
?/DIV>
?/DIV>
=
=
+
where V
IN_MAX
= 5.5V, I
OUT_MAX
= 600mA, t
BLANK
=
10.5ms, and t
RETRY
= 661.5ms.
Attention must be given to the MAX14545 where the
latchoff condition can be manually reset by toggling EN
from high to low. If the latchoff time duration is not suf-
ficiently high, it is possible for the device to reach the
thermal-shutdown threshold and never be able to turn
the device on until it cools down.
相關PDF資料 |
PDF描述 |
|---|---|
| MAX1617AMEE+T | IC REMOTE/LOCAL TEMP SNSR 16QSOP |
| MAX1617MEE+T | IC REMOTE/LOCAL TEMP SNSR 16QSOP |
| MAX1619MEE+ | IC TEMP SENSOR W/ALARM 16-QSOP |
| MAX1765EUE+ | IC REG DL BST/LINEAR 16TSSOP |
| MAX1989MUE+ | IC TEMP SENSOR REMOTE 16TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MAX14544EVKIT+ | 功能描述:模擬開關 IC 28V-Capable ILIM VBUS Accessory Switch RoHS:否 制造商:Texas Instruments 開關數量:2 開關配置:SPDT 開啟電阻（最大值）:0.1 Ohms 切換電壓（最大）: 開啟時間（最大值）: 關閉時間（最大值）: 工作電源電壓:2.7 V to 4.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:DSBGA-16 |
| MAX14545ETA+T | 制造商:Maxim Integrated Products 功能描述:28V-CAPABLE ILIM VBUS ACCESSORY SWITCH - Tape and Reel |
| MAX14547AEUT+ | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX14547AEUT+T | 制造商:Rochester Electronics LLC 功能描述: 制造商:Maxim Integrated Products 功能描述: |
| MAX14548AEEWL+T | 制造商:Maxim Integrated Products 功能描述:100MBPS, 16-CHANNEL LLTS - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。